Mussoorie Dehradun Development Authority Tender
... More
The MDDA has issued a formal invitation for competitive bids for the Mussoorie Dehradun Development Authority project, for Construction Of Additional Office Floor And Other Works At Mdda Office Dehradun in Dehradun, Uttarakhand, with an estimated contract value of Rs. 2,22,62,000. The bid opening date for this tender is 19-05-2025 and the last date for bid submission is 24-05-2025. Interested bidders for Mussoorie Dehradun Development Authority tender can download the important documents here to check the scope of work, eligibility criteria and technical requirements.
Mussoorie Dehradun Development Authority - MDDA Tender
Civil And Construction
Building Construction
Eprocure
Opening Date19 May 2025
Closing Date24 May 2025
Tender Amount₹ 2,22,62,000
Technical
Technical
Financial
Additional Eligibility
Bid Capacity
... View More
The formula for bid capacity is: Assessed Available Bid capacity = ( A*N*M - B )
Technical Capacity
... View More
The required prior work experience for the bidder includes: - Civil engineer: 8 years in execution of civil construction work
- Junior engineer: 5 years in execution of civil works/steel structure works
- Civil supervisor: 5 years in civil construction
- Junior engineer electrical: 5 years in electrical works
- Electrician: 3 years in electrical works The bidder should have completed at least one similar work costing not less than 80% of the project cost. The similar work should be comprehensive civil construction/renovation work with fabrication of steel structure in roof truss, etc. Additionally, the bidder should have:
- General Construction Experience: Experience under construction contracts in the role of Prime contractor, for at least the last 5 years prior to the bid submission deadline.
- Specific Construction Experience: - Three similar works each costing not less than 40% of the Project Cost. - Two similar works each costing not less than 50% of the Project Cost. - One similar work costing not less than 80% of the Project Cost. The bidder must provide information on contracts of similar size and nature, including the contract number, award date, completion date, role in the contract, total contract amount, and percentage of total amount if the bidder was a partner in a joint venture (JV) or subcontractor. The total contract amount for similar contracts is to be specified in INR. The percentage of similar works completed is also required, with specific percentages mentioned as 40%, 50%, and 80% of the Project Cost for different similar works. The bidder's prior work experience is related to the "Assessed Available Bid capacity" calculation, which involves the maximum value of civil engineering works executed in any one year during the last five years, updated to the price level of the last year at a rate of 10 percent a year. No specific amount is mentioned for the project cost, but the bidder should have completed works with a value that allows them to meet the minimum qualification criteria.
Costs
EMD
₹ 4,45,500Document Cost
₹ 5,900Tender Fee
Refer Documents
Summary
Construction Of Additional Office Floor And Other Works At Mdda Office Dehradun
Description
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user
Contact
Tender Id
2025_MDDA_84041_1Bid Award Id
ViewTender No
26/Development Work/25-26 dt 08/04/25Tender Authority
Mussoorie Dehradun Development Authority ViewPurchaser Address
-Website
http://uktenders.gov.in
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost
Documents
BOQ Items
... More
Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.
1226
625
767439.2200000001
... More
Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete : Ridges plain (500 - 600mm)
79
451
35640.06
... More
Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete : Gutter (600 mm over all girth)
120
1113
133597.19999999998
... More
Providing and fixing on wall face unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A, including jointing with seal ring conforming to IS : 5382, leaving 10 mm gap for thermal expansion, (i) Single socketed pipes. 150 mm diameter
274.4
927
254396.24
... More
Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1 :4:8 (1 Cement : 4 coarse sand (zone-Ill) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources)
15.44
5772
89133.2672
... More
Providing and laying factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50 mm thick compacted bed of sand, compacting and proper embedding/laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of Engineer-in-Charge. 80 mm thick C.C. paver block of M-35 grade with approved colour design and pattern.
92.64
925
85692
... More
Providing and fixing tiled false ceiling of specified materials of size 595x595 mm in true horizontal level, suspended on inter locking metal grid of hot dipped galvanized steel sections ( galvanized @ 120 grams/ sqm, both side inclusive) consisting of main "T" runner with suitably spaced joints to get required length and of size 24x38 mm made from 0.30 mm thick (minimum) sheet, spaced at 1200 mm center to center and cross "T" of size 24x25 mm made of 0.30 mm thick (minimum) sheet, 1200 mm long spaced between main "T" at 600 mm center to center to form a grid of 1200x600 mm and secondary cross "T" of length 600 mm and size 24x25 mm made of 0.30 mm thick (minimum) sheet to be interlocked at middle of the 1200x600 mm panel to form grids of 600x600 mm and wall angle of size 24x24x0.3 mm and laying false ceiling tiles of approved texture in the grid including, required cutting/making, opening for services like diffusers, grills, light fittings, fixtures, smoke detectors etc. Main "T" runners to be suspended from ceiling using GI slotted cleats of size 27 x 37 x 25 x1 .6 mm fixed to ceiling with 12.5 mm dia and 50 mm long dash fasteners, 4 mm GI adjustable rods with galvanised butterfly level clips of size 85 x 30 x 0.8 mm spaced at 1200 mm center to center along main T, bottom exposed width of 24 mm of all T-sections shall be pre-painted with polyester paint, all complete for all heights as per specifications, drawings and as directed by Engineer-in-charge.GI Metal Ceiling Lay in perforated Tegular edge global white color tiles of size 595x595 mm and 0.5 mm thick with 8 mm drop; made of GI sheet having galvanizing of 100 gms/sqm (both sides inclusive) and 20% perforation area with 1.8 mm dia holes and having NRC (Noise Reduction Coefficient ) of 0.5, electro statically polyester powder coated of thickness 60 microns (minimum), including factory painted after bending and perforation and backed with a black Glass fiber acoustical fleece.
502.4
1753
880797.632
... More
Providing and fixing UPVC partitions Pannel with Board with extruded built up standard tubular section/ appropriate sections and other sections of approved make conforming to fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top bottom and sides with requied rubber/neoprene gasket etc. Sections shall be smooth,rust free,straight,mitred and jointed mechanically wherever required including cleat angle, stainless screws, all complete as per architectural drawing and the directions of Engineer-in-charge.
787.52
10000
7875200
... More
Providing and fixing thermal insulation of ceiling (under deck insulation) with Resin Bonded Rockwool conforming to IS: 8183,density 48 kg/ m3, 50 mm thick, wrapped in 200 G Virgin Polythene bags fixed to ceiling with metallic cleats (50x50x3 mm) @ 60 cm and wire mesh of 12.5 mm x 24 gauge wire mesh, for top most ceiling of building.
914
595
544570.34
... More
Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS: 15622, of approved make, in all colours and shades, laid on 20 mm thick cement mortar 1 :4 (1 cement: 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqm including grouting the joints with white cement and matching pigments etc., complete. Size of Tile 600x600 mm
509
1316
670088.3200000001
... More
Providing and fixing V.R.V. System With Commissianing all complete as per architectural drawing and the directions of Engineer-in-charge. ( L.G. and Daikin make)
1
3008574
3008574.07
... More
Providing and fixing Fire Fighting System, Fire Extinguishers and Fire alarm System With Commissianing all complete as per architectural drawing and the directions of Engineer-in-charge.
1
1983140
1983140
... More
Providing and fixing Elecrical Work all complete as per architectural drawing and the directions of Engineer-in-charge.
1
3167234
3167234.75
Evaluation Notes How It Works ?
Potential Partner
Select Your Requirements