Indian Institute Of Petroleum Tender

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size in the existing pipe etc. as required.

Above 185 sq. mm and upto 400 sq. mm

Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheathed / XLPE aluminium conductor cable of 1.1 KV grade as required

3½ X 240 sq. mm (62mm)

Providing and laying position cement concrete 1 : 2 :4 (1 cement : 2 Courase sand: 4 graded stone aggregte 20 mm nominal size) in foundation of pump, DG set, panels etc. Including form work etc. As required.

Providing, laying and fixing following dia G.I. pipe (medium class) in ground complete with G.I. fittings including trenching (75 cm deep)and re-filling etc as required

150 mm dia

Excavation for cable trenches in soft soil depth upto 1.2 m including dressing of sides lift upto 1.5 m, including getting out the excavated soi, refilling with sand or good soil after laying of cable/pipe etc. in layers of 20 cm, ramming watreing and disposal of surplus excavated soil as directed, witinh a lead of 50 meters.

Supplying and laying of following size ISI marked PVC insulated and PVC sheathed/XLPE /FRLS (Flame proof, water proof) aluminium conductor steel armoured cable of 1.1KV grade as required.

3.5 X 400 sqmm

Supplying & febrication,installation,testing and commissioning of 4 poles,LT Outdoor panel with double wall housing with spacing about 6 inchs with each other (Duble wall cubical panel for environmental protection) made of 2 mm thick CRCA-MS sheet suitable housing ( 1050 MM X 550 MM) of 500 mm deep with mounting arrangement, 1000 A 4 STRIP Aluminioum busbar duly sleeved making suitable hole for cable entries detachble gland plates at bottom painting with supierior quaility . bus bar with heat shirnk sleeves etc, dust and vermin proof IP 65 standred having the switch gears and metering facility compelete with connections & inter connections painting etc.as required. (Every seperate feeder name plate fabrication and installation work and about 4 feet to 5 feet height solid high quality angle iron stand is also included in this Item). The panel must be factory fabricated.The drawing of the panel fabricated and after fabrication the same will be inspected and aproved by Engineer-in-charge before its dispatch from factory to site.