Haridwar Roorkee Development Authority Tender

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required complete etc. as per direction of Engineer- in-charge (length of finished kerb edging shall be measured to calculate volume for payment). (Precast C.C. kerb stone shall be approved by Engineer-in-charge).

Providing and Laying of Interlocking Concrete Blcok (M-35) Pavements having thickness 60 mm as per drawing and Technical Specification Clause 1504

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level: 1:2:4 (1 cement: 2coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 20 mm nominal size derived from natural sources)

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth leve 1:1.5:3 (1 cement: 1.5 coarse sand (zone-III) derived from natural sources: 3 graded stone aggregate 20 mm nominal size derived from natural sources)

Centering and shuttering including strutting, propping etc, and removal of form for 5.9.1 Foundations, footings, bases of columns, etc. for mass concrete

Surface dressing of the ground including removing vegetation and inequalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level. 5.22.1 Mild steel and Medium Tensile steel bars kg 107.10

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:4 (1 cement: 4 coarse sand) cum

CEMENT PLASTER (IN FINE SAND) 12 mm cement plaster of mix : 1:4 (1 cement: 4 fine sand

Finishing walls with water proofing cement paint of required shade : 13.44.1 New work (Two or more coats applied @ 3.84 kg/10 sqm)

Finishing walls with Acrylic Smooth exterior paint of required shade : 13.46.1 New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm)

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture

GATE CHARGES AS/DESIGN AND FUNCTION

Random rubble masonry 12-4-3 Cement mortar 1:6 (1 cement : 6 coarse sand)

RAILING OF 750MM HIGH ABOVE PARAPET OF 600 MM OF 40X30X5 SIZE OF HOLLOW M.S PIPE JOINTARY OF WHICH IS DONE BY SMAW WELDING ACCORDING TO THE ARCHITECTURAL DESIGN AND DRAWING. BASE AVERAGE OF RAILING /RUNNING METER COST IS ACCORDING TO 10.50 KG PER RUNNING METER.

TOILET FIXTURE AND FITTING 3 MEN 5 WOMEN OF DRAINAGE AND WATER SUPPLY P.V.C PIPE FITTING FINISHING WORK OF 1. VETIFIED TILES (600X600)OF AREA 223.04 SQMT FIXING WITH MODERATE 2. C.P FITTINGS AND FIXTURES OF BASE MODEL ESSCO BY JAQUAR CONTAINING 8 WALL HUNG SEATS ,3 URNALS,4 WASH BASIN,8 HAND FOCETS,24 ANGLE WALLS,4 BOTTEL TRAPS,WALL MIXTURE AND OTHER REQUIRED SMALL CAP FITTINGS. 17.4 Providing and fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350 mm and 340x410x265 mm sizes respectively with automatic flushing cistern with standard flush pipe and C.P. brass spreaders with brass unions and G.I clamps complete, including painting of fittings and brackets, cutting and making good the walls and floors wherever required : 17.4.1 One urinal basin with 5 litre white P.V.C. automatic flushing cistern each 6258.75. 17.16A Providing and fixing 8 mm dia C.P. / S.S. Jet with flexible tube upto 1 metre long with S.S. triangular plate to Eureopean type W.C. of quality and make as approved by Engineer - in - charge. each 349.15 17.2 Providing and fixing white vitreous china pedestal type water closet (European type W.C. pan) with seat and lid, 10 litre low level white P.V.C. flushing cistern, including flush pipe, with manually controlled device (handle lever), conforming to IS : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required : 17.2.1 W.C. pan with ISI marked white solid plastic seat and lid each 6515.55 17.28 Providing and fixing P.V.C. waste pipe for sink or wash basin including 17.28.1 P.V.C. waste fittings complete. Semi rigid pipe 32 mm dia each 103.90 17.34 Providing and fixing toilet paper holder : C.P. brass each 803.70

GAZEBO AREA FRAME WORK OF M.S HOLLO PIPES OF REQUIRED SECTION AS PER ARCHITECTURAL DRAWING OF CARPET AREA APPROX 24.12 SQMT INCLUDES SITTINGS OF WOODEN PLANKS,FLOORING OF ANTI SKID TILES OF 600 X 600 SIZE APPROX ESTHETIC LIGHTS AND OTHER MENTION IN 1.2

PROVIDING OF FRP (FIBER REINFORCEMENT PLASTIC) MAKE MUDRA 3D HANDS SCULPTURE FINISH WORK WITH MS STRUCTURE AS PER ARCHITECT DESIGN, SIZE AND LOCATION APPROVED BY CLINT WITH COST OF INCLUDING MAKING, CLAY WORK, MOULDING, CASTING, 8 MM FRP SURFACE FINISH WORK WITH NC COLOUR FINISH ON THE SURFACE FOR OUTDOOR / INDOOR, TRANSPORT, HANDLING AND INSTALLATION & ANY CHARGES FOR STRUCTURAL CONSULTANTS FOR M.S. FRAME OF SCULPUTRE TO BE CONSIDERED IN GIVEN QUOTE Supply installaton testing and commissioning Luminaries system : - 50 Nos. LED LIGHTS , ( Wipro , phillips / equivalent )

Supply installaton testing and commissioning of foaming jet fountain with ball joint with fittings and mounting stands are made from galvanised steel . High quality rubber gaskets , nuts & bolts and foundation bolts along with control valves to adjust flow pressure & all fittings should be in Brass from a standard manufacturer with ISI Marking. Supply installaton testing and commissioning of Pump set & eletric panel comprise of 01 no x 10 hp ( kirloskar/ crompton /equiv make ) pump suction covered with large area mesh filter , filter body made from galvanised steel , filter mesh made from stainless steel , three phase , 380-440v AC , 50 cycles supply with foundation bolts and 3 core flat PVC flexible copper conductor doble isulated submersible cable with copper conductors not less than 1.5 sqmm. Electric panel comprises of steel sheet paint finish enclosure with hinged front door, back - wall mounting type with provision for incomig & outgoing cable entry Supply installaton testing and commissioning Luminaries system : - 14 Nos. LED LIGHTS ,( Wipro , phillips / equivalent ) WATER FALL FOUNTAIN IN THE PARK (Water body and fountain design approved by the project Architect) Supply installaton testing and commissioning Luminaries system : - 50 Nos. LED LIGHTS , ( Wipro , phillips / equivalent )

Preparation of beds for hedging and shrubbery by excavating 60 cm deep and trenching the excavated base to a further depth of 30 cm, refilling the excavated earth after breaking clods and mixing with sludge or manure in the ratio of 8:1 (8 parts of stacked volume of earth after reduction by 20% : one part of stacked volume of sludge or manure after reduction by 8%), flooding with water, filling with earth if necessary, watering and finally fine dressing, leveling etc. including stacking and disposal of materials declared unserviceable and surplus earth by spreading and leveling as directed, within a lead of 50 m, lift up to 1.5 m complete (cost of sludge, manure or extra earth to be paid for separately)

Uprooting rank vegetation and weeds by digging the area to a depth of 60 cm, removing all weeds and other growth with roots by forking repeatedly, breaking clods, rough dressing, flooding with water, uprooting fresh growths after 10 to 15 days and then fine dressing for planting new grass, including disposal of all rubbish with all leads and lifts.

Supply, Spreading & mixing of vermi compost @ 3kg/Sqm Only Lawn Area & bed area

Supplying and spreading of sand in Lawn area, including watering, mixing and dressing complete.

Providing & laying Selection no. 1 grass turf with earth 50mm to 60mm thickness of existing ground prepared with proper level and ramming with required tools wooden and than rolling the surface with light roller make the surface smoothen and light watering the same maintenance for 30 days or more till the grass establish properly,as per direction of officer in charge

Anti termite treatment of lawn area through premise 30.50% I P. one liter premise diluted in 499 liters water and applying solution @ 1.00 litre solution per sqm lawn or bed area.(two application) i/c cost of chemical)and as per direction of officer-in-charge.and as per direction of officer-in-charge.

Digging holes in ordinary soil and refilling the same with the excavated earth mixed with manure or sludge in the ratio of 2:1 by volume (2 parts of stacked volume of earth after reduction by 20% : 1 part of stacked volume of manure after reduction by 8%) flooding with water, dressing including removal of rubbish and surplus earth, if any, with all leads and lifts (cost of manure, sludge or extra good earth if needed to be paid for separately) Holes 90 cm dia, and 90 cm deep

Providing and Displaying Foxtail palm well developed with fresh & healthy foliage of ht. 150 to 180 cm having bottom girth of in big Cement Pot as per direction of the officer-in-charge.

Providing and stacking of Ficus Long island topiary of height 360-390 cm. in big Cement Pot as per direction of the officer-in-charge.

Providing and stacking of Ficus Microcarpa topiary of height 240-270 cm. in big Cement Pot as per direction of the officer-in-charge.

Providing and stacking of Maulsari Tree of height 210-240 cm. in big Cement Pot as per direction of the officer-in-charge.

Providing and stacking of Largerstroemia sp. (savni) of height 105-120 cm. in big Cement Pot as per direction of the officer-in-charge.

Providing and stacking of Seaforthia palm of height 105-120 cm. in big officer-in-charge.

Providing and stacking of Buxus (box wood) of height 45-60 cm. with 2-3 branches in earthen pots of size 20 cm as per direction of the officer-in-charge.

Providing and stacking of Hamelia patens of height 60-75 cm. with 6-8 branches in poly bags of size 25 cm as per direction of the officer-in-charge.

Providing and stacking of Hibiscus rosasinensis of height 60-75 cm. with 5-6 branches in p.bag of size 25 cm as per direction of the officer-in-charge.

Providing and stacking of Iresine herbstii, of height 25-30 cm., full of branches well developed in 15 cm size of Earthen Pot/Plastic Pot & as per direction of the officer-in-charge.

Providing and stacking of pedilanthus hybrid variety, of height 25-30 cm., full of branches well developed in 15 cm size of Earthen Pot/Plastic Pot & as per direction of the officer-in-charge.

Providing and stacking of various varieties of seasonal flowering plants healthy and fresh foilage in p.bag of size 25 cm as per direction of the officer-in-charge

Plantation of Trees, Shrubs, and Hedge at site i/c watering and removal of unsaverieable material’s as per direction of officer in charge (excluding cost of plant & water) Cost of plantation per Tree

Plantation of Trees, Shrubs, and Hedge at site i/c watering and removal of unsaverieable material’s as per direction of officer in charge (excluding cost of plant & water) Cost of plantation per Shrub

Plantation of Trees, Shrubs, and Hedge at site i/c watering and removal of unsaverieable material’s as per direction of officer in charge (excluding cost of plant & water) Cost of plantation per Hedge/Ground cover