Bridge Ropeway Tunnel And Other Infrastructure Development Corporation Of Uttarakhand Limited Tender

Supplying, installation, testing & commissioning of 13 Passenger (884 KG) MRL lift having contract speed of 1 MPS in the existing lift shaft as per detailed specifications enclosed and as under (i) Speed : 1 MPS (ii)   Floors : 5 (G+4) (iii)  Travel : 12.6 mtrs (approx.) (iv)  Stops & opening : 5 / 5 (v)  Controller: A.C. variable voltage & variable frequency (vi) Operation : Microprocessor based simplex selective collective with / without atten­dant (vii)   Power - 415 V, 3 phase, 50 Hz, 4 wires system (viii)   Type of doors (a)   Car Doors: AutomaticPower operated, center opening horizontal sliding stainless steel frame with Toughened Glass doors (b)  Landing Doors: AutomaticPower operated, center opening hori­zontal sliding stainless steel frame with Toughened Glass doors. (ix) Car body will be of scratch proof SS finish. (x) Emergency light in the lift car. (xi) Full height Infra Red protection is to be provided for landing/ car doors. (xii) Provision of Toe guards, Fireman's switch etc. Automatic rescue device complete with with Battery of adequate capacity so as to operate ARD atleast seven time a day provided the duration between usege is atleast 30 Minutes. A Stainless steel hand rail not less than 600 mm long at 900 mm above floor level to be fixed on both the side panels and rear panel in the lift car. Button in car operating panel & landing operating panel shall be having Braille Inscription & shall be fixed for the handicaped. Voice announcement system in the car to announce the position of the elevator in the hoistway as the car passes or stops at a floor served by the elevator. Flooring:-chequered aluminium sheet. Lift installation shall include all safety & control features as specified in the specifications. The features required for use of the lift by handicapped persons eg hand rail, braile signage closing speed of doors etc

Supplying, installation, testing & commissioning of 13 Passenger (884 KG) MRL lift having contract speed of 1 MPS in the existing lift shaft as per detailed specifications enclosed and as under (i) Speed : 1 MPS (ii)   Floors : 4 (G+3) (iii)  Travel : 12.6 mtrs (approx.) (iv)  Stops & opening : 4 / 4 (v)  Controller: A.C. variable voltage & variable frequency (vi) Operation : Microprocessor based simplex selective collective with / without atten­dant (vii)   Power - 415 V, 3 phase, 50 Hz, 4 wires system (viii)   Type of doors (a)   Car Doors: AutomaticPower operated, center opening horizontal sliding stainless steel frame with Toughened Glass doors (b)  Landing Doors: AutomaticPower operated, center opening hori­zontal sliding stainless steel frame with Toughened Glass doors. (ix) Car body will be of scratch proof SS finish. (x) Emergency light in the lift car. (xi) Full height Infra Red protection is to be provided for landing/ car doors. (xii) Provision of Toe guards, Fireman's switch etc. Automatic rescue device complete with with Battery of adequate capacity so as to operate ARD atleast seven time a day provided the duration between usege is atleast 30 Minutes. A Stainless steel hand rail not less than 600 mm long at 900 mm above floor level to be fixed on both the side panels and rear panel in the lift car. Button in car operating panel & landing operating panel shall be having Braille Inscription & shall be fixed for the handicaped. Voice announcement system in the car to announce the position of the elevator in the hoistway as the car passes or stops at a floor served by the elevator. Flooring:-chequered aluminium sheet. Lift installation shall include all safety & control features as specified in the specifications. The features required for use of the lift by handicapped persons eg hand rail, braile signage closing speed of doors etc

Supplying, installation, testing & commissioning of 13 Passenger (884 KG) MRL lift having contract speed of 1 MPS in the existing lift shaft as per detailed specifications enclosed and as under (i) Speed : 1 MPS , (ii)   Floors : 3 (G+2) (iii)  Travel : 4.2 mtrs (approx.) (iv)  Stops & opening : 3 / 3 (v)  Controller: A.C. variable voltage & variable frequency (vi) Operation : Microprocessor based simplex selective collective with / without atten­dant (vii)   Power - 415 V, 3 phase, 50 Hz, 4 wires system (viii)   Type of doors (a)   Car Doors: AutomaticPower operated, center opening horizontal sliding stainless steel frame with Toughened Glass doors (b)  Landing Doors: AutomaticPower operated, center opening hori­zontal sliding stainless steel frame with Toughened Glass doors. (ix) Car body will be of scratch proof SS finish. (x) Emergency light in the lift car. (xi) Full height Infra Red protection is to be provided for landing/ car doors. (xii) Provision of Toe guards, Fireman's switch etc. Automatic rescue device complete with with Battery of adequate capacity so as to operate ARD atleast seven time a day provided the duration between usege is atleast 30 Minutes. A Stainless steel hand rail not less than 600 mm long at 900 mm above floor level to be fixed on both the side panels and rear panel in the lift car. Button in car operating panel & landing operating panel shall be having Braille Inscription & shall be fixed for the handicaped. Voice announcement system in the car to announce the position of the elevator in the hoistway as the car passes or stops at a floor served by the elevator. Flooring:-chequered aluminium sheet. Lift installation shall include all safety & control features as specified in the specifications. The features required for use of the lift by handicapped persons e.g. hand rail, braile signage closing speed of doors etc