Vocational Education And Skill Development Department Tender

CATEGORY: operated with interchangeable nozzles , Air ratchet with standard accessories , Air impact wrench with standard accessories , Battery charger Capable to charge batteries from 5AH-150AH , Circlip pliers Expanding and contracting 15cm and 20cm , Cylinder bore gauge capacity 20 to 160 mm , Depth micrometer 0-25mm , Different type of Engine Bearing model 10 Different types on board , Different type of piston model 5 Different Typeson board , Electric Soldering Iron 230 V 60 watts 230 V 25 watts , Hand vice Up to 37 mm , Multimeter digital LCD Display , Oil can 0.5-0.25 liter capacity , Outside micrometer 0 to 25 mm , Outside Micrometer 25 to 50 mm , Outside micrometer 50 to 75 mm , Outside micrometer 75 to 100 mm , Piston ring compressor , Piston Ring expander and remover. , Pliers flat nose 15 cm , Pliers round nose 15 cm , Pliers side cutting 15 cm , Set of stock and dies-Metric , Sheet Metal Gauge , Steel measuring tape in a case 10 meter , Steel rule 15 cm inch and metric , Tandem master cylinder with booster , Torque wrenches 5-35 Nm, 12-68 Nm and 50- 225 Nm , Tyre pressure gauge with holding nipple , Automotive Water pump for dismantling and assembling , Chain Pulley Block-3 ton capacity with tripod stand 3 ton capacity with tripod Stand , Cut section models of shock absorbers , Cut section of cross ply and radial tyres , Cut section working model of Single plate clutch assembly Single plate Clutch sectioned to show the internal details , Front axle Rzeeppa Joint with stand for Dismantling and assembly Rzeppa joint of LMV , Steel rule 30 cm graduated both in English and metric units , Inside spring caliper 150mm , Hermaphrodite caliper 150mm , Divider spring 150 mm , Centre Punch 100 mm , Hammer B.P. 0.5 kg , File flat bastard 300 mm , File flat 2nd cut 250 mm , File flat smooth 200 mm , Screw Driver 10 X 200 mm , Combination Plier 150 mm , Safety glasses , Surface plate 400 mm x 400mm grade , Scribing block universal 300 mm , Try square 300 mm , Outside spring caliper 200 mm , Hammer B.P. 800 gms with handle , Angle plate adjustable 250 x 150 x 175 mm , Punch letter set. 3 mm , Punch number set 3 mm , Clamps C 100 mm , Clamps C 200 mm , Tap and Die set in box metric pitch 6 mm to 12 mm , File Half round 2nd cut 250 mm , File triangular smooth 200 mm , Tool bits holder Armstrong L.H , Tool bits holder Armstrong R.H. , Table chuck 75 mm jaw swivel base , Machine Vice Swivel Base -150 mm , Hand vice 50 mm jaw , Radius turning attachment , Angle turning attachment , Compound angle vice standard sine , Universal Machine Vice 100 mm , Base chuck for slotter to suit the machine , Shaper indexing center to suit the machine , Chair for Instructor , Table for Instructor