Uttar Pradesh Cooperative Processing And Cold Storages Federation Limited Tender

12 mm thick plaster in 1:4 cement, Coarse sand including raking & washing the surface of brick work and then plastering including supply of all material, labour, T&P etc. required for proper completion of work as per PWD. S.I. No. 584(a).

Cement Concrete with 2 cm. gauge S/grit, C/ Sand of 2.20 F.M. & cement in proportion 4:2:1 including supply of all material, labour,T&P etc. required for proper completion of work as per PWD S.I. No. 279 (a) .

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thikness as per design, over a prepared sub base with 43 grade cement or any other type as per clause 1501.2.2 (1:1.5:3) coarse and fine aggregates confirming to IS 383 maximum size of coarse aggregate not exceeding 25mm, mixed in a concrete mixer of not less then 0.2 cum capacity and appropriate weight batcher using approved mix design, laid in approved fixed side form work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per shovels. rakes, compacted using needle, screed and plate vibrators and finished in continuous operetion including provision of contraction and expansion, construction joints as per norms, applying debonding strips primer, sealant, dowel bars, near approaches to bridge/ culvert and construction, joints, admixtures as approved, curing of concrete salabs for 14-days, curing compound (Where specified) and water finishing to lines and grade as per drawing and Technical Specification clause 1501 including cost of polythene sheet and dowel bar and also including complete shifting of matrials & concrete etc. (S.I.NO. 20.18 New item-a)

R.C.C. work in 1:1.5:3 cement, c/sand & 20mm gauge stone grit in slabs including necessary centering and shuttering etc. including supply of all material,labour, T&P etc. required for proper completion of work as per PWD s.i.no. 284.

M.S (tor steel or plain) in plain work such as R.C.C. work including cutting & bending to proper shape complete including supply of all material, labour, T&P etc. required for proper completion of work as per PWD s.i.no. 504

Supply and fixing of M.S. sign board of prescribed size 1.20m*2.75m with angle 40*40*6mm iron angle and imm thick ms iron sheet including painting and letter writing complete.

Providing 2 stage photographs at starting, & end Time of work.