UP Cooperative Federation Limited Tender

SITC of Backward Curved Centifugal Fan with Cabinet (Make:Nicotra Gebhardt/Kruger/Sys) DIDW Backward curved Exhuast fan complete with TEFC moter, pulleys, V - Belt guards etc. Double Skin Backward curved non overloding type Centrifugal fan with Fire retardent & waterproof cabinet . 16000 CFM sgmm 50, (700 mm dia) 7.5 kw/4 pole (Fresh Air) Centrifugal Fan ( Fire Rated moter) ( H Class IE2 Motar)

SITC of JET FAN (Make:Nicotra Gebhardt/Kruger/Sys) AGM-02-0400-HC -300◦C-120MIN , 50HZ ,Non Reversible , Thrust - 75/18, RPM 2820/1405, Air Flow Rate - 10000/5000 m3/hr, 2/4 Pole

SITC CO Sensor Make: MSR Supply of CO Set and CO2 sensing system for automatic running and modulating ventilation and exhaust fan for pollution and fire mode as required.

SITC Cable Heavy duty 750 volt grade for Fans (Make: Havells/Polycab) 3Cx10.00 mm2 Copper Armoud For Centifugal Fan

3Cx6.0 mm2 Copper Armoud For Axial Fan

3Cx2.5 mm2 Copper Armoud For JET Fan

3Cx0.5 mm2 Copper Wire For Co Senser

3Cx150.00 mm2 Aluminnum Armoud For Panel Incomer

SITC M.S Conduit - 20mm ISI MARK For co censer 0.5 sqmm wiring 3 core

SITC Panel Logic Control with starter Supply of cubical type main MV panel board suitable for 3 phase, 415 volts, 50 Hz, and of 25 KA rupturing capacity at 415 volts, fabricated from minimum 2 mm thick and doors of 1.6 mm thick CRCA sheet powder coated through seven tank process facility for prickling and degreasing complete with suitable rating digital Amp meter with CTs, 0-500 Volt meter with selector switch, phase indication lamp with control MCB, suitable rating Al. Bus Bar, mountings, interconnections, earthing etc. as required. The electrical panel with feeders for suitable nos. of starters for 3 phase dual speed fans with suitable motor rating at high/low speed. PLC with necessary logic for CO detection and control of suitable Nos of Axial fans by sensor and shall be connected with each panel to provide input to panel for running the required number of fans in particular zone. Potential free contact shall be provided for BMS integration. CO Sensors shall be designed to detect CO gas in the air with sensing range between 0-250 PPM. i. 11 kw /4pole 02 No Fan ii. 7.5 kw/4pole 2 no Fan iii. 2.53kw2/4pole 07 no Fan iv. 3.7 kw /4pole 02 No Fan 800 Amps TP MCCB – Thermal Overload Relay, Electronic timer –,Single Phase Preventor – ON/OFF/TRIP Indication Lamps, Digital Ammeter & Voltmeter -1 No. each with ASS with suitable CTs of Class 1.0, VSS and MCBs of suitable rating, ON/OFF/RESET Push Buttons, Auto/Manual Selector Switch -

SITC of Aluminium Lovers for Floor Axial Fan

SITC of Aluminium Lovers for Floor Axial Fan BirdScreen

SITC G I Duct For All Fan Exhuast Air and Supply Fresh Air 22 Gauge

SITC MS Cable Trey 600 X 50 MM

Civil Tranch with ms jali work from Main Building to Pump House Room And Panel room (600x600)

TOTAL (Sr. No. 1 to 18)