Saharanpur Development Authority Tender

Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates using Bitumen V.G. 10 @ 1.46 Kg/sqm to required line, grade and level to serve as wearing course on a previously prepared base by manual MORD Specifications 508 and as per direction of Engg-in-Charge complete Including all taxes but excluding GST.

Providing and laying seal coat Type B Specification by manual means with Bitumen V.G. 10 @ 0.68 kg per sqm sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall as per Technical Specification Clause 510 and as per direction of Engg-in-Charge complete Including all taxes but excluding GST.

Construction of un-reinforced, without dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per disign, over a prepared sub base with 43 grade cement or any other type as per Clause 1501.2.2 (1:1½:3) coarse and fine aggregates confirming to IS 383 maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less then 0.2 cum capacity and appropriate weight batcher using approved mix design, laid in approved fixed side form work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels. rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints as per norms, applying debonding strips primer, sealant, dowel bars, near approaches to bridge/ culvert and construction, joints, admixtures as approved, curing of concrete slabs for 14-days, curing compound (Where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 including Cost of Polythene Sheet and Dowel bar and also including complete shifting of matrials & Concrete etc.(M-30)

Supply & laying of 80 mm thick Precast cement concerete I-Shape' Interlocking paver blocks ISI mark confirming to IS: 15658-2006 with top layer of minimum 5 mm thickness having plan dimension 200x(160+120mm) of O.P. Cement , smooth high gloss finish, skid resistant; manufactured from rubber moulds through vibro-compression mechanism. The compressive strength of concrete paver block shall not be less than 50Mpa and weight 5 kg per including cost of material, with a blanket layer of 4.00cm. thick fine sand. including labour, T & P etc required for proper completion of the work as directed by Engineer-in-charge complete Including all taxes but excluding GST.

Paintings or Varnishing on iron work or new wood work with one coat of ready mix priming paint and two coats of approved superior quailty ready mixed paint or clear synthetic varnish ( Berger, dulux,, Narolac, Shalimar) including supply of all materials, Labour,T&P etc. required for proper complete of the work. pain to be used should confirm to the ISI no. 1950 (PWD SI. No-641+642)