Rural Engineering Department Tender

Excavation in foundation in ordinary soil (Loam clay, or sand ) including lift upto 1.5 m & lift up to 30.0 Mtr & including filling,watering and ramming ofexcavated earth in to the trenches or in to the space between the building and the sides of foundataion trenches or in to the plinth and removal & disposal of surplus earth as directed by the Engineer- In-Charge up to a distance of 30.0 Mtr from the foundation trenches as per SI. N0. 251.

Concrete with 4 cm. gauge brick ballast, Fine sand of 1.25 F.M. and cement in proportion of 12:6:1 in foundation and under floors, including supply of all materials, labour and T&P etc. required for proper completion of the work.as per SI. N0. 273

First class brick work in 1:4 cement and coarse sand above 2.25 F.M. mortar in foundation and plinth including supply of all materials,labour and t&p etc required for proper completion of the work. as per SI. N0. 305. (B)

Providing and Laying 125 micron thin polythene to act as separation layer

Construction of Un Reinforced ,dowel jointed at expansion and constuction joint only , Plain Cement Concrete pavement , thickness as per design , over a prepared sub base , with 43 grade cement or any other type as per Clause 1501.2.2 (M-30 Grade) , coarse and fine aggregrates conforming to IS :383 , maximum size of coarse aggregrate not to exceed 25mm,mixed in a concrete mixer not less than 0.20cum capacity and appropriate wieght batcher using approved mix design ,laid in approved fixed side form work (steel channel , laying and fixing of 125 micron thick polythene film , wedges, steel plates including levelling the form work as per drawing ), spreading the concrete with shovels, rakes , compacted using needle,screed and plate vibrators and finishing in continous operation joints, applying debonding stripes, primer ,sealant dowel bars near approaches to bridge/culvert and construction joints , admixtures as approved curing of concrete slabs for 14 days curing compound (where specified) and water finishing to lines and grade as per drawing and technical specification MORD 1501 (excluding supply polythene and making of contraction Joint ) as per rate sanctioned by S.E. R.E.D Azamgarh

12 mm thick plaster over brick work with cement mortar consisting of one part cement & four parts of fine sand of 1.25 F.M. including supply of all material, labour and T&P etc required for proper completion of the work as per SI NO 584

Making contraction / construction joint with filling bitumin 40% , asbestas 5% and coarse sand including all for proper completion of the work

R.C.C work with cement Concrete1:2:4 (with 1 cement :2 coarse sand :4 graded 22.40 mm gauge approved stone grit ) including supply of all materials, labour and T&P etc. required for proper completion of the work. Including cost of the form work as per SI NO 283 A

Mild steel or iron work in plain work such as R.C.C. including cutting, bending and placing in position and also including its wastage etc for proper completion of work as per SI No 504