Rural Engineering Department Tender

Cement Concrete Pavement thickness as per design over a prepared sub base with 43 gauge cement or any other type as per Clause coarse and fine aggregates confirming to IS:383 maximum size of coarse aggregate not exceeding 25 mm mixed in a concrete mixure of not less than 0.20 cum capacity and approved appropriate weigh batcher using approved mixed design laid in approved fixed side formwork curring of concrete slabs for 14 days curring compounded (where specified) and water finising to lines and grade as per drawing and technical specification clause 1501

Providing and fixing of typical informatory sign board with Logo as per MORD specifications and drawing. Three MS Plates of 1.6 mm thick, top and middle plate duly welded with MS flat iron 25mm x 5m size on back on edges. The lower plate will be welded with MS angle iron frame of 25mm x 25mm x 5mm. The angle iron frame of the lower most plate and flat iron frame of middle plate will be welded to 2 nos. 75mm x 75 mm of 12 SWG sheet tubes posts duly embedded in cement concrete M-15 grade blocks of 450mm x 450mm x 600mm, 600mm below ground level. The top most diamond plate will be welded to middle plate by 47mm x 47mm of 12 SWG steel plate tube. All M.S. will be stove enameled on both sides. Lettering and printing arrows, border etc. will be painted with ready mixed synthetic enamel paint of superior quality in required shade and colour. All sections of framed posts and steel tube will be painted with primer and two coats of epoxy paint as per drawing Clause 1701 and Annexure 1700.1