Rural Engineering Department Tender

12mm thick plaster with cement and c/ sand in 1:4 oover brick work minimum thickness not to be less thsn 1 cm . Including supply of all materials , labour , tool 7 plants ,required for proper completion of the work .

Cement concrete with 2cm gauge approved stone ballast, coarse sand &cement in the proportin of 4:2:1 including supply of all materials , labour, Tools & plants etc.required for proper completion of the work .S I NO 279(a)

Providing ,laying,spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreasing in uniform thickness hand packing,rolling with three wheel 80-100 KN static Roller in stages to proper grade and camber,applying and brooming,requisite type of screening/binding materials to fill up the interstices of coarse aggregate,watering and compacting to the required density asper clouse 404

Construction of un-reinforced, Plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per clause 1501.2.2 M 30 (grade) coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels , rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contracton and expansion, construction joints applying debonding strips, primer, sealant, near approaches to bridge/culvert and construction joints admixtures as approved, curing of concrete slabs for 14-days, lines and grade as per drawing and Technical Specification Clause 1501(Rates are including all Taxes but excluding GST) UPPWD.SOR-2021 No. 20.14(a).

R.C.C work with cement approved coarse sand and 2cm gauge approved stone ballast in the proportions of 1:1.5:3 in collumn. Excluding supply of reinforcement and its binding but excluding its fixing and binding the same with 24 B.W.G.G.I.binding wire and in cluding ne essary centering and shuttering etc.and also including supply of all materials, laboure and T&Petc. required for proper completion of the work Excluding cost of Binding wire.SI NO 284 New item

M.S (tor steel or plain) in plain work such as R.C.C work including cutting & bending to proper shape complete including supply of all material, labour, T&P etc. required for proper completion of work as per PWD S.I. No. 504

Supply and fixing of M.S sign board.of prescribed size 1.20m *2.75 m with angle 40*40*6 mm iron angle and 1 mm thick ms iron sheet including painting and letter writing complete.approved rate as per S.E.R.E.D. Meerut.