Rural Engineering Department Tender

Laying brick soling layer on prepared sub-grade with S.O.B. Class brick on end edging according to lines, graded and cross-section shown on the drawing filling joints with sand and earth, spreading 25 mm thick layer of earth over brick soling, watering and rolliing the same with three wheel road roller 80-100 kN as per Mord Technical Specification Clause 4.18- 412.

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings (As per Mord Sr.No.-11.4 and technical specifications Clause 802, 803, 1202 & 1203) P.C.C. Grade M-10, Nominal mix (1:3:6).

Brick masonry work in cement mortar in substructure complete excepting pointing and plastering, as per drawing (As per Mord Sr.No.-11.5 and technical specification Clauses 602, 603, 604, 1202 & 1204 (II). (In 1:4 Cement mortar).

Plastering with cement mortar (1:4), 12 mm thick on brickwork in substructure (As per Mord Sr.No.-12.3 and technical specification Clauses 613.4 & 1204.

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings (As per Mord Sr.No.-11.4 -(III)and technical specifications Clause 802, 803, 1202 & 1203) P.C.C. Grade M-20, Nominal mix (1:2:4).

Construction of Granular Sub Base by providing Well graded material, spreading in uniform layers with Motor grader/Tractor mounted appropriate equipment on prepared surface, mixing by mix in place method with Rotavator at OMC and compacting with Smooth wheel roller to achieve the desired density complete as per Technical Specification Clouse 401

Plain/reinforced cement concrete in substructure complete as per drawings (As per Mord Sr.No.- 12.5 and technical specification Clauses 800-III) (R.C.C. Grade M-20)

Supplying, fitting and placing TMT bar reinforcement (Fe 415) in substructrue complete as per drawings (As per Mord Sr.No.- 12.7 technical specification Clauses 1002, 1005, 1010 & 1202).

Construction of un-reinforced, , plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using curing compound (where specified) and water finishing to lines and grade as per drawing (As per Mord Sr.No.-6.4 and Technical Specification Clause 1500).

Supply and fixing of a sign board including necessary supply of all materials, labour, Tools & plants etc. required for proper completion of the work As Per S.E. (R.E.D.), Saharanpur Sanction