Public Works Department Tender

Water Bound Macadam Grading-III Providing, laying, spreading and compacting stone aggregates of 53-22.4 mm sizes to water bound macadam G-3 specification including spreading in uniform thickness, hand packing, rolling with Smooth wheel roller 80-100 KN in stages to proper grade and camber, applying and brooming requisite type of screening/ binding Materials to fill up the interstices of coarse aggregate, watering and compacting to the required density for Grading 3 as perTechnical Specification clause -405(3)A

Brick edging on both side of the road of first Brick class M 150 8 cm wide and 12 cm deep laid with mud mortor including labour & supply of brick finished to required template and in proper alignment and also including dressing and ramming the excavated earth as directed by the E/I. of the work includkng material, all labour, T&P etc. for proper completion of work.

Providing and applying primer coat with bitumen emulsion on prepared surface of granular Base including clearing of road surface and spraying primer at the rate of 0.70 kg/sqm using mechanical means as per Technical specification clause - 502(I)

Providing and applying tack coat with bitumen using bitumen pressure distributor @ 0.30 Kg/Sqm. on the prepared bitumin surface cleaned with hydralic broom, As per MORD specification 503

Providing, laying and rolling of open - graded premix surfacing of 20 mm compacted thickness with 13.2 mm crushed stone grit @ 0.18cum/10sqm and 11.2 mm size crushed stone grit @ 0.09cum/10sqm from approved quarry and bitumen @ 1.46Kg/sqm to required line, grade and level to serve as wearing course on a previously prepared base, mixing in a suitable plant or by mixall, laying and rolling with a smooth wheeled roller 8-10 tonne capacity, finished to required level and grades, including cost of material, labour, plant, machinery and T&P, all taxes.including complete as per MORD Specification No.508(II)

Providing and laying seal coat type-C sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using 6.5 mm crushed stone grit @ 0.09cum/10sqm from approved quarry and bitumen/emulsion @0.65kg/sqm including cost of material, labour, plant, machinery, mixall and T&P, all taxes including labour etc. complete as per MORD Specification No.510(ia)

Construction of un-Reforced, dowel jointed at expension and construction joint only, plain cement concrete pavement, thickness as per desingn, over a prepared sub base, with 43 grade cement or any other type as per clause 1501-2.2 M30 Grade, coarse and fine aggregate conforming to IS 383 macadam size of coarse aggregate not exceeding 25mm mixed in a concretee mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polthene film, wedges, steel plates including leveliing the formwork as per drawing), spreading the concrete with showels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provisiion of contraction and expansion, construction joints, applying, deboinding strips, primer sealant, dowel bars, near approaches to bridge/ culvert and construction joints admixtures as approved, curing of concrete slabs for 14-days curing compound where specifed and water finishing to lines and grade as per drawing and technical specification on clause 1501

Construction Of Subgrade and Earthen Shoulers with approved material obtained from borrow pits with all lift and leads transporting to site, spreading, grading to required slope and compacting to meet requirement of table No. 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1

Earth in excavation in trenches for foudation in ordinary soil including lift upto 1.5 m lead upto 50 m. and dressing of sides and ramming of bottom and disposal of surplus excavated earth as directed by the Engineer-in-charge within a distace of 50m. SI

Plain cement concrete 1:3:6 nominal mix in foundation with brick ballast 40 mm nominal size mechanically mixed, placed in foundation and compacted by vibration including curing for 14 days. Sl.No. 2100 Including labour cess & Royality but exluding GST

Providing and Laying 40mm. Guage O.B.B. ballast (dry brick ballast) with local sand Complete as per S.I. No. 293 in foundation Including labour cess & Royality but exluding GST

Supply and Laying of H.P. NP3 Including cartage upto site laying with coller joint filling in cement mortor with Jute, labour T&P etc. 600 mm dia

Supply and Laying of H.P. NP3 Including cartage upto site laying with coller joint filling in cement mortor with Jute, labour T&P etc. 350 mm dia

Class 150 Brick masonry work cement mortar 1:4 in foundation complete excluding pointing and plaster as per drawing and Technical specification Clause. 600, 1202 & 1203 Including labour cess & Royality but exluding GST

Pointing with cement mortar (1:3 ) on brick work in substructure as per Technical Specifications Clause. 613.3 & 1204 Including labour cess & Royality but exluding GST

Plastering with cement mortar (1:3 ) on brick work in substructure as per Technical Specifications Clause. 613.3 & 1204 Including labour cess & Royality but exluding GST

Supply and fixing of sign board, k.m., HM., Stone and viilage name plate.

Rate to be quoted without G.S.T. & G.S.T. Shall be Paid extra as per Prevailing rules.