Public Works Department Tender

Tack Coat (i) Providing and applying tack coat with Bitumen VG-10 using bitumen distributor at the rate of 0.35 kg per sqm on the prepared bituminous surface cleaned with Hydraulic broom as per Technical Specification Clause 503.Clause 503. MORD (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing, laying and rolling of open-graded premix carpet of 20 mm thickness compesed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a Suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by Type C seal coat as per Technical Specification Clause 508 Mord (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing and laying Seal Coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510 Mord (Type-C) (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Construction of Subgrade and Earthen Shoulders Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1. (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross-sections, and transporting to the embankment location with a lift upto 1.5 m and lead upto 1000 m as per Technical Specification Clause 302.3 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 I. P.C.C grade M 10 (i) Nominal mix 1:3:6 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Brick masonry work in cement mortar in foundation complete excluding pointing and plastering as per drawing and technical specifications Clauses 600, 1202 & 1203 II. Brick masonry in 1:4 cement mortar (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Pointing with Cement Mortar (1:3) on brickwork as per technical specification Clause MORD 613.3 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Plastering with cement mortar (1:4), 15 mm thick on brickwork in substructure as per technical specification Clauses 613.4 & 1204 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing laying and fixing of 600 mm dia NP-3 Class Spigot Hume Pipe (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing laying and fixing of 1000 mm dia NP-3 Class Spigot Hume Pipe (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 IV. R.C.C grade M 20 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing weepholes in brick masonry/stone masonry, plain/reinforced concrete abutment, wing wall, return wall with 100 mm dia AC pipe extending through the full width of the structures with slope of 1(V):20(H) towards drawing face complete as per drawing and technical specification Clauses 614, 709, 1204.3.7 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Supplying, fitting and placing HYSD bar reinforcement in foundation as per drawing and Technical Specification clause 1000 & 1202 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing and laying boulder apron for bed protection with stone boulders of minimum size and weight as per Table 1300.1, no fragment weighing less than 25 kg laid dry complete as per drawing and technical specifications Clause 1301 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing and laying filter material underneath pitching in slopes complete as per drawing and technical specifications Clause 1302 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Sand filling in plinth including supply of necessary quantity of local sand from a distance not exceeding 8 Kms from the site of work and including watering dressing etc. required for proper completion of work. (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing and fixing of Hectometere stone as per IRC-8 including painting and letter writing etc as per direction of E/I. (Hecto mt. -stone) (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing and fixing of kilometere stone as per IRC-8 including painting and letter writing etc as per direction of E/I.(Km -stone). (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing and erecting direction and place indentification retro-reflectroised sign as per IRC-67 made of high intensity grade sheeting vide clause 801.3 fixed over almuminium sheeting,2 mm thickwith area not exceeding 0.9 sqm.Supported on a mild steel single angle iron post 75 x75 x6 mm firmly fixed to the ground by means of property designed foundation with M-15 grade cement concrete 45x45x60 cm,below ground level as per approved drawing,Complete.(90x90 cm) (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Maintenance of bituminous surface road and gravel or WBm road including filling pot holes and patch repair etc.restoration of rain cuts and dressing of side slop / berms,making up of berms / shoulders.maintenance of drain, maintenance of culvert,maintennance og guard rails and parapet.maintenance of road sign,speed breakers, standing tree at adjacent to road wherever required.maintenance of Hectometr and kilometr stone, cutting of branches of tree, shurb and trimming of grass and weeds etc.white whashing of parapet including CD Work,painting of guard stone, refixing of displaced guard stone (as per performance Index Anexure-1) mentioned in GO No. 55 /2022 /187 /23-9-2022-02 Nabard / 2021 Dt. 28.04.20022 & Enc lettere no. 14 BDD -1 ( NH ) / 40 MT - 11 / 2024dated 03.01.2024 subjected to approval from Govt. Maintence of 1st year after completion of work @ Zero % of total work amount of item 1 to 21. (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Maintenance of Second year @ 1% (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Maintenance of Third year @ 1.50% (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Maintenance of Fourth year @ 2.0 % (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Maintenance of Fifth year @ 3.00% (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)