Public Works Department Tender

Providing, laying seal coat with VG-10 Bitumen @ 6.5 kg per 10Sqm sealing the void in a bituminous surface laid to the specified levels grade cross fall usingType C as per Technical specification clauses 510. Including cost of all material, labour, T&P and all Taxes, Labour Cess, Royalty but excluding GST etc required for proper completion of the work and as per direction of Engineer Incharge. (Including cost of Bitumen)

Construction of un-reinforced, plain cement concrete pavement thickness as per disign, over a prepared sub base with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion, construction and constructionl joints, applying primer, sealant, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14 days, curing compund (where specified) and water finishing to lines and grade as per drawing and technical specification clause 1501. (For Agra)

Excavation in foundation in ordinary soil (Loam, Clay or Sand) Including lift upto 1.50 m and lead upto 30m and including filling watering and ramming of excavated earth into the trenches or into the space between the building and the sides of foundation trenches or into the plinth and removal and disposal of surplus earth as directed by the Engineer In-charge upto a distance of 30m from the foundation trenches. (Small work) Ch-4 SI No- 1

Providing and laying cement concrete in 1:4:8 (1 Cement : 4 Coarse sand : 8 graded stone aggregate 40 mm nominal size) and curing complete, Including cost of form work. in Foundation and floors. Ch- 5 SI No- 4.1.8 including cost of all materials, T&P, labour, cess, cartage for proper completion of work as per direction of Engineer-in-Charges

Class-150 (Non Modular) brick work in 1:4 cement and Coarse sand mortar in foundation and plinth including supply of all materials, labour and T&P etc. required for proper completion of the work. SI No- 6.1.1 including cost of all materials, T&P, labour, cess, cartage for proper completion of work as per direction of Engineer-in-Charges

Providing and laying cement concrete in 1:2:4 (1 Cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) and curing complete, Including cost of form work. In Foundation and floors including cost of all materials, T&P, labour, cess, cartage for proper completion of work as per direction of Engineer-in-Charges

12mm Cement plaster with cement mortar in proportion of 1:4 cement & coarse sand of single coat for interior plastering upto floor two level including internal rounded angles chamfers, and rounded angles not exceeding 80mm. In girth and finished even and smooth. Ch- 13 SI No- 13.4.1

Construction of embankment with approved materials deposited at site from roadway cutting and excavation from drain and foundation of other structures graded and compacted to meet requirement of Tables 300.1 and 300.2 as per Technical Specification Clause 301.5 including cost of all material, labour, T&P and all Taxes, Labour Cess, but excluding GST etc required for proper completion of the work and as per direction of Engineer Incharge.

Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site. spreading, grading to required slope and compacted to meet requirement of Table 300.2 as per Technical Specification Clause 303.1. including cost of all material, labour, T&P and all Taxes, Labour Cess, but excluding GST etc required for proper completion of the work and as per direction of Engineer Incharge.

Supply and Fixing of RCC hume pipe NP-3 (Socket Hume Pipe) 350mm Pipe including cost of all materials, T&P, labour, cartage for proper completion of work as per direction of Enginee-in-Charges.

Note - 1- Rates are inclusive of all taxes but excluding GST which shall be paid extra as applicable 2- Labour cess @ 1% will be deducted from contractor's bill at the time of payment