Public Works Department Tender

Providing and injecting chemical emulsion for preconstructional antitermite treatment and creating a chemical barrier under and allaround the column pits, wall trenches, basement excavation, top surface of plinth filling, junction of wall and floor along externel perimeter of building, expansion joints, surrounding of pipes and conduit etc. complete (plinth area of the building at ground floor only shall be measured as per I.S. 6313 part. II 1981) Chlorpyrifos or any other approved material such as Heptachlor or chlordane will be used. The rate of application of chemical emulsion shall be as follows SOR Chapter No-8 Item No-1C and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T

M-150 brick work in 1:3 (one cement and three coarse sand . mortar) in foundation and plinth and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T S.I no 307

12mm. Thick plaster with one part of cement and three part of approved coarse sand and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T Including making of groove in plaster surface. S.I no 583

Sand filling in plinth including supply of necessary quantity of sand from a distance not exceeding 8 Kms. From the site of work and including watering, dressing etc. Rate to and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI NO 255

Concrete with 4cm. Guage stone ballast fine sand of 1.25 F:M. and cement in proportion of 1:4:8 in foundation and under floors and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI NO 281

R.C.C. Work with cement approved coarse sand and 2cm. gauge approved stone grit in proportion of 1:1.5:3 raft foundation and footing with 4cm. Gauge stone ballast. excluding supply of reinforcement and its bending but including its fixing and binding the same with 24 B.W.G.G.I Binding wire and including necessary centering and shuttering etc. and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T S.I NO 287

Mild steel or iron in plain work such as reinforced concrete or reinforced brick work (when not included in an over all rates) wrought to required shape as necessary including bending for proper completion of the work and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI NO 504

Mild steel or iron work in heavy sizes such as trusses; built up gates, door, frames, record racks, roof work, gates etc. wrought to required form including drilling holes, rivetting or welding where necessary, and also including supply of steel, bolts and nuts and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI NO 503

Supply and fixing of galvanised corrugated iron roofing 24 BWG in position including supply of all materials labour tools plant etc. Required for proper completion of work and including wastage and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T

Providing and fixing false ceiling at all height including providing and fixing of frame work made of special sections, power pressed from M.S. sheets and galvanized with zinc coating of 120 gms/sqm (both side inclusive) as per IS: 277 and consisting of angle cleats of size 25 mm wide x 1.6 mm thick with flanges of 27 mm and 37mm, at 1200 mm centre to centre, one flange fixed to the ceiling with dash fastener 12.5 mm dia x 50mm long with 6mm dia bolts, other fange of cleat fixed to the angle hangers of 25x10x0.50 mm of required length with nuts & bolts of required size and other end of angle hanger fixed with intermediate G.I. channels 45x15x0.9 mm running at the spacing of 1200 mm centre to centre, to which the celling section 0.5 mm thick bottom wedge of 80 mm with tapered flanges of 26 mm each having lips of 10.5 mm, at 450 mm centre to centre, shall be fixed in a direction perpendicular to G.I. intermediate channel with connecting clips made out of 2.64 mm dia x 230 mm long G.I wire at every junction, including fixing perimeter channels 0.5 mm thick 27 mm high having flanges of 20 mm and 30 mm long, the perimeter of ceiling fixed to wall/partition with the help of rawl plugs at 450 mm centre, with 25mm long dry wall screws 230 mm interval, including fixing of gypsum board to celling section and perimeter channel with the help of dry wall screws of size 3.5 x 25 mm at 230 mm c/c, including jointing and finishing to a flush finish of tapered and square edges of the board with recommended jointing compound jointing tapes finishing with jointing compound in 3 layers covering upto 150 mm on both sides of joint and two coats of primer suitable for board, all as per manufacturer's specification and also including the cost of making openings for light fittings, grills, diffusers, cutouts made with frame of perimeter channels suitably fixed, all co plete as per drawings, specification and direction of the Engineer in Charge but excluding the cost of painting with 12.5 mm ge gypsum moisture resistant board (LKo SOR Chapter 14 item 12.45.3) and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T

Providing and laying vitrified floor tiles (BELL / KAJARIA / SOMANI or other standard make) in different sizes (thickness to be specified by the manufacturer) with water absorption's less than 0.08% and conforming to IS :15622 of approved make in all colours and shades, laid on 20 mm thick cement mortar 1:4( 1 cement: 4 coarse sand) including grouting the joints with white cement and matching pigments etc, and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI NO CH 14 NEW ITEM 4

Supply and fixing of (anodized aluminum door having 2 min aluminium section excluding costing and an average costing of 20 micron fully gland made of aluminum door tube sine 83.3 x 44.65 m as vertical member and 1140 44.45 mm sim tube in bottom and horizontal member door chaukhat should be of minun table vertical with th hen openable shutier the rate including cost a of material of glass handles lock scary sending and fixtures exclading cost of floor spring if ropaired for proper completion of the work, as per direction of lingineur in charge .Same as in tem no. 14 but with 5.000 mm thick plain glass complete SOR Ch12 new ITEM no 15 and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T

12 Wall panelling providing and fixing in position wall panels of plain phenol formaldehyde synthetic resin tiles over kail wood frame and provision for providiong switch board fixtures etc. an per drawing complete with polishing and finishly with french/Wax polish as per dircation given by Engineer-in-charge.Same as in item no. 12 above but with one side laminated instead of plain board.SOR Ch12 new ITEM no 14 and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T

Providing and fixing in position double skin wooden partition with fibre or particle hoard frame of 900 x 1200 rectangular of section 50 x 38 mm covered with 12 mm thick teak wood particle board commerial quality on both face duly painted two coats of high gloss synthetic enamel paint over one priming paint complete and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SOR Ch12 new ITEM no 10

Providing and fixing G.I./First quality high pressure CPVC pipes of dia.20mm or higher complete with G.I. fittings and clamps, including cutting and making good the walls etc. linternal work - Exposed on wall : and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T (SI 18.10.2)

Construction work of Prefabricated Public Toilet in the Outer court of Distt Sambhal

12mm. Thick plaster with one part of cement and three part of approved coarse sand including supply of all materials labour and completion of work.Including making of groove in plaster surface and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T S.I no 583

Concrete with 4cm. Guage stone ballast fine sand of 1.25 F:M. and cement in proportion of 1:4:8 in foundation and under floors and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI NO 281

Providing wall putty on New surface with approvel quality material of Berger/J.K./Birla or similar make 2 coates and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SL NO ch.15 new item 12

Distempring two coat with oil bound distemper of approved brand and manufacture and required shade on undecorated wall surface with an even shade over and including a primer coat with cement primer of approved brand and manufacture such as of British, 'Shalimar asian paint after thoroughly brushing the surface free from mortar droppings and other foreign matter and also including preparing the surface even and sand prepared smooth and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SOR Sl no 649+650

Providing and fixing white vetreous china pedestal type water closet (Indian type) W.C. pan with ISI marked white solid plastic seat and lid with seal and lid, 10 litre low level white vitreous china flushing cistern & C.P. flush bend with fittings & C.I. brackets, 40mm flush bend, overflow arrangement with specials of standard make and mosquito proof coupling of approved municipal design complete including painting of fittings and brackets, cutting and making good the walls and floors wherever required and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T (SI 17.3.1)

Providing and fixing Single sqauatting plate with 5 litre P.V.C. automatic flushing cistern one piece construction white vitreous china squatting plate with an integral longitudinal flushing pipe, white P.V.C. automatic flushing cistern, with fitting, standard size G.I. flush pipe for back and front flush with standard spreader pipes with fittings, G.I. clamps and C.P. brass coupling complete including painting of fittings and brackets, cutting and making good the walls and floors wherever required and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI No 17.6.1

Providing and laying vitrified floor tiles (BELL / KAJARIA / SOMANI or other standard make) in different sizes (thickness to be specified by the manufacturer) with water absorption's less than 0.08% and conforming to IS :15622 of approved make in all colours and shades, laid on 20 mm thick cement mortar 1:4( 1 cement: 4 coarse sand) including grouting the joints with white cement and matching pigments etc, and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T

Providing and fixing C.P. brass long body bib cock of approved quality conforming to IS standards and weighing not less than 690 gms 15mm nominal bore and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T (SI 18.51.1)

Providing and fixing P.V.C. waste pipe for sink or wash basin size 40mm dia. including P.V.C. waste fittings complete and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI 17.28.1.2)

Providing and fixing brass stop cock of approved quality: 20mm bore and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T (SI 18.16.02)

Providing and fixing of Flat back wash basin of size 630x450mm white vitreous china wash basin including making all connections but excluding the cost of fittings : and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T SI No 17.25.1

Providing and fixing G.I./First quality high pressure CPVC pipes of dia.20mm or higher complete with G.I. fittings and clamps, including cutting and making good the walls etc. linternal work - Exposed on wall : and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T (SI 18.10.2)

Providing and fixing PVC pipe, 6 kg/ per sq.cm. pressure 10cm. Dia. including cutting and making good the walls etc. linternal work - Exposed on wall : and including supply of material, labour, labour cess, T&P royalty, all tasex ect. complete as per direction by i-in-c but excluding G.S.T (SI 730A)