Public Works Department Tender

1- Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with paver in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.(excluding GST)

1- Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14- days,(excluding GST)

1- Providing and applying tack coat with bitumen (VG-10) using pressure distributor at the rate of 0.35 kg per sqm on the prepared bituminous/granular surface treated with primer & cleaned with hydraulic broom as per Technical Specification Clause 503 (Including all taxes required and Cost of bitumen but excluding GST)

1- Providing, laying and rolling of open - graded premix surfacing of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or cut-back or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a smooth wheeled roller 8-10 tonne capacity, finished to required level and grades. (Including all taxes required and hire charges of road roller and Cost of bitumen but excluding GST)

1- Providing and laying seal coat by manual means with VG-10 Grade Bitumen sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510 (Including all taxes required and hire charges of road roller and Cost of bitumen but excluding GST)

1- Earth work in Patri or embankment in ordinary soil loam, clay or sand in patries on both side of road including ramming dressing required to proper completion of work including all labour T&P etc all complete. as per S.I. NO. 253 (Excluding GST)

1- Hume Pipe Culvert 350mm Dia 1 No. Excavation of foundation in ordinary soil including lift upto 1.50 m and lead up 30m and including filling watering and ramming of excavated earth into trenches or into the plinth and removel and disposal of surplus earth as direction by I/E upto a distance of 30m from the foundation trench as per SI No-251 excluding GST)

1- P.C.C. work with cement approved coarse sand 2.0cm gauge approved stone ballast in the proportion of 1:2:4 in lintels of doors and windows etc and bed plates excluding the supply of reinforcement and its bending and including providing and fixing necessary centering and suttering and its removal after completion fo the work & supply of all other materials labour and T&P etc required for the proper completion of the work SI No-284 excluding GST

1- Supply and Laying of 350 mm NP-3 Hume pipes