Public Works Department Tender

Providing and laying Seal Coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510 Mord (Type-C) (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Construction of un-reinforced and construction joint only plain cement concrete pavement thicknesh as per drawing over a prepared sub base with 43 grade cement as per clause 1501.22 M-30 Grade coarse and fine aggregate conforming to IS 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixture of not less than 0.20cum capacity and aproctimat weight batcher using approved mis design laid in approved fixed etc form work (Steel, channel laying & fixing fo 125 micron thick polythin film wedge steel plates including leveling the form work as per drawing) speading the concrete with shovels, rakes, compacted, using niddle sceed and plate vibrators and finished in a continuous operation including provision of contraction, expansion, construction joints applying primers sealent and construction joint admixtures as approved curring of concrete slabe for 14 days curing compound (where specified) and water finishing to lines and grade as per drawing and technical specification clause 1501. (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1. (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Excavation for roadwork in soil with hydraulic excavator of 0.9 cum bucket capacity including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross-sections, and transporting to the embankment location with a lift upto 1.5 m and lead upto 1000 m as per Technical Specification Clause 302.3 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 I.( P.C.C grade M 10 (i) Nominal mix 1:3:6) (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Brick masonry work in cement mortar in foundation complete excluding pointing and plastering as per drawing and technical specifications Clauses 600, 1202 & 1203 II. (Brick masonry in 1:4 cement mortar) (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Plastering with cement mortar (1:4), 15 mm thick on brickwork in substructure as per technical specification Clauses 613.4 & 1204 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Providing concrete for plain/reinforced concrete in open foundations complete as per drawings and technical specifications Clause 802, 803, 1202 & 1203 IV. R.C.C grade M 20 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)

Supplying, fitting and placing HYSD bar reinforcement in foundation as per drawing and Technical Specification clause 1000 & 1202 (Rates are including all taxes, royalty, labour cess etc but Exculding GST shall be paid as per applicable)