Public Works Department Tender

Construction of un-reinforced, without dowel jointed at expansion and construction joint, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other typ0e as per clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS: 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continious operation including provision of contraction and expansion, construction joints, aplying debonding strips, prime, sealant, near approaches to bridge, culvert and construction joints, admixtures as approved, curing of concrete slabs for 14 days.

Cement Concrete with 4 cm gauge approved in proportions of 8:4:1 stone Ballast, Coarse sand and cement. including supply of all materials, labour, Tools & plants etc. required for proper completion of the work. As per SI No. 281

R.C.C. Work with cement, approved coarse sand & 2 cm gauge approved stone grit in proportions of 1:1.5;3 in lintels of door & windows excluding supply of reinforcement and its bending, but including its fixing and binding the same with 24 B.W.G.G.I. binding wire and including necessary centering and shuttering etc. and supply of all materials, labour, Tools & plants etc. required for proper completion of the work including cost of binding wire. The rate excludes making of drip course which shall be paid extra. As per SI No. 284(A)

M.S.(tor steel or plain) in Plain work such as R.C.C. or R.B. work including bending for proper shape and including supply of steel & its wastage, bend, hooks and authorised overlapping shall be measured and including cost of binding wire.

Cement Concrete with 4 cm gauge approved stone grit, coarse sand & cement in the proportion of 8:4:1 including supply of all materials, labour, Tools & plants etc. required for proper completion of the work. (S.I. No. 279(a)

M-150 class brick work in 1:3 cement and coarse sand mortar in superstructure including supply of all materials labour tools & pland etc. required for proper completion of the work. (S.I. No. 307)

Struck cement pointing with 1:2 cement and fine sand of 1.25 F.M. mortar with colouring including supply of all materials, labour, Tools & plants etc. required for proper completion of the work. (S.I. No. 578)

12mm thick plaster with cement and fine sand of 1.25 F.M. in 1:4 over brick work minimum thickness not to be less than 1 cm. including supply of all material, labour, T&P etc. required for proper completion of work. (S.I. No. 584)

Cement Concrete with 4 cm gauge approved stone grit, coarse sand & cement in the proportion of 4:2:1 including supply of all materials, labour, Tools & plants etc. required for proper completion of the work. (S.I. No. 279(a)

Supply and fixing of 600mm dia Hume Pipe

Construction of Sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacting to meet requirement of table 300-2.