Public Works Department Tender

Supply and fixing ISI marked 32 mm thick flush door shutter commercial conforming quality conforming to IS : 2202 (Part I) including supply and fixing of hinges,screws, sliding bolt, tower bolt, door stoper and Allum. Handel etc complete work.

Supply and fixing of glass pans (4.8 to 5.7mm) with equal or equivalent ISI marked quality, putty, brads and spring including supply of all materials, labour and T&P etc complete work

Providing and applying white cement based putty of average thickness 1mm of approved brand and manufacturer over the plastered wall surface to prepare the surface even and smooth complete. SI 30

Painting with oil bound distemper (two coat) of approved quality and of required shade on undecorated wall surface to give an even shade with one priming coat of approved quality as directed by E/c, including cost of all material, labour T&P etc.SI 449+450

Painting with synthetic enamel paint two coat of approved quality on wood or steel surface including priming coat as directed by E/c, including cost of all material, labour T&P etc.SI 641+642

Providing and fixing 600x450 mm size with bevelied edge mirror of superior glass ( of approved quality) complete with 5mm thick hard board ground fixed with rawal plug with iron screws and washers complete.

Providing and Fixing C.P. shop Dish Holderhaving length of 138 mm breadth 102mm height 75 mm with concealed fitting including supply of all material labour T&P etc. complete. (L&K MAKE)

Providing and fixing CP brass towel rail 750×20mm together with pair of CP brass brackets to fit the towel rail complete

Providing and fixing Fly proof wire gauze to windows, clerestory windows & doors with M.S. Flat 20×5 mm and nuts & bolts complete. Stainless steel (grade 304) wire gauze of 0.5 mm dia wire and 1.4 mm aperture on both sides

Disposal of refuse (malba) 15.00 km far from the site of excuation as per direction of E/c.

Providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/ appropriate Z sections and other sections of approved make conforming to IS: 733 and IS: 1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing / paneling, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-charge. (Glazing, paneling and dash fasteners to be paid for separately) : Anodised aluminium (anodised transparent or dyed to required shade according to IS: 1868, Minimum anodic coating of grade AC 15)