Public Works Department Tender

Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using VG-10 (IOCL/HPCL) penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of either Type C as per Technical Specification Clause 508. (Including all T&P, Labour, Material, Royalty Tax but excluding GST)

Providing and laying seal coat sealing the voids in a bituminous (IOCL/HPCL) surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510 (Including all T&P, Labour, Material, Royalty Tax but excluding GST)

Construction of subgrade and earthen shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.2 with lead upto 1000 m as per Technical Specification Clause 303.1. (Including all T&P, Labour, Material, Royalty Tax but excluding GST)

U-Type Drain (Including all T&P, Labour, Material, Royalty Tax but excluding GST)

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501. (Including all T&P, Labour, Material, Royalty Tax but excluding GST)

First Year Maintainance (@0% of Total Work Amount of S.No. 1 to S.No.8)

Second Year Maintainance (@1.5% of Total Work Amount of S.No. 1 to S.No.8)

Third Year Maintainance (@3.0% of Total Work Amount of S.No. 1 to S.No.8)

Fourth Year Maintainance (@4.5% of Total Work Amount of S.No. 1 to S.No.8)

Fifth Year Maintainance (@6.0% of Total Work Amount of S.No. 1 to S.No.8)