Public Works Department Tender

Item Name :- (iii)Providing and applying tack coat with Bitumen VG-10 using bitumen distributor at the rate of 0.35 to 0.45 kg per sqm on the prepared granular surfaces treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503.

Providing, laying and rolling of open - graded premix surfacing of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or cut-back or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a smooth wheeled roller 8-10 tonne capacity, finished to required level and grades. Including cost of Bitumen but Excluding GST.

6 Item Name :- Seal Coat Item Name :Seal Coat Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type A, Type B and Type C as per Technical Specification Clause 510 A. By Manual Means Case - III : Type C (I) Bitumen (S-90)

Item Name :- Cement Concrete Pavement Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixture

Excavation in foundation in ordinary soil (loam clay or sand) including lift upto 1.50 metre and lead upto 30 Mtr. Including filling watering and ramming of excavated earth into the trenches of into the space between the building and the sides of foundation trenches or into the plinth and removal & disposal of surplus earth as directed by the Engineer incharge upto a distance of 30m from the foundation trenches. Excluding GST (SI No- 251)

cement concrete with 40 mm gauge approved stone ballast, coarse sand and cement in proportions of 6:3:1 including supply of all materials, labour, tools & plant etc required for proper completion of the work.Excluding GST (SI No- 280)

M - 150 Brick work in one Corse Sand and three surkhi morter in foundation and plinth including supply of all materials, labour & tools & plants etc. requied for proper completion of the work. Excluding GST (SI No- 305A)

Cement concrete with 40 mm gauge approved stone ballast, coarse sand and cement in proportions of 1:1½:3 including supply of all materials, labour, tools & plant etc required for proper completion of the work.Excluding GST

1.20 cm thick instead of 2 cm thick cement plaster in dado or skirting in 1:2 consisting of one part of cement & two parts of approved coarse sand laid in panels finished with 3 mm floating coat of neat cement or cement mixed with marble dust in ratio of 5:1 including supply of all materias, labour T&P etc. required for proper completion of the work. Excluding GST (SI No- 597B)

2.5 cm thick Damp Proof Course with cement and approved coarse sand 1:1½:3 with and including water proofing material as ordered by the Engineer Incharge in the proportion as specified by the manufacturers including supply of all materials, labour and tools & plants etc required for proper completion of work and including proper curing and shutterings as necessary. (SI No- 361)