Public Works Department Tender

Construction of granular sub-base by providing close graded material, spreading in uniform layers with motor grader on prepared surface, mixing by mix in place method with front end loader at OMC, and compacting with vibratory roller to achieve the desired density, complete as per clause 401 (SI No. 4.01)

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Material by tipper to site, laying in uniform layers with grader in sub- base / base course on well prepared surface and compacting with vibratory roller to achieve the desired density.(Morth Specification Clause - 406 SI No. 4.14)

Construction of sub-grade and earthen shoulders with approved material obtained from borrow pits with all lifts & leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table No. 300-2 (Morth Specification Clause - 305 SI No. 3.18)

Wet Mix Macadam +1% OPC+3.5 % Emulsion Providing laying spreading to graded stone aggregate (WMM) after mixing of water at OMCin mechanical mix plant carriage of mixed material by tipper to site laying with 1% OPC and 3.5 % emulsion in uniform single layer on subbase / subgrade and compacting with road roller to achive desired density as per MoRTH specification 4.06 (Bitumen Emulsion SS-2)

Providing and applying tack coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.(Rate including Bitumen VG-10) (Morth Specification Clause - 503 SI no. 5.02 I)

Providing and laying bituminous concrete with higher capacity batch type hot mix plant 120 TPH using crushed aggregates of specified grading, premixed with bituminous binder @ 5.40 per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No. 507 B SI no. 5.05 complete in all respects(Rate including Bitumen VG-30)

Providing & laying of 80 mm thick C.C. Pre rubber moulded inter locking paver tiles incl. 40 mm thick fine sand cusion bed in proper slope & camber including all material, labour, T&P etc. required for proper completion of the work. M-40 Grade

Plain cement concrete 1:3:6 nominal mix in foundation with crushed stone aggregate 40 mm nominal size mechanically mixed, placed in foundation and compacted by vibration including curing for 14 days.(Morth Specification Clause - 2100 SI no. 12.04)

Plain/Reinforced Cement Concrete in Open Foundation complete as per Drawing and Technical Specifications. RCC M-20 Grade (Morth Specification Clause - 1500,1700 & 2100 SI No. 12.08 C ) Case -II

Plain/Reinforced Cement Concrete in Open Foundation complete as per Drawing and Technical Specifications. RCC M-25 Grade (Morth Specification Clause - 1500,1700 & 2100 SI No. 15.11 D )

Supplying, Fitting and Placing HYSD bar Reinforcement in sub-structure complete as per Drawing and Technical Specifications (Morth Specification Clause - 1600 & 2200 SI.NO. 13.06 )

Brick masonry work in 1:3 in sub-structure complete excluding pointing and plastering, as per drawing and Technical Specifications (Morth Specification Clause 1300 , SI no- 12.05)

Pointing with cement mortar (1:3 ) on brick work in substructure as per Technical Specifications (Morth Specification Clause - 1300 & 2200 SI No 13.02 )

Plastering with cement mortar (1:3 ) on brick work in sub-structure as per Technical Specifications ( Morth Specification clause no 1300 &2200 SI No. 13.03)

Laying Reinforced Cement Concrete Pipe NP-3 prestressed concrete pipe for culverts on first class bedding of granular material in single row including fixing collar with cement mortar 1:2 but excluding excavation, protection works, backfilling, concrete and masonary works in head wall and parapets.(600 mm dia HP)(Morth Specification Clause 1106, SI No- 9.3)

Laying Reinforced Cement Concrete Pipe NP-3 prestressed concrete pipe for culverts on first class bedding of granular material in single row including fixing collar with cement mortar 1:2 but excluding excavation, protection works, backfilling, concrete and masonary works in head wall and parapets.(1000 mm dia HP)(Morth Specification Clause 1106, SI No- 9.4)

Providing & fixing, km. stone, hectometre stone & sign board etc. complete Informetry signboard repair of culvert etc.

Providing and Laying of hot applied thermoplastic compound 2.5 mm thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per IRC:35. The finished surface to be level, uniform and free from streaks and holes. As per MORTH specification 803, SI no. 8.13.

Supply, fixing & eraction of built up Cantilever Structure 6 m span comprising of one vertical posts of 6.00 M height made up of 300 mm NB heavy class MS pipe as vertical member welded with 10 mm MS plate at top & 12 mm M S plate at bottom. The horizontal Truss shall comprise of 50 mm dia heavy class M.S. pipe and 40 mm d1a heavy M S pipe as bracing & 10 mm MS plate al bottom for fixing to vertical posl as per structure design & drawing with one of steel primer and two coals of synthetic enamel plant. The work Includes construction of RCC Foundation or size 0.90x0.90x1.50 m or required depth as per site condition for built up structure Including Earth work In excavation 100 mm thick Lean Conc,ete In 1:3:6 cement coarse sand and 40 mm gauge stone ballast and RCC • M25 grade conc,ete Including supply and fixing or 25 mm dia Foundation Bolts 600 mm long as per provision or structure design including cost or reinforcement & shuttering. The lateral vertical clearances and complete lnstalation work shall be as per relevant clauses of MORT&H specification secllon 800 and IRC 67-2012 complete in all respect The Rales shall Include cost of design fabrlcaUon, supply, transportation, Local shifting Erection of Signage structure using c,ane, Inclusive of all taxes etc. all T&P machine, material and labour required for proper completlon of work as per direction of Engineer-In-charge.

Supply and fixing of fully Retro Reflective sign board made of 4 mm thick aluminium sheet face to be fully covered with high Intensity encapsulated lens long types as per colour required. The Retro reflective sheet shall be processed on base Aluminium will be provide with frame of 40 x 40 x 4 mm angle all around cross with proper clamping arranged of fix cantilever structure. The back of the aluminium sheet be powder coated. Rates to be inclusive of all taxes, royalty, VAT etc. all T&P/machine, material and labour required for proper complition of work.

Direction and Place Identification signs upto 0.9 sqm size board. (Providing and erecting direction and place identification retro-reflectorised sign asper IRC:67 made of encapsulated lens type reflective sheeting vide clause 801.3, fixed over aluminium sheeting, 2 mm thick with area not exceeding 0.9 sqm supported on a mild steel single angle iron post 75 x 75 x 6 mm firmly fixed to the ground by means of properly designed foundation with M15 grade cement concrete 45 x 45 x 60 cm, 60 cm below ground level as per approved drawing)

Providing and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per IRC:67 mad of high intensity grade sheeting vide clause 801.3, fixed cover aluminium shting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x75 mm x6 mm firmly fixed to th ground by means of properly dsignd foundation with M-15 grade cment conc. 45 cm x 45 cm x 60 cm, 60 cm below ground lvel as per approved drawing (Speed Limit Signs at Curve and Abadi Portion)

Providing and fixing of retro- reflectorised cautionary, mandatory and informatory sign as per IRC :67 made of high intensity grade sheeting vide clause 801.3, fixed over aluminium sheeting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x 75 mm x 6 mm firmly fixed to the ground by means of properly designed foundation with M15 grade cement concrete 45 cm x 45 cm x 60 cm, 60 cm below ground level as per approved drawing.(Stop Sign Board on Minor Roads at Intersections)

Providing and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per IRC:67 mad of high intensity grade sheeting vide clause 801.3, fixed cover aluminium shting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x75 mm x6 mm firmly fixed to th ground by means of properly dsignd foundation with M-15 grade cment conc. 45 cm x 45 cm x 60 cm, 60 cm below ground lvel as per approved drawing.( Hazard Sign on Parapet (Left & Right Side))

Providing and fixing of retro-reflectorised cautionary, mandatory and informatory sign as per IRC:67 mad of high intensity grade sheeting vide clause 801.3, fixed cover aluminium shting, 1.5 mm thick supported on a mild steel angle iron post 75 mm x75 mm x6 mm firmly fixed to th ground by means of properly dsignd foundation with M-15 grade cment conc. 45 cm x 45 cm x 60 cm, 60 cm below ground lvel as per approved drawing.(Chevron Sign at Curves)

Maintenance of bituminous surface road and/or gravel road and/or WBM road including filling pot holes and patch repair etc. Restoration of rain cuts and dressing of side slopes / berms, making up of berms / shoulders, maintenance of drain, maintenance of culvert,maintenance of guard rails and parapet,maintenance of road sign,speed breakers, standing tree at adjacent to road wherever required, maintenance of 200m and kilometer stones, cutting of branches of tree, shrubs and trimming of grass and weeds etc. White whashing of parapets including CD Works, painting of guard stones, re-fidding of displaced guard stones (as per performance Index Anexure-1) & maintenance mentioned in GO No. 17 /2024 /S-113/23-1-2024-23-1099/113/2023 Dt. 16.01.2024, Circular no. 3689 C-OPRMC/Original-23-24 Dt. 17.02.2024 (On item no. 1 to 28) Mantenence Charge I year - 0.00% (On Item no. 01 to 28.)

Maintenance of bituminous surface road and/or gravel road and/or WBM road including filling pot holes and patch repair etc. Restoration of rain cuts and dressing of side slopes / berms, making up of berms / shoulders, maintenance of drain, maintenance of culvert,maintenance of guard rails and parapet,maintenance of road sign,speed breakers, standing tree at adjacent to road wherever required, maintenance of 200m and kilometer stones, cutting of branches of tree, shrubs and trimming of grass and weeds etc. White whashing of parapets including CD Works, painting of guard stones, re-fidding of displaced guard stones (as per performance Index Anexure-1) & maintenance mentioned in GO No. 17 /2024 /S-113/23-1-2024-23-1099/113/2023 Dt. 16.01.2024, Circular no. 3689 C-OPRMC/Original-23-24 Dt. 17.02.2024 (On item no. 1 to 28) Mantenence Charge II year - 0.25% (On Item no. 01 to 28.)

Maintenance of bituminous surface road and/or gravel road and/or WBM road including filling pot holes and patch repair etc. Restoration of rain cuts and dressing of side slopes / berms, making up of berms / shoulders, maintenance of drain, maintenance of culvert,maintenance of guard rails and parapet,maintenance of road sign,speed breakers, standing tree at adjacent to road wherever required, maintenance of 200m and kilometer stones, cutting of branches of tree, shrubs and trimming of grass and weeds etc. White whashing of parapets including CD Works, painting of guard stones, re-fidding of displaced guard stones (as per performance Index Anexure-1) & maintenance mentioned in GO No. 17 /2024 /S-113/23-1-2024-23-1099/113/2023 Dt. 16.01.2024, Circular no. 3689 C-OPRMC/Original-23-24 Dt. 17.02.2024 (On item no. 1 to 28) Mantenence Charge III year - 0.50% (On Item no. 01 to 28.)

Maintenance of bituminous surface road and/or gravel road and/or WBM road including filling pot holes and patch repair etc. Restoration of rain cuts and dressing of side slopes / berms, making up of berms / shoulders, maintenance of drain, maintenance of culvert,maintenance of guard rails and parapet,maintenance of road sign,speed breakers, standing tree at adjacent to road wherever required, maintenance of 200m and kilometer stones, cutting of branches of tree, shrubs and trimming of grass and weeds etc. White whashing of parapets including CD Works, painting of guard stones, re-fidding of displaced guard stones (as per performance Index Anexure-1) & maintenance mentioned in GO No. 17 /2024 /S-113/23-1-2024-23-1099/113/2023 Dt. 16.01.2024, Circular no. 3689 C-OPRMC/Original-23-24 Dt. 17.02.2024 (On item no. 1 to 28) Mantenence Charge IV year - 0.75% (On Item no. 01 to 28.)

Maintenance of bituminous surface road and/or gravel road and/or WBM road including filling pot holes and patch repair etc. Restoration of rain cuts and dressing of side slopes / berms, making up of berms / shoulders, maintenance of drain, maintenance of culvert,maintenance of guard rails and parapet,maintenance of road sign,speed breakers, standing tree at adjacent to road wherever required, maintenance of 200m and kilometer stones, cutting of branches of tree, shrubs and trimming of grass and weeds etc. White whashing of parapets including CD Works, painting of guard stones, re-fidding of displaced guard stones (as per performance Index Anexure-1) & maintenance mentioned in GO No. 17 /2024 /S-113/23-1-2024-23-1099/113/2023 Dt. 16.01.2024, Circular no. 3689 C-OPRMC/Original-23-24 Dt. 17.02.2024 (On item no. 1 to 28) Mantenence Charge V year - 1.00% (On Item no. 01 to 28.)