Public Works Department Tender

Providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mmgrit @ 1.80cum. per 100 sqm , 11.2 mm. grit @ 0.90cum per 100 sqm using penetration grade bitumen 146 kg per 100 sqm.including cost of labour at plant and laying site as required and T&P etc but excluding cost of bitumen , Hire charges of plant, Transportation of mix material with tipper and laying with paver finisher finished to required level and grades as per Technical Specification Clause 508.and inclunding tack coat over Bituminious surface. (Excluding GST)

Providing, laying Seal coat Type C over P.C. surface with crushed stone chipping 6.7 mm. nominal size @ 0.90cum per 100 sqm using penetration grade bitumen VG-10 @ 0.65 kg per 100 sqm.including cost of labour at plant and laying site as required and T&P etc but excluding cost of bitumen, Hire charges of plant, Transportation of mix material with tipper and laying with paver finisher finished to required level and grades as per Technical Specification Clause 510.(Excluding GST)

Construction of plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M 30 (Grade), coarse and fine aggregates conforming to IS: 383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501. (Excluding GST)

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), excavated soll and disposal of surplus excavated soll as directed, within a lead of 50 m.including dressing of sides and ramming of bottoms, lift up to 1.5 m, including getting out the all kind of soil as per S.I. No. 2.8.1

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level 1:3:6 (1 Cement : 3 coarse sand : 6 graded stone aggregate 40 mm (nominal size)) as per S.I. No. 4.1.6

Brick work with common burnt clay (non modular) bricks of class - 150 in foundation and plinth in : Cement mortar 1:4 (1 cement : 4 coarse sand) as per S.I. No. 6.1.1. (Excluding GST)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level 1:2:4 (1 Cement : 2 coarse sand : 4 graded stone aggregate 20 mm (nominal size)) as per S.I. No. 4.1.3. (Excluding GST)

Plastering with cement mortar (1:4) 15 mm thick on brickwork in substructure/superstracutre as per technical specification clauses 613.4 & 1204. (Excluding GST)