Public Works Department Tender

SPEED LIMIT & Restriction Over Board (Ch. 47.900 to 48.450)

HAZARD MARKER (Ch. 48.000)

LEFT SIDE ROAD (Ch. 48.400)

RIGHT SIDE ROAD (Ch. 48.300, 48.350, 48.400, 48.450)

Repeated Bar Sign Board (Ch. 47.900, 48.350, 48.400, 48.450)

Speed Table Sign Board (Ch. 47.900 to 48.650)

School Board (Ch. 48.300)

Accidental Caution Board (90 cm high octagon) (Ch. 47.900 to 48.450)

Supply & Fixing of Retro reflective Tree Plate having size 15cm x15cm, consisting Type XI Retro reflective Sheeting foxed Over 1.50 mm thick aluminium sheet including labour, Material T&P etc for proper completion of the work. The rate shall include all materials, labour, T&P transportation installation and incidentals all complete as per direction of the Engineer-in-Charge

Reflective Raised Pavement Markers (Cat Eyel Road Stud) (8.35)- Supply and fixing of raised pavement marker with Made of Plastic body of RPM Road Stud shall be ggestive moulded from ASA (Acrylic Styrene Acrylonitrite) or HIPS (High-Imoact Polystyrene) or Acrylonitrite Butadien Styrene (ABS) or Any other suitable material approved by the Engineer. The Marker shall support a load of 13,635 kg fested in accordance with ASTM D4260 The Reflective panels shall consist of number of lenses contatring single or dual prismatic cubes capable of providing total internal reflection of the light entring the lens face. Lenses shall be mouled of methyl methecrylate conforming to ASTM D788 of equivalent. The slop or retro-reflecting surface shall preferably be 35+1-5 degree to base and the area of each retro-reflecting surface shall not be less than 13.00 sq.cm the marker height shall not be less than 10 mm and shall not exceed 20 mm & Width shall not exceed 130 mm. The base of the marker shall be flat within 1.3 mm all road studs shall be legibly marked with the name, trade or other means of identification of the manufacture epoxy installations, excess adhesive around the edge of the marker, excess adhesive on the pavement and adhesive on the exposed surfaces of the markers shal be immediately removed. The contractor shall submit a two year warranty for satisfactory field performance including stipulated retro-reflectance of the reflecting panel, to the Engineer in addition, a two year warranty for satisfactory infield performance of the finished road marker shall also be given by the contractor who carries out the work of fixing of reflective road markers. In case the markers are displaced, damaged get worn out or lose their reflectivity compared to stipulated standards, the contractor would be required to replace all such markers within 15 days of the Intimation from the Engineer, at his own cost. The rate shall include all materials, labour, T&P, transportation, installation and incidentals all complete as per direction of the Engineer-in-Charge.