Panchayati Raj Department Tender

WBM Grading -3 -Providing laying , spreding and compacting stone aggregate of 22.4-53mm size to water bound macadam specification including spreading in uniform thickness ,hand packing . Rolling with smooth whell roller 80-100 kn in stage to proper grade and camber ,applying and brooming ,stone screening to fill up the interstices of coarse aggregate ,watering and compacting to required density as per technical specification Clause 405.

Excavation for roadway in soil using manual means for carrying of cut earth to embankment site with a lift upto 1.5m and lead up to 50m as per technical specification clause 302.3

Laying brick soling layer on prepared sub-grade with brick on edging according to lines, graded and cross-section shown on the drawing filling joints with sand and earth, spreading 25 mm thick layer of earth over brick soling, watering and rolliing as per Technical Specification Clause 412 As BRICK EDGING

Laying brick soling layer on prepared sub-grade with brick on edging according to lines, graded and cross-section shown on the drawing filling joints with sand and earth, spreading 25 mm thick layer of earth over brick soling, watering and rolling as per Technical Specification Clause 412 AS brick edging

Providing and applying tack coat with bitumen emulsion SS-1 on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.00 kg/sqm using mechanical means as per Technical Specification Clause 502.

Providing, laying and rolling of open graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 (13.2mm & 11.20mm in 2:1) mm aggregates either using penetration grade bitumen VG-10 to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kN static roller capacity, finished to required level and grades to be followed by seal coat of Type C as per Technical Specification Clause 508.

Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using Type C as per Technical Specification Clause 510

Providing and laying reinforced cement concrete pipe NP-3 for culverts on first class bedding of granular material in single row incluginf fixing collar with cement mortar 1:2 but excluding excavation, protection works, backfilling, concrete and masonary work. 450 mm NP3 grade pipe

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,

Supply and fixing of sign board