Directorate Of Urban Local Bodies Tender

Excavating, supplying and filling of local earth (including royalty) by mechanical transport upto a lead of Skm also including ramming and watering of the earth In layers not exceeding 20 cm in trenches, plinth, sides of foundation etc. complete.

Presiding and laying in position ready mixed or site batched design mix cement concrete for plain cement concrete work: using coarse aggregate and fine aggregate dens ed from natural sources. Portland Pozzolana/Ordinary Portland /Portland Slag cement. admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting 9103 to accelerate / retard setting of concrete. to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curiag, carriage for all leads: but excluding the cost of centering. shuttering and finishing as per direction of the engineer-in-charge; for the following grades of concrete. Note: Extra cement up to minimum specified cement content in design mix shall be payable separately. In case the cement content in design mix is more than 110% of the minimum specified cement content, the contractor shall have discretion to either re-design the mix or bear the cost of extra cement

Presiding and laying in position ready mixed or site batched design mix cement concrete for plain cement concrete work: using coarse aggregate and fine aggregate dens ed from natural sources. Portland Pozzolana/Ordinary Portland /Portland Slag cement. admixtures in recommended proportions as per IS: 9103 to accelerate / retard setting 9103 to accelerate / retard setting of concrete. to improve durability and workability without impairing strength; including pumping of concrete to site of laying, curiag, carriage for all leads: but excluding the cost of centering. shuttering and finishing as per direction of the engineer-in-charge; for the following grades of concrete. Foundation

Same as item no, 4 but Allworks above plinth & up 10 floor V level Beam

Same as item no, 4 but Allworks above plinth & up 10 floor V level Column

Same as item no, 4 but Allworks above plinth & up 10 floor V level Slab

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in:Cement mortar 1:4 (1 cement :4 coarse sand) With F.P.S.(non modular) bricks

Brick work with common burnt clay machine moulded perforated bricks of class designation 12.5 conforming to IS:2222 in superstructure above plinth level up to floor five level in cement mortar 1:6 (1 cement : 6 coarse sand) :With F.P.S.(non modular) bricks.

Painting top of roofs with bitumen of approved quality @ 17kg per 10 sqm impregnated with a coat of coarse sand at 60 cudm per 16 sqm, Including•cleanIng the slab surface with brushes and finally with a piece of cloth lightly soaked In kerosene oil complete With residual type petroleum bitumen of grade VG - 10

Treatment of soil under existing floors using chemical emul @ one litre per hole, 300 mm apart Including drilling 12 mm diameter holes and plugging with cement mortar 1 :2 (1 cement : 2 Coarse sand) to match the existing floor: With Chlorpyriphos/ Lindane E.G. 20% with 1% concentration

Steel reinforcement for R.C.C. work ready to use "cut and bend" rebars of approved make from factory/workshop to construction site including placing in position and binding all complete .Thermo-Mechanically Treated bars of grade Fe-500D or more

Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength conforming to IS: 4454 - part 1 and M.S. top cover of required thickness for rolling shutters.80x1.25 mm M.S. laths with 1.25 mm thick top cover

Providing and laying "brick coba" 12 min thick laid with M- 150 class brick bat cobs 7.50 cm thick with gap of 15 mm to 20 mm thick base of cement mortar 1:4 cement and coarse sand mixed with water proofing compound spreading cement slurry mixed with aerelic cement concrete water proofing compound filled gaps of cobs & top of coba mortar mixed with water proofing compound in and coarse sand mortar finished smooth & top mashed false square 30 x 30 cm and side wall parapet shall be monottythic plaster wall upto 30 cm higher and junction and corner shall be rounded by brick ballast cement and coarse sand masonaiy coba with lop finished plister mixedWith acetic water proofing compound @ 2% b) weight & including S/o all material,labour, T&P etc complete for proper completion of work.

12 mm cement plaster on rough side of single or half brick wall of mix: 1:6 (1 cement: 6 coarse Sand)

12 mm cement plaster on rough side of single or half brick wall of mix: 1:3 (1 cement: 3 coarse Sand)

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade Two or more coats on new work over an under coat of suitable shade with ordinary paint of approved brand and manufacture

Finishing walls with textured exterior paint of required shade :Old work (Two or more coats on existing cement paint surface @ 3.28 Itr/10 sqm.

Painting two coats over priming coat on Steel & other metal surfaces up to 10 cm width,oriq,mi in areas with superior synthetic enamel such•ag Luxo1-3 lii-gloss apcolile superlac,Dulux specified-finishing to give an even shade & incl.cleani.p.the surface of all dirt, dust & other foreighn matter saned preparing and knotting incl. cost of all etc. required for proper completion of work.

C/O APRON DRAIN