Harish Chandra Research Institute Tender

Providing and fixing 6 liver Dead lock

Providing and fixing ISI marked aluminium butt hinges anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with necessary screws etc. complete 125x75x4 mm

Providing and fixing aluminium tower bolts, ISI marked, anodised (anodic coating not less than grade AC 10 as per IS : 1868 ) transparent or dyed to required colour or shade, with necessary screws etc. complete 150x10 mm

Aluminium Handle 125 mm

Providing and fixing aluminium extruded section body tubular type universal hydraulic door closer (having brand logo with ISI, IS : 3564, embossed on the body, door weight upto 36 kg to 80 kg and door width from 701 mm to

Providing and fixing in position 4 mm tk. Anti Scratch acrylic sheet for celling with aluminium framing as per requirement and direction of Engineer- in - Charge .(Cost of aluminium snap beading shall be paid in basic item )

Mirror : Providing and fixing full length mirror 6mm thick of Saint Gobain make above counter using 25 mm Stainless steel 304 grade studs fixed to walls with SS 304 grade spacers on 25 mm with spacers installed on all 4 corners of mirror of smaller sizes upto 600 mm wide & additional studs fixed at every 1000 mm at to & bottom for larger sizes. the glass shall be bevelled on the perimeter all around for a distance of 25 mm. the rates quoted are complete in all respects including fixing of studs, rawl plug, holes in glass bevelling etc complet in all respects.

Providing and fixing fully automatic "NO TOUCH" die cast aluminium, epoxy coated hand drier of ess ess/ jaquar/ grohe make suitable to operate on 220 volts, single phase 50 hz motor rating 100W, 2850 rpm automatic infrared sensing device, 1600W heating element approximate 275 cum/hr air flow wind velocity 15.5 m/sec. AC power supply.

PProviding & fixing 12 mm tk. toughened glass partitions of 4'x 2' each in toilets to be used as urinal partitions fixed in place using sevax fittings as per detailed drg T3

Providing and fixing factory made 30 mm thick door shutter made of solid PVC foam profile. The styles & rails shall be of size 75 mm x 30 mm having wall thickness 5 mm. The styles, top & bottom rails shall have one side wall thickness of 15 mm integrally extruded on the hinge side of the profile for better screw holding power. The styles and rails shall be reinforced with M.S. tubes of size 33 mm x 17 mmx 1 mm, painted with primer , all four corners of reinforcement to be welded or sealed. Solid PVC extruded bidding (push fit type) will be set inside the styles and the rails with a cavity, to receive single piece extruded 5mm C sheet as panel. The styles and rails will be mitred cut and joint with the help of PVC solvent cement & self driven self tapping screws. Single piece extruded solid PVC lock rail of size 100 mm x 30 mm with wall thickness 5 mm & 15 mm integrally extruded in the middle of the lock rail & fixed with styles with the help of PVC solvent cement & self driven self tapping screws of size 100mm x 8 mm complete as per manufacturer's specifications and direction of Engineer-in-charge.