Directorate Of Urban Local Bodies Tender

Cement concrete with 4.0cm gauge brick ballast fine sand of 1.25 F.M and Cement, in proportion of 12:6:1 in Foundation and under floors, including supply of all materials, labour, T&P, etc. required for proper completion of the work etc. (SI.No. 273)

M-150 Brick work in one cement & Four Fine sand (1:4) mortar in foundation and plinth including supply of all materials, labour, T&P, etc. required for proper completion of work as per direction of Engineer-in-charge. SI. No. 305

12 mm thick plaster with cement and fine sand of 1:25 fineness modules in 1:4 over brick work minimum thickness not to be less than 1 cm. including supply of all materials labour t & p etc. (Sl. 584).

Cement concrete with 2.0cm gauge approved stone grit coarse sand and cement in the proportion of 4:2:1 on top of wall & floors etc. including supply of all materials, labour, T&P, etc. required for proper completion of work as per direction of Engineer-in-charge. SI No. 279a

Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per disign, over a prepared sub base with 43 grade cement or any other type as per Clause 1501.2.2 (1:1.5:3) coarse and fine aggregates confirming to IS 383 maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less then 0.2 cum capacity and appropriate weight batcher using approved mix design, laid in approved fixed side form work (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with hovels. rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints as per norms, applying debonding strips primer, sealant, dowel bars, near approaches to bridge/ culvert and construction, joints, admixtures as approved, curing of concrete slabs for 14-days, curing compound (Where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 including Cost of Polythene Sheet and Dowel bar and also including complete shifting of matrials & Concrete etc.(M-20)

Supply and fixing of sign board. (SI No. New Item 2(i) Ch. 27)