Agra Development Authority Tender

Supply and laying IP 67 LED STRIP 5w as per approved design and drawing as approved by architect and Engineer-in-charge. Make - (Vak /phillips / eveready)

Electrical work for Control Room.

CABLES Supply and laying of aluminium conductor PVC insulatedarmoured served sheathed cables 1100 Volts grade at a depth of 750 mm below ground level over a cushionof 75 mm. thick sand all around and protected with burnt bricks on sides and on top. On surface the cable run shall be fixed on M.S. clamps etc. of suitable size or as directed by the Engineer-Incharge,complete in all respect. The armouring of the cable shall be properly connected with the earth conductor by clamps etc. 6 sq. mm 2 core

4 sq. mm 3 core

4 sq. mm 4 core

6 sq. mm 4 core

10 sq. mm 4 core

16 sq. mm 4 core

25 sq. mm 3-1/2 core

35 sq. mm 3-1/2 core

Supply and fixingof brass nickleplated compressiongland for PVC insulated& armoured served sheathed, undergroundcable including rubber ring etc. complete in all respect. The armouringof the cable shall be properly connected with the earth as per direction of Engineer-Incharge. 6 sq. mm 2 core

4 sq. mm 3 core

4 sq. mm 4 core

6 sq. mm 4 core

10 sq. mm 4 core

16 sq. mm 4 core

25 sq. mm 3-1/2 core

35 sq. mm 3-1/2 core

Supply and installation of MS Smart Pole of height 12m, ms thickness 8mm, dia 273mm with junction box IP65 including the cost of foundation, foundation bolts, excavation & back filling bearing the windspeed of 200km/hr and required T&P complete in all respect as per approved design and drawing as approved by architect and Engineer-in-charge. (without telecom cabinet, housing (SPECIFICATIONS AS PER ANNEXURE) (Complete with all accessories) Make Vak /hillips / eveready.

Water Screen With Laser Show & video Duration of Multimedia laser Show - 30 Minute Supply , Installation , testing and commissioning - laser spectrum DT50/DT50 Scanner in 12W laser machine Lasers - 12 watts Laser The laser spectrum 12 show laser projector is a pure diode solution with analog color modulation and a guaranteed output power of 11'700 mW.The projector has good specifications with a beam diameter of ca. 4.5 mm and a beam divergence of less than 0.9 mrad (full angle). It is equipped with a red (3'700 mW / 637 nm), a green (2'900 mW / 520 nm), and a blue (6'000 mW / 450 nm) diode laser source. The tarm 12 devices have very fast scanners, running at 45 kpps@8° ILDA and scanning a maximum scan angle of 50° (@30 kpps).

Design, supply , installation & commissioning of Supply and installation of LCD projector ( PT - DZ870U)Having intergrating seamlessly to produce a continous show/ spectable ( Epson / Hitachi / Panosonic ) ( AOR)

S/F of Water Screen ( 27M x 9M ) Bass/ SS ( Including desigining fabrication and require Fitting ) ( AOR)

S/F OF 25 HP Open well Submersible pump three phase Make - Crompton ( AOR)

S/F Of Submersible Flat Cable 10 MM x 3 Core - Copper ( AOR)

S/F Of four Channel amplifier with AVB connectivity Power per channel ( all channels driven) 1250 W @ 2ohms, 1250 @ 70/100 V Bridged Power 2500 W @ 4 ohms, 2500 W @ 8 ohms , 2500 W @ 16 ohms , 2500 W @ 70/100 V ( AOR)

S/F of Power Speaker 300 Watt ( Ahuja or equivalent ) PSX : 1200 ( AOR)

Speaker Base JBL or equivalent- VRX 918S : 18" bass - reflex subwoofer , frequency range 31HZ 220 HZ - ( 10db) ; SPL 95 db /130 db( max) ; 800 W/1600 W 3200W( cont/prigram/peak) ; 20 ( H) x 23.5 (W) x 29.5(D) in 37kg

MCC Panels (1). Made of 2 mm thick sheet enclosure foot mounted cubicle type epoxy powder coated (Siemens grey). Front doors are hungable & lockable with the body. (2). Degree to protection - P 54 .(3). All cable entry from bottom. (4). All doors and gland plates have spongy rubber gasket. (5). Panels should have the main incoming feeder, bus bar chamber, instrument chamber, pump feeder chamber and cable ally chamber. (a) Main incoming chamber consist of one number rated TP MCCP, (make Schneider L&T, Siemens GE Equivalent). (b) Bus Chamber consisting of rated current 415 V 50 Hz, with heat sink and rated CT (make Kappa/AEE Equivalent.) (c) Instrument Chamber consisting of digital/analogue Ammeter & Voltmeter with selector switches and phase indicator lamp and necessary rated SP MCB (make MDS/GE/Schneider for control circuit.) (d). Every pump feeder consisting of short circuit protection through HRC TPN Main Switch (GE/L&T Siemens/ Schneider) overload protected through thermal overload relay (GE/ Schneider, L&T Siemens), Single phasing protected by single phase preventor (Make MInilect rated star & delta contractors and star delta timer (GE, L&T/Schneider/Siemens) ammeter, voltmeter, selector switches rated CT overload indication & pump ON-OFF push button and necessary rated SP MCB make MDS/GE/Schneider for control circuit. 6) Cable ally consisting of rated terminals (Elmex/Phonix or equivalent )

Power DB (1). Made of 2mm thick sheet steel enclosure, foot mounted cubicle type, epoxy powder coated (Siemens grey) front doors are hangable & lockable with the body. (2). Degree of protection P54. (3). All cable entry from bottom. (4). All doors and gland plates have spongy rubber gasket. (5). Panels should have the main incoming feeder, bus bar chamber, instrument chamber. (a). Main incoming feeder consisting of rated capacity TPNHRC fuse switch combination make Schneider/L&T/Siemens/GE/Equivalent.(b). Bus bar chamber consisting of rated capacity aluminium bus bar with heat sink, rated capacity CT make AEE/Kappa. (c). Instrument chamber consisting of digital/analogue ammeterand voltmeter with selector switch phase indicating lamp and required rated SP MCB make Schneider / L&T / Siemens / GE/ MDS for control circuit.

Design , Supply , installation & commissioning of Sunlite with Computer system and console ( licensed software for lifetime validity to run the complete sho ) controller Rack Consisting of electronic control card interfacung with computer and our above panels converting digital input to analogue output with necessary electrical / electronic safety protection items and necessary rated SP MCM , make MDS / GF / Schneider or equivalent. for control circuit.

Laser Software Software Description LD2000 is a Professional level software uesd for creating the highest quality laser shows on the planet , It is a complete system and comes with the LD2000 software and QM2000 hardware

Synchronizing , of Music with Water pattern ( including Programmer Fee and Programmed Song - 30 Mins

Synchronizing Laser with Software and programming according theme Show - Including programmer fee - 30 Mins

Synchronizing , Video Projector with Software and Programming accoding theme Show 30 Mins

Shooting and Editing Movie accoeding Theme - Including Director Fee , Camaram and Supporting Staff and Studio charges - 30 Mins

Prepared Theme Show Indcluding Director Fee , Voice over and Studio Charges -30 Mins

2 year Operating of Musical fountain with Light and Sound Show with 2 Nos Operators and 1 Nos Helper