Public Works Department Tender

Suppling fitting & placing Thermo Mechanically Treated bar/Cold Twisted deformed bar reinforcement in foundation complete as per drawing & MoRD technical specification clause 1000 & 1202.

Providing concrete for plain concrete (using jhama brick aggregate) in open foundations complete including formwork as per drawings & MoRD technical specifications Clauses 802, 803, 900, 1202 and 1203. (including centering, shuttering, staging etc. but excluding reinforcement) III. P.C.C grade M 20 (using jhama brick aggregate) (i) Nominal mix (1:2:4)

Providing weepwholes in brick masonary/Stone masonary plain/reinforced concrete abutment, wing wall, return wall with 100mm dia AC pipe or PVC pipe ( 110mm OD of 6.0 kg/sqcm pressure ) extendind through the full width of the structures with slope of 1(V), 20(H) towards drawing face complete as per drawing and MoRD technical specification clauses 614, 709, 1204.37

Providing & laying filter media with Jhama brick aggregates as per specification to a thickness of not less than 600 mm with smaller size towards the Soil & bigger size towards the wall & providing over the entire surface behind abutment, wing wall, return wall to the full height, compacted to firm condition complete as per drawing & MoRD technical specification clause 1204.3.8

Construction of Embankment with Material Obtained from Borrow Pits Construction of embankment with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per MoRD Technical Specification Clause 301.5.

80 mm thick factory made c.c. interlocking paver block of M-35 Grade Providing and laying factory made chamfered edge Cement Concrete paver blocks of required strength, thickness & size/ shape, made by table vibratory method to attain superior smooth finish using PU or equivalent moulds, laid in required grey colour & pattern over 50 mm thick compacted bed of sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand in footpath, parks, lawns, drive ways or light traffic parking etc. all complete as per specifications & approval/direction of the Engineer -in-Charge: (a) 80 mm thick c.c. paver block of M-35 grade with approved colour, design and pattern.