Department Of Agriculture Tender

Excavating holes up to 0.5 cum including getting out the excavated soil , then returning the soil as required in layers not exceeding 20 cm in depth , including consolidating each dposited layer by ramming , watering etc , disposing of surplus excavated soil , as directed within a lead of 50 m and lift up to 1.5 m. -All kinds of soil

Filling available excavated earth (excluding rock) in trenches,plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift upto 1.5 m. -All kinds of soil

Supplying and filling in plinth, under floor, foundations etc. with sand (fine) from local quarry with all lifts including spreading in horizontal layers, watering, grading to required slope, ramming, consolidating and compacting each layer by using plate compactor or by any suitable method complete.

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering - -All work upto plinth level: a) 1:4:8 ( 1 Cement: 4 fine sand : 8 graded well burnt brick aggregate 40 mm nominal size)

First class brick work in foundation and plinth including cost of all materials as required complete:- In cement mortar 1:4 ( 1 cement : 4 fine sand ).

Providing and laying in position specified grade of reinforced cement concrete excluding the cost of centring, shuttering, finishing and reinforcement- -All work upto plinth level: 1:11/2:3 ( 1 Cement: 11/2 fine sand : 3 graded stone aggregate 20 mm nominal size)

Reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and skirting courses, fillets, columns, pillars, piers, abutments, posts and struts etc. upto floor five level excluding cost of centring, shuttering, finishing and reinforcement- a) In plinth and skirting courses, fillets, columns, pillars, posts and struts 1:11/2:3 ( 1 Cement: 11/2 fine sand :3 graded stone aggregate 20 mm nominal size)

Centering shuttering including struttings, propping etc. and removal of form work for: a) Foundations, footings, bases for columns etc. for mass concrete with timber plank

c) Columns, Pillars, Piers, Abutments, Posts and Struts with shuttering ply

Reinforcement for R.C.C. work including straightening,cutting, bending, placing in position and binding all complete upto floor five level. Thermo-Mechanically Treated bars/ Cold twisted deformed steel bars.

6 mm cement plaster of mix In cement mortar 1:3 ( 1 cement : 3 fine sand ).

Providing steel structural steel work riveted ,volted or wellded in built up sections , trusses and framed work , including cutting , hoisting , fixing in position and applying a priming coat of approved steel primer all complete as required.

Providing and fixing 1.8 m high GI barbed wire fencing with 2.4 m RCC M15 grade 150 mm x 150 mm concrete post placed every 3 m centre-to-centre founded in M15 grade cement concrete, 0.6 m below ground level, every 15th post, last but one end post and corner post shall be strutted on both sides and end post on one side only and provided with 12 horizontal lines and 2 diagonals interwoven with horizontal wires, fixed with GI staples, turn buckles etc. complete as per MoRD technical specification Clause 1705

Finishing walls with acrylic smooth exterior paint of required shade of approved brand and manufacture on new work ( two or more coats applied @ 1.67 kg/10 sqm) over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm complete(payment shall be made after submission of test certificate issued by manufacturer). New work (two or more coats applied @ 1.67 litre/10sqm over and including priming coat of exterior primer applied @ 2.2 kg/10 sqm)

Painting with synthetic enamel paint ( two or more coats) of required colour of approved brand and manufacture on new work to give an even shade.(Payment shall be made after submission of test certificate issued by the manufacturer)

Compacting original ground supporting sub grade loosening of the ground up to a level of 300 mm below the subgrade level, watered, graded and compacted in layers to meet requirement of table 300.1 and 300.2 for subgrade construction as per MoRD technical specification clause 303.5.2

80 mm thick factory made c.c. interlocking paver block of M-35 Grade Providing and laying factory made chamfered edge Cement Concrete paver blocks of required strength, thickness & size/ shape, made by table vibratory method to attain superior smooth finish using PU or equivalent moulds, laid in required grey colour & pattern over 50 mm thick compacted bed of sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand in footpath, parks, lawns, drive ways or light traffic parking etc. all complete as per specifications & approval/ direction of the Engineer -in-Charge:- (a) 80 mm thick c.c. paver block of M-35 grade with approved colour, design and pattern

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means over areas (exceeding 30cm in depth, 1.5m in width as well as 10 sqm on plan) including disposal of excavated earth, lead upto 50m and lift upto 1.5m, disposed earth to be levelled and neatly dressed. -All kinds of soil