Tribal Welfare Engineering Department Tender

BILL OF QUANTITIES;Supply, Transportation of energy efficient fan, 1200mm sweep, alluminium body, consuming 28W, BEE 5 Star rated, ceiling fan with Brush Less Direct Current (BLDC) Motor, class of insulation : B, 3 Nos, blades, 30 cm long down rod, 2 Nos canopies, shackle kit, safety rope, copper winding, Power Factory greater than 0.90, Service Value (CMMAV) greater than 8.5, Air delivery minimum 235 CMM, 350 RPM (tolerance as per IS:374-2019(, THD less than 10% with remote or compatibl to electronic step type regulator unit for speed control and all remaining accessories including safety pin, nut b olts, washers temperature rise = 75 degree C (max), insulation resistance moe than 2 mega ohm, suitable for 230V, 50 HZ, single phase AC Supply, earthing etc., including all standard accessories etc., complete for finished item of work Makes : Atomberg (Efficio)/Havells Orient

BILL OF QUANTITIES;Supplying and wiring with 2 runs of 14/0.3m (1.00 Sq.mm) FRLS / HFFR P.V.C. insulated ISI Copper Cable GM/L&T/RPG/Havells/V-Guard/Power Flex/Polycab/Gold Medal/ Standard /Milion/ Vimal/ Suncab/ Paragaon/FortuneArt make in the existing metallic / non-metallic conduct pipe with 6A 1 Way flush type switch, Ceiling rose and 3mm thick hylam sheet covering to switch control box including cost and conveyance of all materials to site, labour charges and sales tax etc. complete for finished item of work for light, bell, fan and exhaust fan points in Non-Residential Buildings

BILL OF QUANTITIES;Supply and fixing of ISI mark 25mm dia 2.20mm thick PVC conduit pipe Sudhakar / GM/AKG/VIP / Modi make concealed in wall with all required acessories including No.14 SWG GI wire for earth continuity including chiseling the wall wherever necessary , including necessary masonery work for light/fan pointand seperate plug point with M.S deep box including cost and conveyance of all materials to site and labour charges, sales tax etc., complete for finished item of work.

BILL OF QUANTITIES;Supplying & Fixing Orissa Pan 580 mm x 440 mm white glazed W.C 1st quality ISI marked conforming to IS:2556-Part-3-1981 with "P" or "S" trap Hindware/ Parryware/ Neycer - ISI mark 580 mm x 440mm as approved by the Engineer-in-charge fixed in brick masonry with necessary ?S? trap of water closet, shall be encased in C.C. (1:2:4) 6" alround well above the joint, to stop leakage at the joint, cost & conveyance of all materials and labour charges etc., including sales and other taxes on all materials complete for finished item of work for all floors.

BILL OF QUANTITIES;Providing and placing on terrace (at all floor levels)polyetheylene water storage tank with double layer approved brand and manufacture with cover and suitable locking arrangement and making necessary holes for inlet and outlets and over flow pipes but without fittings and base support for tanks including cost and conveyance of all materials and labour charges , Overheads & Contractors profit complete for finished item of work.

BILL OF QUANTITIES;Supplying and fixing of Single Socket 110mm diaPVC/SWR pipe - 4 Kg/sq.cm and fixing all special such as plain bends, off sets, door bends, single junctions, double junctions as per site requirement, fixing with PVC clamps if necessary with required number of nails including cost and conveyance of pipe to site, labour charges, complete for finished item of work.

BILL OF QUANTITIES;Supply and fixing of astral Flow guard or equivalent CPVC pipes and fitting to meet therequirement of ASTM-D 2846 and are produced in CTS (Copper tube sizes)1/2" to 2"Ashirvad flow guard SDR 11 SDR 13.5 pipes are made from idential CPVC compounds having the smae physical properties for Hot and Cold water (IS 15778:2007) 22.20 mm dia OD

BILL OF QUANTITIES;Supply and fixing of astral Flow guard or equivalent CPVC pipes and fitting to meet therequirement of ASTM-D 2846 and are produced in CTS (Copper tube sizes)1/2" to 2"Ashirvad flow guard SDR 11 SDR 13.5 pipes are made from idential CPVC compounds having the smae physical properties for Hot and Cold water (IS 15778:2007) 28.60 mm dia OD

BILL OF QUANTITIES;Supplying & Fixing of 15 mm brass body CP finish bib tap of not less than 300 grams weight screw type (full turn) with internal / external threaded connection conforming to IS 8931 including cost and conveyance of all materials to site, all labour charges, sales and other taxes on all materials etc., complete for finished item of work for All Floors.

BILL OF QUANTITIES;Nominal diameter of standard 42/32mm UPVC pipe with standing up to 20 Kgs/CM2 upto 200 Mts (Elec-5.11.1 a)

BILL OF QUANTITIES;Constructing 457.2mm x 457.2mm ( 1'-6" x 1'-6") brick in CM (1:6) prop. Masonry inspection chamber upto 914.4mm (3'-0") and fitted with light weight 457.2mm x 457.2mm ( 1'-6" x 1'-6") C.I. frame and cover of 20Kg. including cost and conveyance of all materials to site, all labour charges, sales and other taxes on all materials etc., complete for finished item of work.

BILL OF QUANTITIES;Constructing 904.0 mm (3?0?) dia brick masonry inspection chamber as per IS - 4111: Part-1:1986 with cement mortar (1:6) prop using 2nd Class Clay Bricks of 225 mm thick from approved source having a minimum crushing strength of 5 N/sq.mm including plastering with cement mortar 1:3 prop; ½? thick both inside and outside fitted with 20? dia RCC manhole covers and frames including excavating pits up to a depth of 904 mm (3'-0") in all sorts of soils (exculding rock) and laying cement conrete (1:4:8) 150 mm thick using 40 mm HBG Metal and P.C.C. 1:2:4 benching and channel 100 mm thick as per Standard specification and including cost and conveyance of all materials like cement, sand/rock sand (50:50), bricks, water etc., to site, cost of on all materials and all incidental and operational, labour charges like mixing cement mortar, constructing masonry, lift charges, curing , Overheads & Contractors profit etc., complete for finished item of work as per Standard specification.

BILL OF QUANTITIES;Painting to Old External Walls with two coats of Polymer Plastic Emulsion paint of Asian / Berger / Nerolac / Saicoat / Endocem or equalent quality of approved brand and shade as approved by the Engineer - in - Charge over base coat of cement primer water base grade -II exterior making three coats in all to give an even shade after thoroughly brushing the surface to remove all loose powdered materials, including cost and conveyance of all materials, including cost and conveyance of all materials, cost of brushes, water to site, etc., sales & other taxes, all operational, incidental and labour charges such as scaffolding charges, lift charges, curing etc., complete for finished item of work in all floors for external Walls.(APSS No. 911)

BILL OF QUANTITIES;Painting to Old internal walls with two (2) coats of ready mixed oil bound washable distemper acrylic base of approved brand and shade over a base coat of cement primer water base interior Grade-I of approved brand, makind three (3) coats in all to give an even shade after thourughly brushing the surface to remove all dirt and remains of loose powdered materials, including cost and conveyance of all materials to work site and all operational, incidental, labour charges etc., complete for finished item of work in all floors for internal walls (SS 911)

BILL OF QUANTITIES;Providing Galvanized Iron fly proof wire mesh of not less than 20 gauge with Teak Wood Styles & rails of size 50mm x 50mm including cost and conveyance of all materials, accessories, labour charges for transportation, erection at site complete for finished item of work.

BILL OF QUANTITIES;Supply and fixing of Salwood fully pannelled window 0.90 x 1.20 M frame of size 100 mm x 75 mm thick shutters (two leaf) frame of 100 x 35 mm four styles of 1.05m length and railes of 100 x 35 mm of 0.38m length, Salwood planks 35mm thick, two Handles 75mm, Hinges 100mm long 4 No's, Tower bolts of 100mm length 4 No's, including wrought and put up and labour charges etc., complete for finished item of work.

BILL OF QUANTITIES;Providing and fixing factory made solid Wood Polymer Composite (WPC) single extruded Door Frame section of 100*65 MM with encapsulation of 6 MM rigid layer on all external surfaces. The door frame will have a rebate of 32MM/ 37 MM. The two Vertical members are to be joined together with the horizontal member using 8x75 MM long MS Star full thread screws to be used with reverse forward speed control hand drilling machine. The ready/assembled door frame is fixed to wall using Z Hand fast 300 MM long hold fast

BILL OF QUANTITIES;Providing and fixing 30mm thick Solid panel PVC door shutter consisting of frame made out of M.S. tubes of 19 gauge thickness and size of 19mm x 19mm for stiles, & 15mm x 15mm for top & bottom rails. M.S. frame shall have a coat of steel primers of approved make and manufacture. M.S. frame shall be covered with 5mm thick heat moulded PVC ?C? channel of size 30 x 50mm forming stiles, and 5mm thick, 75mm wide PVC sheets for top rail, lock rail & bottom rail on either side, and 10mm (5mm x 2) thick, 20mm wide cross PVC sheet as gap insert for top rail & bottom rail. Panelling of 10mm thick PVC sheet to be fitted in the M.S. frame welded / sealed to the stiles & rails with 30mm wide x 5mm thick PVC sheet beading on either side, and joined together with solvent cement adhesive etc. An additional 5mm thick PVC strip of 20mm width is to be stuck on the interior side of the ?C? Channel using PVC solvent adhesive. Complete as per direction of Engineer-in-charge, manufacturer?s specification & drawing for finished item of work .

BILL OF QUANTITIES;Supplying & fixing of 1.22x 2.13 Mts. (Double Leaf) Door frame made of roll formed section of 1.25 mm thick CRCA section, size should be 50 x 47 mm with 32 mm rebate. The corner of the frame should be welded. The frame should be painted with one coat of primer and finished painted with pure polyester paint. The frame should be provided with approved quality M.S.Powder coated butt hinges IS 205 125mm long of 6 Nos. along with Double flush door shutters solid bond wood block board type with commercial ply on both faces of 30mm thick including fixtures such as Mild Steel "Z" type Hold Fasts 6 Nos., M.S.Powder coated tower bolts I.S. 204, 300 mm long and 10mm BOLT dia 2Nos, M.S.Powder coated handles IS 208 125mm long 4No, M.S.Powder coated Aldrop IS 2681 300mm long 1No., M.S.Powder coated Door Stoper 2No., sales and other taxes cost and conveyance of all materials to site, all labour cahrges such as making of door frame, fixing in position,fixing of shutters, & hard ware fixtures, etc.,complete for finished item of work. The frame should be embedded to a depth of 40mm in the flooring.

BILL OF QUANTITIES;Providing impervious coat to exposed RCC roof slab surface with CM(1:3), 20mm thick with 1kg of water proof compound per bag of cement laid over roof when it is green including cost of all materials, , excluding conveyance charges of materials and including all operational, incidental and labour charges for mixing mortar, laying, rendering smooth and thread lining, curing, rounding off junctions of wall and slab etc,, complete for finished item of work for Ground Floor

BILL OF QUANTITIES;Providing Skirting to internal walls to 15 cm height and risers of steps with soluble salt porcelain vitrified tiles screen printed and polished of size 600 x 600 mm and thickness between 8-10 mm 1st quality conforming to IS:13711, IS:13712, IS:13630 (Parts 1 to 15) of any colour and finish of make Jhonson & Jhonson, Kajaria, Nitco, Marbonite, set over base coat of CM (1:5) 12 mm thick with cement slurry of honey like consistency spread at the rate of 3.30 kgs per sqm and jointed with white cement paste mixed with pigment of matching shade to full depth, including cost of all materials like tiles, cement, sand/rock sand (50:50) and water etc., complete , etc., complete for finished item of work for Ground Floor

BILL OF QUANTITIES;Flooring with soluble salt porcelain vitrified tiles screen printed and polished of size 600 x 600 mm and thickness between 8-10 mm 1st quality conforming to IS:13711, IS:13712, IS:13630 (Parts 1 to 15) of any colour and finish in all shades and designs of make Jhonson & Jhonson, Kajaria, Nitco, Marbonite, set over base coat of cement mortar (1:8), 12 mm thick over CC bed already laid or RCC roof slab, including neat cement slurry of honey like consistency spread @ 3.3.kgs per sqm & jointed neatly with white cement paste to full depth mixed with pigment of matching shade, including cost of all materials like cement, sand/rock sand (50:50) water and tiles etc., complete, , etc., complete for finished item of work for Ground Floor

BILL OF QUANTITIES;Removing of Existing Plastering (TBSC-U.I-08)

BILL OF QUANTITIES;Plastering 12mm thick in two coats with base coat of 8mm thick in CM (1:5) and top coat of 4mm thick in CM (1:3) dubara sponge finish including cost and conveyance of all materials like cement, sand/rock sand (50:50), water etc., to site, , sales & other taxes on all materials,all operational, incidental and labour charges such as mixing mortar, scaffolding charges, lift charges, including cutting of Grooves wherever necessary as directed by Engineer - in - charge, finishing, curing, etc., for Even Surfaces of brick wall complete for finished item of work. (APSS 901,903 & 904) for Ground Floor