Telangana State Education Women And Infrastructure Development Corporation Tender

Supplying and fixing of Unplasticised Poly VinylChloride (UPVC) 2 Track–2 Panel Sliding Doors duly manufactured using UPVC reinforcedprofiles(Composition of profile shall consists minimum of 5.5 PHR of TiO2 and not more than12 PHR of CaCo3 for every 100 parts of PVC resin) of 60 mm x 45 mm x 2.20 mm withreinforcement of 1.2 mm thickness, super sash with overall size of 39 mm x 75 mm x 2.20 mmwith for sliding door shutter frames capable of mounting single glazing system, structurallyreinforced with hot dip galvanized up to 50 microns of minimum thickness of 1.5 mmprefabricated & welded through fusion welding the door sash shall be fitted with 6 mm thickclear float glass of reputed make duly fixed with Grey colour TPV Gasket for sash & Glazing beadshall be co-extruded with Grey colour soft PVC. Door shall be provided with standard hardware& multi point locking system of bent handle espagulate .the system is to be installed at thesite using anchor fasteners, silicon rubber sealant, easy glazing/ deglazing at site etc.,including cost and conveyance of all materials, 1 Sqm 5669.00.

Providing and fixing 30mm thick Solid panel PVC door shutter consisting of frame made out of M.S. tubes of 19 gauge thickness and size of 19mm x 19mm for stiles, & 15mm x 15mm for top & bottom rails. M.S. frame shall have a coat of steel primers of approved make and manufacture. M.S. frame shall be covered with 5mm thick heat moulded PVC ‘C’ channel of size 30 x 50mm forming stiles, and 5mm thick, 75mm wide PVC sheets for top rail, lock rail & bottom rail on either side, and 10mm (5mm x 2) thick, 20mm wide cross PVC sheet as gap insert for top rail & bottom rail. Panelling of 10mm thick PVC sheet to be fitted in the M.S. frame welded / sealed to the stiles & rails with 30mm wide x 5mm thick PVC sheet beading on either side, and joined together with solvent cement adhesive etc. An additional 5mm thick PVC strip of 20mm width is to be stuck on the interior side of the ‘C’ Channel using PVC solvent adhesive. Complete as per direction of Engineer-in-charge, manufacturer’s specification & drawing for finished item of work .

Providing and placing on terrace (at all floor levels) polyetheylene water storage tank with double layer approved brand and manufacture with cover and suitable locking arrangement and making necessary holes for inlet and outlets and over flow pipes but without fittings and base support for tanks including cost and conveyance of all materials and labour charges for placing and fixing in position as directed by Engineer-in-Charge.