Police Housing Corporation Limited Tender

For getting the details of etenders, if you are looking for information about them from the cumbersome government websites but are tired of doing so, Bidassist comes up with a one stop solution. It collates every Eproc telangana tender on Bidassist. One can approach it for the bidding process, registration process, etc., are explained below.

Police Housing Corporation Limited Tender

Opening Date23 Sep 2019
Closing Date30 Sep 2019
Tender Amount₹ 50,63,469 
This is an estimated amount, exact amount may vary.
Notes
Download

Description

Unlock the Tender details for free
Scription for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user this is tender description for unregistered user

Contact

Unlock the Tender details for free
GEM & Bid Advisory Services
Get portal registration, tender bidding, product/service listing or vendor/MSME certification services at a nominal cost

BOQ Items

... More
DO_NOT_SHOW

-

-

-

View all details for FREE
... More
Supply and Installation of 8.3 TR Capacity DUCTABLE type indoor units comprising with pre-filter, fan section with low noise fan multi speed motor, coil section with DX coil, outer cabinet, drain water lift-up meachanism, insulation, pipe connections, fresh air intake etc. of various capacities with refnet joint with CORDED REMOTE CONTROLER. Make: O General/Daikin/Toshibha.

5

-

137120

... More
Supply, Installation, Testing and Commissioning of initial Charge of refrigerant gas - R 410 A.

1

-

73960.71

... More
Pressure testing of the entrire system with Nitrogen and vaccumizing the nitrogen.

1

-

28762.5

... More
Supply and installation of suction & discharge Hard copper Refrigerant piping with proper supports / hangers from ceiling / wall as required at site & approved by consultant & duly insulated with closed cell elastomeric nitrile insulation of 19mm thick for pipes above 1" and 13 mm thick for pipes below 1". 34.90 mm 28.60 mm 22.10 mm 19.10 mm 15.90 mm 12.70 mm 9.50 mm 6.40 mm

50

-

1685.71

... More
Supply and Laying of Control cable laying connecting the IDUs and ODUs (control wiring using 2C X 1.0 Sq.mm copper cable) 25mm dia PVC FRLS heavy duty conduit PVC pipe etc., complete. Cable Make: Polycab/Power flex. PVC Pipe make: Sudhakar (ISI Mark)

90

-

147.5

... More
Supply and Laying of Remote cabling of 2Cx0.75 Sqmm between each IDU & its wired remote sensor to be suitably laid in PVC conduit as per site requirment etc., complete. Cable Make: Polycab/Power flex. PVC Pipe make: Sudhakar (ISI Mark).

20

-

131.7

... More
Supply and Erection of 32mm Dia PVC hard condenseated drain piping with 9mm thick Nitrile insulated including supprot and wall opening of the following sizes etc. Complete. Make: Sudhakar/Modi/Precision (ISI mark).

30

-

141.18

... More
Supply and Erection of 25mm Dia PVC hard condenseated drain piping with 9mm thick Nitrile insulated including supprot and wall opening of the following sizes etc. Complete. Make: Sudhakar/Modi/Precision (ISI mark).

20

-

126.43

... More
Supply and Erection of factory fabricated G.I. Ducting of 22 Guage size duct with hitect supports.

75

-

1064.11

... More
Supply and Erection of factory fabricated G.I. Ducting of 24 Guage size duct with hitect supports.

175

-

916.61

... More
Supply and Erection of Acoustic insulation inside the duct with 12 mm thick Fiber Glass wool with RP Tissue covered with 26G Al perforated sheet.

50

-

695.36

... More
Supply, Laying and Commissioning of Thermal insulation of ducting with 13 mm thick class O NITRILE RUBBER.

220

-

532.05

... More
Supply, Erection and Commissioning of supply air jet diffuser with butterfly damper size of 315mm Dia etc., complete.

25

-

3266.07

... More
Supply, Erection and Commissioning of Powder coated extruded aluminum return air grille without collar damper etc., complete.

8

-

5900

... More
Supply, Installation and Testing of Canvas connection etc., complete.

5

-

2950

... More
Supply and erection of M.S. angle stand for installation of VRV outdoor units.

5

-

8744.64

... More
Installation and Fixing of 4.0 TR Cassette type Indoor Unit VRF Indoor Units including Cost and Conveyance of Labour charges etc..complete

18

-

3476.62

... More
Providing 2 runs of Copper tubes for suction and liquid between indoor and outdoor unit for split/Casseete Air-Conditioner including foaming etc., complete. 1.3/4" x 3/8"

250

-

978.91

... More
Supply of run of PVC insulated 4 core 2.5Sqmm sheathed flexible copper cable for voltage up to 1100V as per IS 694/1990 of Make: Polycab / Finolex / Powerflex.

250

-

164.83

... More
Supply, Fabrication of 1set MS bracket suitable for fixing out door unit of cassette AC unit / ductable AC Unit complete for finished item of work.

18

-

1854.2



Evaluation Notes How It Works ?

Potential Partner

Select Your Requirements
Disclaimer: BidAssist has made every reasonable effort to ensure that the information is accurate and authentic however it cannot be held liable for any third-party claims or losses of any damages. BidAssist makes no warranty, expressed or implied, as to the results obtained from the use of the information. If you think you may have noticed any error or omission, please let us know by contacting contact@bidassist.com.