Roads And Buildings Department Tender

RSI;Supply and Application of Thermo-plastic Road Marking Compound-2.5mm thick. Supplying of hot applied thermpolastic road marking compound, 5mm thick including reflectorising glass beads @ 250gms with Reflectorising Glass Beads on bituminous surface at 250gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass bead as per MORT&H Section 803.4 and IRC:35-2015, the material should satisfy the requirements as per MORTH Specifications 803.4 and must comply with the following: a) White index for the product should be in the range of 60-70 whem measured against standard reference. The applied panel 7/8 number must be submitted for checking up the white index in the department lab. In case the department approved the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. In case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consignment of the said material and will compell the vendor has to replace the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loose of man days(as per the rules of the department). b).Luminance factor of the material should be in the range of 80-85% at 45 degree centigrade as per AASTHOM 249. c).Crack resistance: The applied panel curred for 7 days under ambient condition and then should be tested as per BS3262, Part-1, 1989 and should pass at the range of '0' degree centigrade to '-10' degree centigrade D) Adhesion:Strong E) Softening point :102 degree centigrade F) Dried film finish: smooth and uniform G) Night Vision: High as directed by the Engineer-in-Charge and confirming to IS: 164-1961(1st revision reffirmed in 1986) and clause conforming to IRC 35-2015 and MORTH Section 803.4

RSI;Supply and fixing of Speed Breakers that are highly resistant to severe impacts of size 350mmx250mmx50mm made of sturdy plastic speed breakers are highly resistance to serve impacts and harsh weather conditions its interlocking subunits make it bind perfectly into a one firm bump. The precoloured material (Black and yeallow) and UV Stabiliers keep them prepetually colourful studded with reflectors on either side so that they are clearly visible to the motorists at night hours (Approved Rates).

RSI;Providing & fixing Hazard Markers 300x900mm Reflectorized Panel(Type XI) Supply and installation of Hazard Markers/Delinators using M.S. angle of size 55x55x6mm and 120cm high above ground level painted with two coats of black and white stripes of 15cm wide with first quality synthetic enamel paint over one coat of appropriate primer of approved brand, colour, with 30cmx90cm Type-XI of ASTMD 4956-09 wide angle cube cornered micro prismatic Retro reflective sheeting of Yellow colour and confirming to IRC 67:2012 fixed over 3MM alluminium composite material having minimum 0.30mm thick aluminium skin on both sides with standard supports consisting of alternately black and Yellow with black stripes in screen printing sloping downward at an angle of 45 degrees topwards the side of the obstruction on which the traffic is to pass and buried in to the ground in a trench of size 30cmx30cm and 50cm depth filled with CC M-20 including cost and conveyance of all materials, equipment, machinery and labour with all leads and lfts, loading and un loading charges necessary for successful completion of the work on any road in division as directed by Engineer-in-Charge and conforming to IRC 67-2012 & MoRT&H SpecificationNo.805 and approved drawings etc., complete for finished item of work.