Professor Jayashankar Telangana State Agricultural University Tender

Paver Patches;Providing and applying tack coat with VG-10 (Bulk) using bitumen pressure distributor at the rate of 0.20 Kgs per sqm on the prepared bituminous/ granular surface cleaned with mechanical broom for finished item of work as per MoRT & H Specificaton 503 (5th revision) and as directed by the Engineer-in-Charge

Paver Patches;Providing and laying bituminous premixed Seal coat (type-B) with HMP of appropriate capacity not less than 60TPH comprising of a thin application of fine aggregate premixed by mechanical means with bituminious binder of grading as defied in table 500 16 of MOST crushed sand defined as passing through 2.36mm sieve and retained on 180 micron seive applied @0.06 cum per 10sqm to be laid simultaneously along with the bitumunious course using 6.80Kgs of bitumen 60/70 grade for 10Sqm and rolling with power roller including of required line, level, grade to serve as wearing course on previously prepared surface and finishing to required level and grades including cost and conveyance of all materials from approved sources and stacking at site to departmental gauge for premeasurements, seigniorage, labour charges and hire and operational charges of power road roller 8 to 10 tonnes capacity and all other machinery, tools and plants, providing barricading for diversion of traffic, erecting red flags other incidental and operational charges etc., complete for finished item of work as directed by the Engineer-in-charge and as per technical specification clause 513 of MORTH (5th revision) using Hot mix plant including contractors profit & over head charges excluding seigniarage charges etc., complete using Mechanical means

Paver Patches;Providing and laying of 30mm thick Bituminous concrete (using bitumen modifier) with 100- 120 TPH Batch Mix type Plant using HBT crushed aggregates of Grading-2 as per table 500- 17 of MoRT & H specification 508 of MORT&H (4th Revision) premixed with bituminous binder of VG 30 grade @ 4.5% to 5% of mix & filler, transporting the hot mix to work site, laying with Mechanical paver finisher to the required grade, level and alignment and rolled with smooth wheeled, vibratory and tendem rollers to achieve the desired compaction as per MoRT&H specification No.508 (4th Revision) complete for finished item of work in all respects as directed by Engineer-in-charge.