Municipal Corporation Tender

Laying of B.T. Road;Supplying and application of hot applied thermoplastic road marking compound, 2.5mm thick including reflectorising glass beads @ 250 gms with reflectorising glass beads on Bituminous surface (or) Cement Concrete Surface with Primer at 250 gms per sqm area, thickness of 2.5mm is exclusive of surface applied glass bead as per MoRTH specifications 803.4 and IRC: 35-2015, the material should satisfy the requirements as per MoRTH specifications 803.4 and must comply with the following a) White index for the product should be in the range of 60-70 when measured against standard reference. The applied panel 7/8 number must be submitted for cheking up the white index in the department lab. In case the department approves the white index of any vendor, the department engineer may carryout random checking of the applied products at site against the approved panel. in case of any major deviation, beyond acceptance limit, department reserve the right to cancel or reject the total supplied consignment of the said material and will compell the vendor has to replace the full consignment by the desired material as per approved panel at his own cost and additional demurrages may be claimed due to loss of man days (as per the rules of the department) b) luminance factor of the material should be in the range of 80-85% at 45 degree centigrade as per AASTHOM 249 c) Crack resistance. The applied panel cured for 7 days under ambient condition and then should be tested as per BS3262, Part-1, 1989 and should pass at the range of '0' degree centigrade to '-10' degree centigrade d) Adhesion : Strong E) Softening point : 102 degree centigrade F) Dried film finish : Smooth and uniform G) Night Vision : High as directed by the Engineer-In-Charge and confirming to IS : 164-1961 (1st revision reaffirmed in 1986) and clause confirming to IRC 35-2015 and MORTH section 803.4

Laying of B.T. Road;Manufacture, Supply & Deliveryof R.C.C. 600mm Dia NP3 Socket and Spigot pipes confirming to B.I.S. 458/2003 at Ex-Factory (Rate per meter of Effective Length) Lowering R.C.C. NP3 Socket and Spigot pipes carefully into the trench laying then true to alingnment and gradiuent, jointing RCC pipes with Cement joints including curing, the cost of jointing materials i.e. Cement Morotr (1:1:5), hemp yarn etc., and testing including filling with water with a water lead upto 500 mts as per B.I.S. No. 783 / 85 per every 25mm Dia

Laying of B.T. Road;Providing and laying bituminous concrete with 100-120 TPH batch type hot mix plant producing an average output of 75 tonnes per hour using crushed aggregates of specified grading, premixed with bituminous binder VG 30 @ 5.4% per cent of mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher with sensor control to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction as per MORTH specification clause No. 509 complete in all respects