Defence Research And Development Organisation Tender

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in:

Cement mortar 1:4 (1 cement : 4 coarse sand)

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in :

Cement mortar 1:4 (1 cement : 4 coarse sand)

Providing and laying Polished Granite stone flooring in required design and patterns, in linear as well as curvilinear portions of the building all complete as per the architectural drawings with 18 mm thick stone slab over 20 mm (average) thick base of cement mortar 1:4 (1 cement : 4 coarse sand) laid and jointed with cement slurry and pointing with white cement slurry admixed with pigment of matching shade including rubbing , curing and polishing etc. all complete as specified and as directed by the Engineer-in-Charge.

Polished Granite stone slab jet Black, Cherry Red, Elite Brown, Cat Eye or equivalent

15 mm cement plaster on the rough side of single or half brick wall of mix :

1:4 (1 cement: 4 fine sand)

Distempering with 1st quality acrylic distemper (ready mixed) having VOC content less than 50 gram/litre, of approved manufacturer, of required shade and colour all complete :

New work (two or more coats) over and including water thinnable priming coat with cement primer having VOC content less than 50 gram/litre

Providing and fixing double scaffolding system (cup lock type) on the exterior side, up to seven story height made with 40 mm dia M.S. tube 1.5 m centre to centre, horizontal & vertical tubes joining with cup & lock system with M.S. tubes, M.S. tube challies, M.S. clamps and M.S. staircase system in the scaffolding for working platform etc. and maintaining it in a serviceable condition for the required duration as approved and removing it there after. The scaffolding system shall be stiffened with bracings, runners, connection with the building etc wherever required for inspectionof work at required locations with essential safety features for the workmen etc. complete as per directions and approval of Engineer-in-charge. The elevational area of the scaffolding shall be measured for payment purpose. The payment shall be made once irrespective of duration of scaffolding.Note: - This item to be used for maintenance work judicially, necessary deduction for scaffolding in the existing item to be done.

Demolishing R.C.C. work manually/ by mechanical means including stacking of steel bars and disposal of unserviceable material within 50 metres lead as per direction of Engineer - in- charge.

Extra for cutting reinforcement bars manually/ by mechanical means in R.C.C. or R.B. work (Payment shall be made on the cross sectional area of R.C.C. or R.B. work) as per direction of Engineer in-charge.

Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge..

In cement mortar

Dismantling tile work in floors and roofs laid in cement mortar including stacking material within 50 metres lead.

For thickness of tiles 10 mm to 25 mm

Passenger Lift (08 persons) with PWD provision for PWD Persons : Lift with power operated center opening door and AC available voltage and variable frequency control with provision for PWD persons having following basic elevator data Elevator Type - Passenger elevator, No of Units - 01, load capacity - 544 kg or 8 persons, Speed -1.0 m/sec, Stops & Openings - 2 stops & 2 openings, Single entrance car, Total no of opening -1 entrance, Travel height – 3.5 m, Elevator Grouping -Simplex Full Collective Control, Well Dimension-1800 mm width and 1600 mm depth (required), Head Room height -3800 mm (required), Pit Height-1500 mm (required), MAP Floor Position-Topmost floor (TOP), Car dimensions -1100 mm wide x 1300 mm deep x 2200 mm high, Door dimensions-800 mm wide x 2000 mm internal height, Door type-Two-panel center opening Plain Panel, Finishes : Car design -SS silver brushed, Car Panel Finish -Moonrock textured StSt, Handrail - Round Bend Handrail Silver brushed stainless steel (ST4) at Rear Wall, Ceiling & Lighting -Integrated roof RS60 Stainless Steel Round spot LED light including granite Flooring of 20 mm Car skirting material: Stainless steel Hairline AISI441, Car Door Finish -Stainless steel Hairline AISI441 with mirror, Floor number 1-2, Floor Mark 0 & 1, Interfloor distance 3650 mm, Landing door material SS Moonrock Textured, Car operating panel -1 Full Height Stainless Steel Face Plate Silver brushed StSt Segmented LCD display Square surface mounted Buttons with braille KDS90, Landing Signalization -Stainless Steel 7 segment display Surface Mounted Silver brushed StSt Square,surface mounted with braille KDS90, Features : Correction drive to next level, Emergency Alarm @ Main Floor, Car Call backwards, Overload function, constant indication/Buzzer, Bypass load Function, Auto Cut off Fan and Light, Manual Rescue Operation, Centralized Hoisting for lesser, vibration and smooth travel, Pit Ladder, Micro movement Led Based Buttons, L.W.D. (Load Weighing Device), Direction & Position Indicator In Car & Landing, Advanced Car Position Indication, Automatic Brake Test function every 11hours, Every run brake, supervision, Phase reversal functioning, Signal Fixtures ,+10% to –10% Voltage Fluctuation, Withstanding Capacity Door Close Button, Door Open Button,Car Emergency Light, Fireman Drive, Curtain of Light 169 Beams, Accurate Relevelling, Automatic, Closed Door, Car Door lock, Emergency Rescue Device with audio announcer, 2 Way Dedicated Intercom, Nudging service, Attendant Service, Round spot LED light, CCTV provision