Tamilnadu Cooperative Milk Producers Federation Limited Tender

Supplying and fixing in position of aluminium anodized partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical members are spaced at 90cm c/c and to horizontal members are spaced at 1.20m, 2.10m and 2.40m height as per the requirements at the site and the bottom panels should be covered with 9mm thick PLB exterior grade and the top and middle panels should be fixed at 5mm thick glass with necessary glassing clips, rubber beadings etc., including necessary dismantling holes in the RCC columns, beams masonry wherever necessary with power drill to the extent required and make good the dismantled portion to original condition after fixing as directed by the Federation officers. Aluminum doors with 5mm thick glass of 6 numbers should be provided including necessary supports, hinges and floor springs wherever necessary etc complete as per the standard specifications.

Fabricating Suppiying and fixing in position of Aluminium anodised natural colour matt finish of single leaf door with half panelled with 12mm thick both side laminated particle board at bottom and half grazed using 5.50mm thick Plain glass at top The outer frame shall be with aluminium box section 101.60x44.45x3.18m at 2.319kg/m and Shutter frame made of section Vertical & Top rail: 50x44.45x2.50mm @ 1.292 kg/m Bottom rail 100 x44.45 x 2.50mm@ 1974 kg/m. Lock rail 50x44.45x2.5mm @ 1.292 kg/m, Alu Clips: 17.15x17.27x1.50mm @ 0.176 kg/m, Alu. Handle: 100x30mm @ 0.988 Kg/m and necessary accessories such as aluminium clips, rubber beading, PVC feit handle for a length of shutter (both sides), locking arrangements furniture fittings such as aluminium tower bolts- 250x12mm-1 No., aluminium tower bolt 200x12mm-1 No.. aluminium Hydraulic door closer 1 No.. lock-1 No.. Door stopper with rubber bush including cost of materials labour charges and power consumption charges required for fabrication including chipping, dismantling and making hole to the required extent in RCC column. beams masonry with power arill wherever necessary and redoing the damaged portion to the original condition after fixing etc.. complete. All the Alu. Section are to be anodised with matt finish under electrically control conditions in accordance with IS 1868/1962 for an average anatic film thickness of 15 microns etc. complete. Aluminium sections, and furniture fittings shall be got approved by the Executive Engineer incharge.

Supply and fixing of Mesh Back Chair - MOULDED Cushioned Seat with the following specification Medium - Adjustable Lumbar Support - Gas lift - Synchro Mechanism - Adjustable Arms - Nylon BASE. The make and colour should be got approved from the Federation Engineer

Supply of officers Medium Back Mesh Office Visitor chair with Heavy duty chrome frame & iron powder coated, Mesh covered seat and back, Chrome/powder coated frame of required size. The Colour and model should be got approved from the federation engineer before installation

Supply and fabrication of table of size 5' x 2/2' using 25 mm thick particle board with drawer , lock and key arrangements complete as directed.,

Supply fabrication and fixing of white marker board using 18 mm thick plywood one sided pre laminated and 1 sided 1mm thick white laminated of size 4'x3' complete as directed.

GST (Note: The tenderer should quote the amount towards Goods and Service tax (GST) in the appropriate columns in terms of percentage (%). If not quoted, it will be considered that the rate quoted is inclusive of GST.)