Tamil Nadu Housing Board Tender

Supplying, fabricating and fixing in position of aluminium partition, aluminium door (for staffs) and providing electrical sockets at the convenient places for the construction of new division office building at sowripalayam, Coimbatore District.

Supplying, Fabricating and placing in position of Aluminium natural color matt finish fixed partition top half glazed with 5.50 mm thick plain glass and bottom half with medium density fibre board of 12 mm thick both sides pre laminated for cubical and the outer frame of the aluminium section of size 101.60x44.45x3.18mm @ 2.319Kg/m at internal vertical 2 Nos & Horizontal 1No, mullion of aluminium section of size 62x38x2mm @ 1.174 Kg/m with necessary aluminium clips of size 79.15 x 17.27 x 1.50mm at 0.176 Kg/m with necessary rubber beading L angles including dismantling and redoing masonry as concrete where necessary etc., complete in all respects complying with relevant standard specifications and as directed by the departmental officers. . The aluminium sections are to be anodised with matt finish under electrically coontrolled condition in accordance with IS 1868-1962 specification for an average anodie film thickness of not less than 15 microns. All aluminium sections /materials are should be got approved by Engineer Incharge before use on works .

Supplying and Fabricating and Fixing in position aluminium anodised door with door shutter partly top 2/3 glazed and partly bottom 1/3 panelled and frame made out of box section 101.6x44.45x3.18mm thick at 2.319 kg/m door shutter made out of Box section 47.1x44.45x2.5mm at 1.202 kg/m for vertical style and top, lock rail sections of size 50 x 44.45 x 2.50 mm @ 1.292 kg/m and bottom section 100.4x44.45x2.50mm at 1.974 kg/m using clips of size 17.15x17.27x1.5mm at 0.176 kg/m with rubber beading, strike plate type handle of size 100x30x1.6mm at 0.988 kg/m on both sides, tower bolts, lock and top 2/3 portion with 5.50mm thick plain glass and bottom 1/3 portion with both side prelaminated board (MDF) 12 mm thick for panel portion with one floor springs including cost of all materials labour power consumption required for fabrication, drilling holes in RCC columns floor slabs masonry wall wherever necessary with powder drills to the required extent and make the same to original condition after fixing and as directed. All the aluminium sections are to be anodised with matt finish under electrically controlled condition in accordance with IS 1868-1962 for an average anodic flim thickness of 15 microns etc.., complete in all respects complying with relevant standard specifications and as directed by the departmental officers. The materials should be got approved by the Engineer Incharge before use on works. The rate shall be inclusive of all materials labour for fixing, transportation, loading,unloading and all other incidential charges.(Single Leaf Door)