Rural Development And Panchayat Raj Department Tender

Cement concrete 1:4:8 mix using 40mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing, etc

Brick work in CM 1:5 mix using country bricks ground moulded of size 23 x 11 x 7 Cm for the following including curing etc., complete complying with standard specifications.(BELOW Basement)

Brick work in CM 1:5 mix using country bricks ground moulded of size 23 x 11 x 7 Cm for the following including curing etc., complete complying with standard specifications.(ABOVE Basement)

Reinforced cement concrete 1; 11/2;3 using 20mm iss HBG metal including the cost and conveyance of all meterials and cost of all labour charges etc completed,..

Reinforced cement concrete 1; 11/2;3 using 20mm iss HBG metal including the cost and conveyance of all meterials and cost of all labour charges etc completed,( Above basement)

Supplying and Fabrication,Placing in position of mild steel or ribbed tor steel grils for RCC works including cost of steel and binding wire etc.

Supplying and erection centering for sides and soffits including necessary supports and structing for plain surfaces such as RCC slab, lintel, beam, coloumns, sunshade etc completed. (BELLOW GROUND LEVEL)

Supplying and erection centering for sides and soffits including necessary supports and structing for plain surfaces such as RCC slab, lintel, beam, coloumns, sunshade etc completed.. (COLUMN)

Plastering cm 1;5 -12mm Thick including the cost and conveyance of all materials and cost of all labour charges etc., complete.

Provision for cupboard cuddapah slab of 40mm thick including supply and fixing etc

Granolithic floor finish 25mm thick in pcc 1:2:4 using 10 to 12 mm HBGS jelly including curing etc

Supplying and applying of two coats of putty of 3mm thick over the exposed RCC surface of ceiling including finishing the joints smoothy with grinding machine and the surface shall be thoroughly cleaned out of dust and scrubbing. The Surface shall then be allowed to dry for atleast 48 hours. It shall then be sand papered (waterproof abrasive sheet) to give a smooth and even surface. Any unevenness shall be made good by applying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat of putty after 6 hours of 1st coat of putty and then sand papering (waterproof abrasive sheet) the same after it is dry and finishing the surface smoothly, etc., complete complying with standard specifications and as directed by the Departmental Officers. [ The rates are inclusive of hire charges for grinding machine with wheel, cost of sand paper (waterproof abrasive sheet), cost of putty blade, labour charges for grinding the joints and sand papering, two coat of putty, scrapping the putty area to level the surface smooth, etc., complete]. The Putty shoule be got approved by the Executive Engineer before use on work.

Shahabad stone flooring laying with new ceramic tiles of size 600*600*20mm laid in CM 1:3 including cost of white cement and labour charges etc

Dadooing the walls with Glazed tiles including the cost and conveyance of all materials and cost of all labour charges etc., complete

Fabrication and supply of mild steel door of any size with single leaf outer frame made of 35*35*5 mm equal M.S angle and shutter frame made of 25*25*5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18G plate etc complete.

Door 0.90*2.40 m

Door 1.10*2.40 m

Fabrication and supply of mild steel window of any size with single leaf outer frame made of 35*35*5 mm equal M.S angle and shutter frame made of 25*25*5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18G plate etc complete.

Window 1.20*1.20 M

Cost and Supply of Ventilators including all cost and conveyance

Ventilators 0.60*0.45 M

Ventilators 0.60*0.45 M

Distembering two coats oil bound distember over priming coat including cost and conveyance of all materials to site labour charges etc. complete (Inner Wall)

Exterior emulsion painting two coats priming coat including cost and conveyance of all materials to site labour charges etc. complete (Outer Wall)

Painting two coat of new iron works such as steel Doors, windows, ventilators etc, with best approved first quality of synthetic enamel paint of approved colour over the existing primming coats, etc

EWC

Baby friendly basin

Provision for Bala paintin cartoons, letters including all charges

ELECTRICAL ARRANGMENTS

Wiring with 2 x 1.5 sqmm (22 / 0.3) PVC insulated SC unsheathed Copper conductor cable of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories inflush with wall with 3mm thick hylum sheet cover with TW switch box and 5A F.T. switch and making good of the concealed portion with suitable Colour for open PVC light / Fan points (SD 20)

Supply and run of 2 of 2.5sqmm (36/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V Grade in suitable PVC rigid pipe on wall and ceiling with continuous earth wire connection of 14SWG TC wire and making good of the concealed portion with suitable colour (SD 56)(Open wiring from meter board to switch board)

Supply and fixing of single box type 4'40 W flu fitting complete with electronic ballast with TW round blocks on wall or ceiling with flu tube with PVC unsheathed Copper leads from terminals to the fitting.(SD 88)

Supply and fixing of single of od bulk head fitting guard (philips/Bajaj/Crompton/K.Lite)

Supply and fixing of 1200 mm (48") AC ceiling fan (Conforming to ISS 374 / 1979) complete with stepped electronic 300W regulator with 300mm down rod on the existing

Supply and run of 2 of 4 sq.mm 956/0.3) PVC insulated SC unsheated cu.conductor of 1100v grade on 7/20 GI bearer wire for service

Supply and fixing of 15 A 3 pin combined flush type wall socket with 15A flush

Supply and fixing of TNEB meter Board suitable for 32A Single Phase service connection with 32A Fuse unit (500V) 32A neutral link and earth link (1" x 1/8" Copper flat) on TW plank of size 375mm x 300mm x 19mm with supporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit.(SD 125)

Supply and fixing of 25mm dia GI pipe

Supply and fixing of 11W CFL bulb

GST Amount for providing Service to Government Contract Works for the above Construction & Maintenance Works. { GST Amount is the Total GST Amount for overall quoted amount (Both Construction and Maintenance) above this row in column "BB" for all works in this package} (Refer Clause 13.2 & 13.3 of Section 2 of Instruction to Bidders (ITB) of SBD)