Rural Development And Panchayat Raj Department Tender

Supply and Filling in basement with excavated earth in layers not more than 15 cm thick and well rammed, watered and consolidated including all labour charges as oper standard specification

Supplying and filling in foundation and basement with filling sand in layers of not more than 15 cm thick wall ramed, watered and compcted including cost and conveyance of sand and all labour charges etc., complete as per std specifications

Brick work with cement mortar 1:5 mix using country bricks of size 83/4"x41/4"x2" for foundation and basement and superstructure foundation and basement and superstructure inculding cost and conveyance of all materiales curing etc ,complete.

Reinforced Cement concrete 1:1.5:3 mix using 20mm one cement, One and off Crusser Stone sand and Three hard broken stone) using 40mm ISS size hard granite broken metal from approved quarry including cost and conveyance of all materials to site including cost of cement which will be supplied departmentally at the departmental section stores and the cost will be recovered at the rates noted in the special conditions appended and conveyance of the same from departmental section stores to the actual worksport and handing charges at each and including cost of from work mix concrete laying compacting and watering curing concrete including all leads for good soft, potable water, hire and fuel charges for all tolls and plats and all other incidental charges such as balling out water forming protective bunds providing coffer dams etc., complete as directed by the Engineer Table I of IS 2116-1980

Supplying and fabrication of steel including cost and conveyance of all materials and all labour charges for cutting,tying placing in position etc., complete for all RCC works. The binding wire shall be supplied by the Contractor.

Supplying and erection centering for sides and soffits inculding necessary supports and structing for plain surfaces such as Below sill level etc complete.,

Supplying and erection centering for sides and soffits inculding necessary supports and structing for plain surfaces such as RCC Slab,Lintel,Beam, coloum,sunshade etc complete.,

Cement concrete 1:2:4 mix using 12mm ISS metal including cost and conveyance of all materials to site and all labour charges for mixing, laying and curing etc complete for bed blocks for 10 cum

Wearing course with over R.C.C. roof slab in the proportion of 32:12.5 and finshed with one course of Cooling tiles of size 12x12x2cm with cement mortar 1:3 mix and pointed with the same oiled mortar including cost and conveyance of all materials to site and all labour charges etc complete for 10 Sqm

Paving the flooring with special type of Pre-polished Concrete Anti-Skid Step Tiles of 20mm thick (20mm thick) in CM 1:3, 20mm thick

Paving the floor with best quality Stain free Nano Polish Vetrified Tiles of size 600 x 600 x 8mm of approved colour, shade and quality laid in cement mortar 1:3 (one cement and three Sand) 20mm thick in all floors and the top pointed with the white cement mixed same colour pigments etc., complete complying with standard specification.

Plastering with cement mortar 1:5 (One cement and five sand) 12 mm thick in all floors including cost of scafolding, finishing, curing etc.

Plastering with cement mortar 1:3 (One cement and Three sand) 10 mm thick in all floors including cost of scafolding, finishing, curing etc.

Fabrication and supply of mild steel Door of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate etc complete.

Door 1.20 x 2.10 m

Door 0.9 x 2.10 m

Fabrication and supply of mild steel window of any size with single leaf outer frame made of 35x35x5 mm equal M.S angle and shutter frame made of 25x25x5 mm M.S angle for horizontal and vertical member with stiffener and fully covered with 18 G plate etc complete. window 1.20 x 1.30 m

Distembering two coats with best approved distember including cost and conveyance of all materials to site and all labour charges etc complete

Exterior Emulsion painting two coats with best approved quality and colour paint over one coat of Base coat including cost and convyance of all materials to work site and labour charges etc., complete. (NEW WALL)

Painting two coat of new iron works such as steel Doors,windows,ventilators, etc., with best approved first quality of synthetic enamel paint of approved colour over the existing priming coats,ete.

Painting two coats with black oxide over new wall surface including cost and conveyance of all materials to site and all labour charges etc., ocmplete

Labour charges for fixing doors alongwith frames in position etc., complete (finished work)

Labour charges for fixing windows and ventilators along with frames in position etc., complete. 1.80 x 1.30m

Provision for Cupboard Cuddapah slab 20-30 mm tk inclding supply and fixing etc

Providing and fixing of PVC rain water down fall pipe 110mm dia with necessary T W Clamps, Plug, Shoes, bend, Screws, nails etc., complete

Wiring with 2 X 1.5 Sq.mm (22 / 0.3) PVC insulated SC unsheathed Copper conducutor cable of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories inflush with wall with 3 mm thick Hylum sheet cover with TW box And 5 A FT switch with continuous earth connection of 14 SWG TC wire for making good of the concealed portion with suitable colour for PVC concealed Light point / fan point (For electronic Regulator) SD 18

Wiring with 2 X 1.5 Sq.mm (22 / 0.3) PVC insulated SC unsheathed Copper conducutor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories inflush with wall with 150 mm X 100 mm X 113 mm TW switch box with 3 mm thick Hylum sheet cover for 5 A 3 pin non interlocking CS plug with continuous earth wire connection of 14 SWG TC wire for making good of the concealed portion with suitable colour for concealed PVC plug point SD 36

Supply and run of 2 of 1.50 sq.mm (22/0.30) PVC insulated SC unsheathed copper Conductor of 1100 V grade on 7/20GI bearer wire for service connection mains SD 65

Supply and run of 2 X 1.5 sq.mm (22 / 0.30) PVC insulated SC unsheathed copper Conductor of 1100 V grade in 25 mm dia GI pipe ( Class ' B ' ) suitably bent at both ends with necessary angle iron upright and end supports for mains. SD 69

Supply and fixing of 16 Amps DPIC Switch of 500 V with fuse and neutral (Side Handle) on suitable TW box PWD Earthing SD 142

Supply and fixing of WT bulk head fitting with guard ( Philips / Bajaj / Crompton / K Lite ) suitable for incandescent lamp with 60 W bulb.SD 80

Supply and fixing of 1200 mm ( 48") AC ceiling fan complete with stepped electronic 300 W regulator with 300 mm down rod on the existing clamp. SD 110

Supply and fixing of single box type 4'-40W flourescent tube fitting with copper choke and condenser with TW round block on wall or ceiling with flourescent tube with PVC unsheathed copper leads from terminals to the fitting of Tube Light [SD 88 ]

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}