Public Works Department Tender

35 Provision of 1+3 EPABX intercom with phone to be provided at the following Places, vide 1.Lift Head Room,2. Reception Room and 3. Inside the Lift, by lift contractor. 36 Lift License: Preparation of drawing, Payment of charges to CEIG and insurance policies if any and obtaining CEIG safety certificate and lift license as per lift act should be done by lift contractor. 37 Automatic rescue device – To facilitate the landing of the nearest floor at the time of power failure. This shall consist of suitable type battery system with charger inverter , under voltage protection system etc. 38 Floor annunciation system with music. 39 Special features: (a). Infra red door sensor with Full height screen. (b). Full width half height rear panel Mirror. (c).Voltage stabilizer for circuit control. (d). Tubular Stainless Steel hand rail in car (e). Signal Fixtures (f). Vandal proof S.S. button with S.S. cover. (g). Stainless steel door frames (h). V3F door operator (i) Call register signal (j) Pit ladder (k). Braille buttons

(l).Stainless steel facia for car operating panel and landing fixtures. (m). ON-OFF switch for fan and Light. (n) Over load warning indicator. 40 Over speed governor, phase failure and phase reversal relay, alarm bell, Guide brackets for car and counter weight, rubber padding under winding unit, Motor of adequate capacity, single reduction wormgear, electromagnetic brake with compression springs, car safety gears, buffer, electro mechanical door locks, emergency key, side supporting angles, motor over load protection devices, final limit switch, main suspension ropes, counter weights, lifting joint joist for mounting the machineries. 41 Guarantee: Guarantee for the Materials & workmanship of equipments complete should be offered by the Lift firm for a period of not less than one year and free service for One Year. 42. Site testing in accordance with is 14665sshould be carried out at the time of handling over.

Narrow vision panel arrangement 15,000/landing (6 landing and 1 car door)

Rewiring with 2 x 1.5 Sqmm. (22/0.3) PVC insulated SC unsheathed cu. Conductor with of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with PVC modular box with 6A one way switches covered with plastic modular cover plate fixed on wall and painting of suitable colour for open PVC light/fan point (5 points per coil) Switches and platess are of Anchor Roma / Equivalent Make

Renewal by Supply and Fixing of WT Bulk head fitting with guard suitable for 7 Watts LED lamp ( Philips/ Bajaj Crompton/K Lite/Equivalent Make)

Renewal by Supply and fixing of 20W, 4 feet SBT fitting on wall or ceiling with LED tube with PVC unsheathed copper leads from terminals to the fittings.

Renewal by Supply and fixing of 375 mm (15") sweep (light duty) AC exhaust fan complete with necessary wall opening and making good of the wall

Renewal by Supply and fixing of louvers shutters arrangements for 375 mm (15") sweep (light duty) AC exhaust fan

Renewal by Supply and fixing of 3 modular metal box with suitable Modular front plate with suitable Modular switches in flush with wall comprising the following with connection 6/10A One way Module switch - 1No 6A 5 pin socket -1 no Switches and Sockets are of Hager/MK India/ Equivalent Make

Renewal by Supply and fixing of 3 modular metal box with suitable Modular front plate with suitable Modular switches in flush with wall comprising the following with connection 16A One way Module switch - 1No 16A 5 pin socket 1No Switches and Sockets are of Hager/MK India/ Equivalent Make

Renewal by Supply and run of 2 of 1.5Sqmm (22/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with continuous earth wire connection of 14 SWG TCwire with painting suitable colour

Renewal by Supply and run of 2 of 4 Sqmm (56/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with continuous earth wire connection of 14 SWG TCwire with painting suitable colour

Renewal by Supply and Clamping of 31/2x50 sq.mm PVC armoured LTUG cable on wall with MS clamps.

Renewal by Supply and fixing of brass cable gland for 3 1/2 x 50 sqmm PVC armoured LTUG cable with earth connection

Renewal by Supply and providing cable end termination of 31/2 X 50 Sqmm PVC LTUG Alu.armoured cable with necessary alu.cable sockets by crimping etc with electrical connection complete

Renewal by Supply and fixing of 12Way Earth bus arrangement

Renewal of Earthing as per ISI specification with an earth electrode of 2.1 mt class B GI pipe of dia. not less than 40 mm with copper earth plate of size 125x50x6mm with necessary tunneling arrangement with necessary masonry work and with 38mmRCC cover slab.

Renewal by Supply and run of 1 of 8 SWG copper wire for earth connection.

Renewal by Supply and fixing of Vertical type 4way triple pole neutral MCB distribution board with Metal Acrylic Door cover with IP42 Protection, with 100A 4 pole MCB Isolator as incoming and 2Nos 40A TPMCB and 6Nos 6A to 32A SPMCB as Outgoing in flush with wall and making good of the concealed portion with earth connection only. The MCB DB and MCB’s should be with ISI mark.(Like Legrand /Hager L&T/ Equivalent make)

Renewal by Supply and run of 4 of 6 Sqmm (84/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with continuous earth wire connection of 14 SWG TC wire with painting suitable colour

Renewal by Supply and fixing of 32A FP MCB in suitable sheet steel enclosure with inter connection.(Make Legrand /Hager/Equivalent Make )

Renewal by Supply and fixing of 32A DP MCB in suitable sheet steel enclosure with inter connection.(Make Legrand /Hager / Equivalent Make )

GST @ 18%