Municipal Administration And Water Supply Department Tender

32mm PVC ball valve

32mm PVC pipe

32mm MTA

32mm Coupler

32mm Bend

110 mm PVC pipe

110 mm PVC Bend

110 mm PVC coupler

110 mm PVC Elbow

25 mm PVC pipe

25 mm PVC Elbow

25mm PVC bend

Supply and fixing of Oriya Type Indian Water Closet - color of 580mmx440mm with "P" or "S" Trap as per standard specification

Supply and fixing following Materials as directed by the departmental officers.Bulkhead 10W

3/4" PVC Wiring pipe

3/4" PVC Elbow

3/4" PVC Tee

3/4" water clamp

6Ahms switch

30W LED Street Light Fitting with LED

Supply and run off 2 of 2.50sqm PVC insulated single core unsheathed copper conductor cable of 1100 V grade with ISI mark confirming to IS:694/1990 with continuous earth connection by means of 1.50 sqm PVC insulated single core unsheathed copper conductor cable confirming to IS:694/1990 in suitable PVC rigid pipe 1.8mm thick concealed in wall for mains including the cost of PVC pipes and specials, cables, cement, brass screws, T.W plugs, saddles and labour etc., complete in all respects as directed by the departmental officers. (derived from SD 55)

Supply of Plastic bucket and mug etc..

Supplyandproviding1000litrescapacityPrimingTankmade up of PVC. Make: SINTEX / EQUIVALENT

Supply and delivery of 10.0 HP Submersible Pump Clear water vertical wet type submersible pumpset suitable for 150mm dia borewell conforming to IS 8034/2002 as amended thereafter and BEE 3 Star Rated capable of discharging noted LPM against head of water column due to all causes. The pump shall be with stainless steel shaft and dynamically balanced bronze or Cast SS impeller, brass screws and CI FG 200 grade pump bowl/diffuser with ISI mark. The pump shall be directly coupled to a continuos rated two pole suitable wet type vertical squirrel cage induction motor as per IS 9283 /1995 as amended there after, suitable for operation in AC three phase 415 V+/-10%, 50HZ +/- 5 % etc Complete.,

Supply and delivery of GI pipes and specials as per standard specifications. 50mm GI pipe

50mm GI coupler

Supply and delivery of Nylon Rope for Bore-well as per standard specifications

Labour charges for the erection of Horizontal shaft, centrifugal pumpset (coupled/Monoblock) in bore well / Open well including fixing of suction pipe and foot valve upto a maximum depth of 7 meters and delivery pipes to the required length with valves, pressure guages upto the exterior wall of pump room and erection of panel board consisting of TPIC switches starter, Voltmeter, Ammeter , Capacitor single phasing preventor and laying and jointing the cables and Twin earthing as per IE rules including providing bed blocks etc., complete and operating the pumps and trial run for 10 days including signing of completion of reports as required by EB authories. , SI No-17a- ii) 5 HP Submersible pumpset

Supply and delivery of 4 sqmm. cable PVC insulated and sheathed 3 core flat type copper cable confirming to IS 694/1990 including labour charges etc., complete and as directed by the departmental officers.

Bore cap using M.S. Flat of size 1 cm x 3 mm and M.S. sheet on top with bolting arrangements for securing the cap in position (Bore caps with M.S. Couplings need not be made) etc complete.,

50mm MS Clamp Set

Supply and delivery of Star-Delta starter confirming to IS 13947, IEC60947-1 and as amended thereafter with suitable KW rating for operation in AC/ Three Phase/50HZ (+/- 5%) and 415V (+/- 10%) including 3 pole magnetic contactor with under voltage release - 3 nos., CT operated Ammeter (65 mm dia) with suppressed scale, Voltmeter (65mm dia), Voltmeter selector switch, Miniature circuit breaker, Thermal Overload relay, Air Break contactors suitable for next Standard higher KW rating, Single phasing preventor, dry running preventor and On/Off Push button switches, wiring with 1 sq.mm/4 sq. mm copper pvc insulated cable, powder coated vermin

Manufacturing supplying and fixing of MILD STEEL DOOR made out of 50 x 50 x 6 mm M.S angle for outer frame,35 X 35 X 5mm M.S.Angle for outer frame of shutter. The entire shutter area shall be covered with CRC sheets (18 G) with 5Nos, of stiffners using M.S.Flats of size 25 X 6mm at equal intervals horizontally. The corners of the frames and shutter with CRC sheets shall be welded by adopting flash butt welding or any other suitable method. Provision towards 3Nos, of Hinges incase of single shutters / 6Nos,of Hinges incase of Double shutters of 125 X 31 X 1.25mm size placed at appropriate intervals and provisions shall be made for Tower bolts 2Nos, Aldrop 1No. The frame shall be provided with 6Nos,of Hold fast of 200mm length using 50 X 6mm M.S.Flat. The entire frame and shutter shall be provided with one coat of red oxide primer including cost of hold fasts,hinges, locking arrangements, handles wind appliences etc., complete and as directed by the departemental officers.

Painting two coats with Ready Mixed Enamel Paint over the new iron works of approved quality and colour without priming coat including the cost all materials etc.,complete, in all floors.

Wash Hand Basin of size 550mmx 400mm with all accessories such as Cast Iron Brackets, 32mm dia CP Waste Coupling, Rubber Plug and Chain, 32 mm dia ' B' Class GI Waste Pipe, 15mm dia GM Wheel Valve, 15mm dia Nylon Connection, 15mm dia Brass Nipples, 15mm CP Pillar Tap etc.

PVC / FibreGlass Framed5.5mmthickMirror, Shelf Type with Hard Board Backing Special Type Mirror of size 1000 x 780mm as per the standard specifications.