Municipal Administration And Water Supply Department Tender

Providing rain water harvesting using 6 No.of RCC well rings of 90cm inner dia (clear) with 5cm wall thickness made out of cement concrete 1:2:4 using 20mm hard broken jelly to a height of 30cm each supplying and fabricating 16 No. of 6mm dia MS rod vertically and 3 No. of 6mm dia MS rod circumferentially tied together with 18 guage binding wire for well rings including necessary earth work excavation 1m dia to a depth of 1m, supplying and filling 40mm HBG inside the erected well ring to a depth of 90cm, and top covered with RCC circular perforated cover slab of Im dia and 5cm thick which inclusive of cost and fabrication of 6mm M.S reinforcement at 15 cm spacings on both directions and one 6mm M.S rod ties at the edge of the slab circumferentially including cost of moulding, curing, finishing and well placing in position and disposing off excavated earth with all initial leads and lifts in places as shown by the Departmental officers etc., complete in all respects

Painting two coats for Exterior surface with approved Exterior Plastic Emulsion paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification.

Painting two coats with Ready Mixed Enamel Paint over the new iron works of approved quality and colour without priming coat including the cost all materials etc.,complete, in all floors.

Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for staircase using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick at required locations to a height of 900mm from finished floor level welded to 38mm dia Stainless Steel pipe post of 1.00mm thick as vertical at 900mm centre with 2 Nos. of 25mm dia intermediate horizontal stainless steel pipe of 1.60mm thick in between. The vertical pipe has to be welded to the 100 X 100 X 6mm MS base plate encased in the base concrete. The rate is inclusive of the charges for cutting, bending, welding, grinding, polishing, conveyance, electrical charges, etc. complete

Wiring with 2x1.5 sqmm (22/0.3) PVC insulated SC unsheathed Copper conductor Cable of 1100V grade in suitable PVC rigid pipes on wall and ceiling with PVC accessories with TW switch box inflush with wall with 5A F.T switch, covered with hylum sheet of 3mm thick with painting of suitable colour, with continuous earthwire connection of 14 SWG TC wire for PVC concealed light Point/ fan point (for electronic regulator) SD-25

Wiring with 2x1.5 sqmm (22/0.3) PVC insulated SC unsheathed Copper conductor Cable of 1100V grade in suitable PVC rigid pipes on wall and ceiling with PVC accessories, in fish with wall, with 150mmx100mmx113mm TW switch box with 3mm thick hylem sheet cover for 5A 3 pin non inter locking CS plug with continuous earth wire connection of 14 SWG TC wire for cocealed PVC plug point-SD38

Supply and run of 2 of 4 sqmm (56/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V grade 25mm dia GI pipe (class 'B') suitably bent at both ends with necessary angle iron upright and end supports for main- SD 70

Supply and fixing of 9w LED bulb

Supply and Fixing of 1200mm (48") Ceiling fan complete with Stepped electronic 300W regulator woth 300mm down rod on the existing clamp (SD-110)

Supplying and fixing of TNEB meter board suitable 32 A single phase service connection with 32 A fuse unit (500V) 32 A neutral link and earth link (1" x 1/8" copper flat) on TW plank of size 375mm x 300mm x 19mm with supporting TW reepers of 1" thick an either side with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB metre to fuse unit- SD125

Supplying and fixing of 4 Feet 20 W LED Tube Light Fitting

Supply and Fixing of 1000 ltr Capacity PVC Water Tank the rate including cost and conveyance of Material to site etc complete

Supply deliver and phase compressure of single motor with ISI marking as per specification for the duty condition with suitable for installation in 110mm dia borewell etc complete (1.50HPx m duty condition)

Supply of 1.50Hp compressure motor's starter including cost conveyance to site etc complete.

Labour Charges for erection of Horizontal shaft, centrifigal in pumpset borewell/ (Coupled/Monoblock) Openwell including fixing of suction pipe and foot valve upto a maximum depth of 7 metres and delivery pipes to the required length with valves, pressure guages up to the exterior wall of pump room and erection of panel Board consisting of TPIC switches starter, Voltmeter, Ammeter, Capacitor single phasing preventor and laying and jointing the cables and twin earthing as per IE rules including providing bed blocks etc., Complete and operating the pumps and trail run for 10 days including signing of completeion of reports as required by EB Authorities

supply of following ws materials a.1"HDPE Hose

b..1/2"HDPE Hose

c.1/2"GI PIPE

D1"CPVC PIPE

3/4" CPVC PIPE

1"X1/2" BORE COUPLING

BORE BOTTOM VALVE

PVC TAP