Municipal Administration And Water Supply Department Tender

Supplying and filling in foundation and basement with filling sand in layers of not more than 15cm.thick well rammed watered and compacted etc., complete complying with standard specification.

Plain Cement Concrete 1:4:8 (one cement four fine aggregates and eight coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges such as water providing etc., complete as per standard specification

Centering for soffits of RCC slabs of plane surface like lintels, beams ,etc.,including strutting 3m high using mild steel sheets of size 90cm X 60cm X and B.G 10 stiffened with M.S angles of size 25mm X 25mm X 3mm laid over silver Oak (C.W) joists of size 10cm X 6.5cm (spaced at about 90cm c/c )and supported dy casurina props of 10cm to 13cm dia (spaced of 75cm C/C) complying with standard specification and directed - 10 m 2 (P & D)Data 38

PLANE SURFACE

Below GL upto 3.3m above GL,Column footing

0 m to 3.3m ht from floor level

3.31 m to 4.3m ht from GL,Brace I set

6.31 m to 7.3m ht from GL,Brace I set

7.31 m to 8.3m ht from GL,Brace I set

CURVED SURFACE

From 0 to 3.30m above G.L

SQUARE COLUMN

Ground to 3.30m above G.L

From 3.31 to 4.30m above G.L

From 4.31 to 5.30m above G.L

From 5.31m up to 6.30m

From 6.31m up to 7.30m

Supplying, fabricating and palcing in position of RTS OR TMT grills for reinforcement for various members for all R.C.C. works including cost of steel, binding wire etc. complete complying with standard specification and as directed by the TWAD Board office

Providing and laying in position, Standardised Concrete Mix M-30 Grade in accordance with IS:456-2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cementcontent of 400 kg/m3 and maximum water cement ratio of 0.45, including admixture (plasticiser / superplasticiser) in recommended proportions as per IS:9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability with about (5.0 cu.m.) 7730 kg. of 20mm machine crushed stone jelly and with about (3.3 cu.m.) 5156 kg. of 10-12mm machine crushed stone jelly and with about (4.79 cu.m') 7670 kg. of crushed stone sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrators, finishing, curing, etc. and providing fixtures like fan clamps in the RCC floor/ roof slabs wherever necessary without claiming extra, etc., complete complying with standard specification and as directed by the departmental officers. The coarse and fine aggregates to be used should comply with the requirements of IS Standards. (No separate payment will be made by the Department for the excess usage of materials).

Beyond 1.5m to 4.5m Below GL

0.00m to 1.50m below G.L

0.00m to 4.50m from G.L

4.50m to 7.32m from G.L

7.33m to 10.98m from G.L

Painting two coats with ready mixed Plastic Emulsion Paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification. - 10 sq.m

Pipe connection work to OHT including cost , labour, materials construction of valve pits etc complete complying with the standard specification as directed by TWAD Board officers

65mm dia GI pipes for inlet connection

65mm dia GI coupling

65mm dia GI bend

65mm dia GM gate valve

Fabrication, supply, delivery and fixing of outside MS Ladder of 45cm clear wide made out of 50 mm x 50mm x 6mm MS angle for both sides and for steps at 30cm C/C welded jointed etc ., for I staging from GL to 1st level brace (weight 4.5kg/m) IInd and IIIrd staging upto floor slab and IVth staging from floor slab to roof top. Supply, delivery and fixing of 32 mm GI pipes medium for hand rails from I stage to IVth stage. RCC M30 Grade mix for Landing slab 5 nos. at Ground Level- 1No. and above Ground Level - 4Nos. Supply and fixing of 32mm GI pipe medium for hand rails for the Landing slab. Supplying and fixing of MS Base plate of 100mm X 100mm X 6mm thick for fixing Anchore fastener bolt for fixing of hand rails at Landing slab and MS Ladder providing locking arrangements with two coats of approved enamel paint over one coat of red oxide paint as per approved Type Design and as directed by TWAD board officers. (30000 litres capacity at 12.0m staging height)

Supplying and fixing in position C.I.Manhole covers (light or heavy duty) mof various sizes of best approved quality and as per atandard specifications etc.,complete.

Providing and fixing RCC inside access ladder of approved pattern and design in RCC M30 design mix of ISS gauge 0.40m width, 0.10m thickness, 0.12m breadth for side post, 0.05m thickness 0.12m breadth for steps with suitable inclination including cost of cement, reinforcement centering, finishing, curing etc., complete and as directed by Department Officers.

Labour charges for Painting TWAD Board Emblem inaccordance with the size and specifications as approvedby the Board on the Service Reservoirs including cost ofall consumables, one coat of base paint, affoldingcharges including painting RDWP Logo on the Service

Goods & Service Tax (GST 18%)