Municipal Administration And Water Supply Department Tender

Plastering in cement Mortar 1:3 mix 20mm thick etc., complete

Supply and erecting shuttering including necessary supports for plane surfaces such as RCC floor slab, Roof slab, Beam, Lintel, Bed Block, landing salb, waist slab, Portico slab and beams etc., all floors using mild steel sheets of 90cm X 60cm and 10 gauge stiffened with welded mild steel angle for boarding supported by casurina props at suitable intervals etc., completed complying with standard specification and as directed

Supply and fabrication of RTS rods with various dia including cost of bending, tying conveyance of all materials to work site etc., complete

Reinforced cement concrete 1:1.5:3 (one cement, one and a half sand and three aggregate) using 20mm gauge hard broken granite stone jelly for all RCC items of work excluding centering, shuttering, and cost of reinforcement grill but including curing finishing, vibrator charges etc., complete and also including fixing fan clamps and fixtures in RCC works wherever necessary as directed by de-eartmental officer etc., complete

Providing and laying well gravel including cost and conveyance of all materials from approved quarries as noted in lead chart to the road side includinig loading, unloading and staclking the well gravel at road side to departmental gauge for premeasurement including labour charges for laying spreading levelling to camper etc., complete as per specification.

Flooring with C.C 1:3:6 mix using 40mm metal 100 mm thick and top plastering with cement mortar 1:3 mix 20 mm thick

DADDOING THE WALLS with first quality COLOUR GLAZED TILES WITH PRINTED DESIGN of 150X150X6 mm laid in cement mortar 1:2 mix to 40mm thick and painting with white cement using 0.40 kg/1m2 including finishing the jointing and eaintine flush with tiles surface etc., complete .

Paving the floor with Vitrified floor tiles of size 60 x 60cm of approved brand and colour Marbonite tiles in all floors base layer of cement mortar 1:3 (One cement and thre sand) 20 mm thick using first quality Marbonite tiles of size 60 x 60 cm and point with colour cement nearly and fixed in position so as to make perfectly smooth and to alignment etc., complete complying with standard specficatiom

Applying wall patty coats including cost of conveyance of all material and labour charges etc., Complete

Painting with emulsion paint paint two coats over a priming coat incluidng through cleaning, scrapping. Removal of dust and including necessary plaster of paris putty works wherever required etc.., complete

Painting new iron work for doors, windows, grills, weld mesh sceens etc., two coats over one coat of primer

Wiring with 2x15 Sq.mm (22/0.3) PVC Insulated SC unsheathed CU conductor of 1100V grade in Suitable PVC rigid pipe concealed in wall and ceilling with PVC accessories TW switch box and 5A.F.T switch with continuous earth wire connection of 14 SWG TC wire for making good of concealed portion with suitable colour PVC Concealed light or fan point. (For electronic regulator) SD-16

Wiring with 2x1.5sq.mm (22/3.0) PVC insulated unsheathed single core unsheathed copper Conductorcable of 1100V grade in suitableheavy gauge MS conduit pipeon wall and celling with M.S accessories inflush with wall with 150mm x 100mm x 75mm MS swithbox with 3mm thick hylum sheet cover for 5A 3pin non interlocking CS plug with continuos earth wire connection of 14SWG TC wire and making good of the concealed portion with suitable colour for concealed plug point

Wiring with 2x4 sqmm (56/3.0) PVC insulated SC unsheathed Coper Conductor cable of 1100V grade in suitable heavy gauge MS conduit piped on wall and celling with M.S accessories inflush with wall with 150mm x 100mm x 75mm MS switch boxconcealed type with 3mm thick hylum sheet cover for 5A 3pin non interlocking CS plug with continuos earth wire connection of 14SWG TC wire and making good of the concealed portion with suitable colour for concealed power plug point.

Supply and Fixing of 20A DP Plug and socket in sheet enclosure with 32A DP MCB in flush with wall with earth connection (For AC Plug) SD-140

Supply and fixing of fancy glass shade and 11W CFL For BH Point SD-80

Supply and fixing of TNEB meter board suitable for 32A service connection with 3 Nos. 32A fuse unit (500V) 32A neutral link and earth link (1" x 1/8" vopper flat) on TW plank of size 600mm x 450mm x 19mm with supporting TW reepers of 1" thick and either siede with painting with suitable bolt and nuts for fixing the TW plank suitable bolt and nuts for fixing the TW plank in wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit SD - 127

Supply and fixing of 3 Phase 32 A aerial fuse unit for 3 Nos. 32A fuse units (500V) on suitable MS sheet covered with 6mm thick hylem sheet on suitable angle iron worthe tapping pole with necessary clamps SD-132

HORIZONTAL THREE PHASE DISTRIBUTION BOARD WITH MCNS 4 way/6way/8 way/ 12 way TPMCB sheet steel distribution boards flush type / surface type fitted with bus bats and neutral links with single/ three phase MCB outgoings and separate 4 way provision for accommodating one No. 4 pole incoming MCB / Isolator and another separate 4 way provision fo accommodating one No.4 pole ELCB / RCD with label holder and provisions for taking up cable for size not less than 35 sq.33 4 ways 3 phase DB No. of ways incomer MCB / Isolator 4 No. of ways incomer ELCB / RCD - 4 No. of outgoings ways - 12

Supply and fixing of single box type 4'40W fluorescent fitting complete with copper choke and condensor with conduit pipe suspension from the ceiling with PVC unsheathed copper leads from terminals to the fitting with tube SD-89

Supply and fixing of 1200mm (48") sweep AC Ceiling fan complete with stepped electronic 300W regulator with 1 metre down rod with dan clamp with side plated and cross arm of size 450 mm (18") SD-106

Supply and fixing of ceiling fixture 250/300 mm complete with gallery etc clear glass opac/ Crystal suitable for 40W / 60W bulb with bulb SD-86

Supply and run 2x4 sq.mm (56/ 0.03) PVC insulated SC unsheathed copper conductor of 1100V grade insuitable heavy gauge MS Conduit pipe concealed in wall and ceiling with continous earth wire connection by 14 SWG TC wire and making good of the concealed portion with suitable colour

Supply and Fixing of TNEB meter board suitable for 32A single phase sevice connection with 32A fuse unit (500V) 32A neutral llink and earth link (1"x 1/8" copper flat) on TW plank of size 375mm x 300mm x 19mm with supporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit

Service Wire

Solid PVC door with frame Shutters using 19 Gauge 19mm MS square tubes for styles and outer frames. 15mm MS square tubes for top, lock and bottom rails. The steel tubes shall be covered with Smm thick solid PVC Sheets. Shutter using Smm thick solid PVC Sheets for panelling shall rigidly fixed in position including necessary furniture and fittings. The over all size of styles shall be SOmm x 30mm. The over all size of top rail, lock rail and bottom rail shall be 7Smm x 30mm. The over all size of frames shall be SOmm x 45mm with suitable rabate for housin: the shutter

UPVC Window Specification: Supplying and _ fixing UPVC (UnPlasticized Polyvinyl Chloride) Windows of casement type (open) from the profile the size of outer frame 60mm x S8mm and shutter profile are reinforcement with GI/imm 125GSM and 100% corrosion free, the profiles are multi chambered sections with wall thick of 2mm. The EPDM rubber (black colour) covered with over all the edges of frame and shutter the shutter will be provided with Espag multi power point locks and also it operates as handle. The corners and joints should be welded and cleaned. Radiations free pin headed plain or brown colour glass 4mm thick should be provided to the shutter and it should not allow leakage of water even at most ranging storms and should have Key lockable action, security protective hinges, strong locking systems and as per size for arresting noise and energy loss. The connecting mechanism between sash and outer frame that enables opening of the window. The window should be fixed to the wall with 100% packing with screws and silicon packing all round the frames. The window should be got approved from the Executive En-ineer before use on work

UPVC Ventilator Specification: Supplying and fixing UPVC (UnPlasticized Polyvinyl Chloride) Louvered Ventilators of from the profile the size of outer frame 60mm x 58mm and shutter profile size of 60 x 78mm both profiles are reinforced with GI/1mm 125GSM and 100% corrosion free, the profile are multi chambered sections with wall thick of 2mm. The EPDM rubber (black colour) covered with all over the edges of frame and shutter. The corners and joints should be welded and cleaned. Radiations pin headed glass 4mm thick should be provided in the louvers. The window should be fixed to the wall with 100% packing with screws and silicon packing all round the frames. The ventilator should be got approved from the Executive Engineer before use on work

Supply of PVC pipes and specials with approved brand etc., comelete

110 mm dai PVC Pipe

90 mm dia PVC Pipe

25 mm dia PVC Pipe

25 mm dia PVCCoupler

25 mm dia PVC Elbow

25 mm dia PVC Tee

25 mm x 20 mm PVC Reducer

SS Elbow Actio tap of size 15 mm

Earth work excavation in all soil with refilling the excavated earth etc, complete

Laying and joining of PVC Pipes and specials with approved brand etc., complete

European water closet (colour) with P or S trap with double flapped seat and seat cover with Brass Highes and 10 liter capacity PVC low level flusing tank with all internal fittings

Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for staircase near wet riser using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick will be provided with tubular supports made of 304L Grade Stainless Steel pipe of 25mm dia of 1.60mm thick welded to the railing. The supports will be grouted into the wall and provided with 93.00mm thick Stainless Steel circular base plate of 304 Grade. The rate shall included for grouting into concrete with necessary supporting arrangements the hand rail in floor polishing buffing, bonding, cutting, grinding, conveyance, welding charges, electrical charges, etc. complete