Municipal Administration And Water Supply Department Tender

Providing centering for sides and so fits of R.C.C. works such as Plinth beams that beams plain surface etc., complete including shuttering upto 3.30 M height using mild steel sheet of size 90 c.m x 60 c.m and 10 gauge stifer with M.S. angles of size 25 mm x 25 mm x 3mm laid over silver w.c.wood joints of size 10 c.m. x 6 c.m. spaced at about 90 c.m. c/c and supported by casurins props of 10 c.m. to 13 c.m. dia spaced 75 c.m. centre to centre includinng cost and conveyence of all meterial at site and labour charges for centering ect., complete complying with standard specification.

Supply of RCC precast slab 100mm thick in C.C. 1:2:4 mix using 20m baby jelly including water curing, moulding charges etc., complete.

Supplying and fabricating and placing in postion MS or RTS Bar reinforcement to all RCC Works as per the design given including cost of steel and bending wire also all floors.

Reinforced cement concrete 1:1.5:3mix(One cement One and Half sand and Three aggregates) mix for all reinfoced cement concrete works using 20 mm ISS gauge hard broken grainte machine crushed metal including cost and conveyance of all materials at site including all labour charges for concrete mixing, laying, watering, curing properly but excluding cost of steel and centering etc., complete complying with standard specifications.

Hoisting the Precast slab as per direction of departmental officers.,

BRICKWORK in cement mortar 1:5 (One cement and five sand) using second class table moulded chamber burnt bricks of size 23 x 11 cm x 7 cm for the following including curing etc., complete complying with standard specifications

Plastering with CM 1:5 (One cement and five sand) mix 12mm thick including finishing cost and conveyance of all materials to work site and all labour charges watering, curing and and all other incidental charges etc., complete complying with standard specifications

S/F of MS Truss with purlins including all labours and transports charges as per direction of departmental officers.,

Roofing with Colour Coated Galvolume sheet profile 0.47mm thick including necessary bolt, nut and bituminous washer etc. complete.

Supplying and fixin in position of solid PVC DOOR SHUTTERS using 19 gauge 19 mm MS sq tubes for styles and outer frames. 15mm MS square tubes for top,lock and bottom rails.The steel tubes shall be covered with 5mm thick solid PVC sheets.shutter usingetc.

Supplying and fixing in position of Alu. Anodised Partition with 62x38x2mm extruded box section at bottom vertical and horizontal members. The vertical member are spaced at 90 cm c/c and to horizontal members are spaced at 1.2M, 2.1M and 2.4M height the bottom panels should be covered with 12 mm thick PLB exterior grade and the top and middle panels should be fixed at 4mm thick glass thick glass with necessary glassing clips.rubber beading, etc., including necessary dismantling holes in RCC columns, beams masonry wherever necessary with power power drill ti the extent required and made good to the original conditions after fixing as directed by the departmental officers. All the Aluminium sections should be anodised to 1.5microns as per ISI specification 1868/1962

Supplying, fabricating and fixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections

Supply and fixing of mild steel door using all round "L" angle 25 X 25 X 6mm thick, cross bracing 20 X 6mm M.S.Flat with necessary locking arrangements including cost and conveyance etc.,

Supplying and fixing UPVC (Un-Plasticized Polyvinyl Chloride) Windows of casement type (open) from the profile the size of outer frame 60mm x 58mm and shutter profile are reinforcement with GI/1mm 125GSM and 100% corrosion free, the profiles are multi chambered sections with wall thick of 2mm. The EPDM rubber (black colour) covered with over all the edges of frame and shutter the shutter will be provided with Espag multi power point locks and also it operates as handle. The corners and joints should be welded and cleaned. Radiations free pin headed plain or brown colour glass 4mm thick should be provided to the hutter and it should not allow leakage of water even at most ranging storms and should have key lockable action, securityprotective hinges, strong locking systems and as per size for arresting noise and energy loss. The connecting mechanism between sash and outer frame that enables opening of the window. The window should be fixed to the wall with 100% packing with screws and silicon packing all round the frames. The window should be got approved from the Executive Engineer before use on work

Supplying and fixing in position best indian make white glazed earthnware WASHHAND BASIN of 560 * 406 mm with a pair of CI Brackets, 15 mm dia CP Pillar tap,32 mm GI Waste water pipe ,32 mm dia CP , Brass waste coupling,plug with chain,15 mm dia PVC connection ,15 mm GM wheel valve with ISI mark and necessary GI union and GI Elbow, including fixing wash hand basin in position with nwhite lead , clamps,teakwood plugs,screws,rubber washer etc., complete without any leakage complying with standard specifications

Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for staircase using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick at required locations to a height of 900mm from finished floor level welded to 38mm dia Stainless Steel pipe post of 1.00mm thick as vertical at 900mm centre with 2 Nos. of 25mm dia intermediate horizontal stainless steel pipe of 1.60mm thick in between. The vertical pipe has to be welded to the 100 X 100 X 6mm MS base plate encased in the base concrete. The rate is inclusive of the charges for cutting, bending, welding, grinding, polishing, conveyance, electrical charges, etc. complete

Painting TWO COATS over the the base coat with best and approved quality of EMULSION PAINT over the plaster surface including cost of paint and other materials, brushes,scaffolding charges etc,m, complete complying with standard specifications

CEMENT CONCRETE 1:2:4 (One Cement, two sand and four aggregate) using 20 mm gauge hard broken granite stone jelly including dewatering if found necessary and laid in layers of not more than 15 cm thick, complying with standard specification.

S/f of 600mmx600mm SFRC Man hole cover as per standard specifications etc.,

AIR CONDITIONER (AC) SUPPLY & INSTALLATION OF AIR-CONDITIONER WITH COPPER COIL.1.5 TR Split Type AC Unit (Electrical pg mo: 40)

Supply and installation of 5 KVA capacity Automatic Voltage Stabilizer with time delay relay (Electrical pg mo: 40)

Supply and laying of 5/8" and 3/8" copper pipe (Extra beyond 3 metres supplied with AC unit) (Electrical pg: 41)

Supply and fixing of MS stand for fixing outdoor unit (Electrical pg: 41)

Wiring with 2 x 1.5 sq.mm. (22 / 0.3) PVC insulated SC unsheathed copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe concealed in wall and ceiling with MS accessories with MS switch box in flush with wall with 5A FT switch with 3mm thick hylem sheet cover MS switch box with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion for concealed light point / fan point (for electronic regulator)

Wiring with 2 x 1.5 sq.mm. (22 / 0.3 ) PVC insulated single core unsheathed copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe on wall and ceiling with MS accessories in flush with wall with 150mm x 100mm x 75mm MS switch box with 3mm thick hylum sheet cover for 5A 3pin non interlocking CS plug with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealed plug point

Wiring with 2 x 4 sq.mm. (56 / 0.3) PVC insulated SC unsheathed copper conductor cable of 1100V grade in suitable heavy gauge MS conduit pipe concealed in wall and ceiling with MS accessories in flush with wall with150mm x 100mm x 75mm MS switch box concealed type with3mm thick hylum sheet cover for 15A 3 pin flush type non interlocking CS plug with continuous earth wire connection of 14 SWG TC wire and rnaking good of the concealed portion for concealed power plug point

Supply and fixing of WT bulk head fitting with guard (Phillips/Bajaj/Crompton/K.Lite) Suitable for incandescent lamp with 100W Bulb(SD 84)

Supply and run of 2 of 6 Sq.mm (84/0.3) PVC insulated SC Unsheathed CU.Condutor of 1100V on 7/20 GI bearer Wire for service connection Mains.

Supply and Laying of 4 x 16 sq.mm. PVC armoured LTUG cable in suitable size HDPE pipe in a trench to be excavated

AC Ceiling Fan complete 1200mm (48") Sweep with 300mm Down Rod (without Regulator) (Higher End)

4' 18W Crystal Glass LED Tube Light Fitting as per the Direction of the Departmental officers etc., complete.

Providing Glass pieces over wall with C.M. 1:5 mix plastering 20mm thick as per the Direction of the Departmental officers etc., complete.

supplying and delivery of pipes and specials including cost of materials to site and all other labour charges.etc

63mm pvc pipe

110mm pvc pipe

110mnm PVC Elbow

63mm pvc elbow

1/2" Push type tap

solvent cement

shellock bottle

Painting with enamel paint two coats for New iron work of approved colour etc complete - For Iron works

Conveying the excavated earth from the site to the distance of 15kms out side of the city limit including all initial lead, lift, loading and unloading with transportation charges etc complete as per the direction of departmental officers.