Municipal Administration And Water Supply Department Tender

Providing Rain Water Harvesting arrangements in corporation building by inserting of 150mm PVC slotted casing pipe, including earth work excavation for 900mm precost cement Ring 5nos filling with One, three, Fifth Rings are 40mm metal and Two and Fourth Rings are Sand providing necessary pipe line arrangements eith std specification etc, complete (19-20,page-87)

Providing and fixing PVC Rain Water Down fall pipe of the following dia with necessary T.W Clamps Plugs,Shoes,Bends,other clamps,screws,nails rtc complete complying with standard specification and as directed by the departmental officers.The rate is inclusive of cost of removable iron gratings of appropriate size.The size of teak wood plugs used is 150x25mm in front & 200x75mm in rear(wall side) with a depth of 110mm.The pipe is to be fixed by means of "U" clamps at the centre of pipes to be fixed 110mm dia PVC Pipe(4kg/Sqcm)

UPVC Pipes and specials 1 1/4"- UPVC Pipe Line Work

3/4"- UPVC Pipe Line Work

1 1/4"- Elbow

3/4"- GI Pipe

3/4"- GI Gate Value

5"- PVC Pipe Line work

4"- PVC Pipe Line Work

4"-5"- PVC Reduser

3"-4"- PVC Reduser

5"- PVC Tee

4"- PVC Tee

5"- PVC Elbow

4"- PVC Elbow

Providing and fixing false ceiling at all height including providing and fixing of frame edges of the board with recommended jointing compound , jointing tapes , finishing with jointing compound in 3 layers covering upto 150 mm on both sides of joint and two coats of primer suitable for board, all as per manufacturer's specification and also including the cost of making openings for light fittings, grills, diffusers, cutouts made with frame of perimeter channels suitably fixed, all complete as per drawings, specification and direction of the Engineer in Charge but excluding the cost of painting work made of special sections, power pressed from M.S. sheets and galvanized with zinc coating of 120 gms/sqm (both side inclusive) as per IS : 277 and consisting of angle cleats of size 25 mm wide x 1.6 mm thick with flanges of 27 mm and 37mm, at 1200 mm centre to centre, one flange fixed to the ceiling with dash fastener 12.5 mm dia x 50mm long with 6mm dia bolts, other flange of cleat fixed to the angle hangers of 25x10x0.50 mm of required length with nuts & bolts of required size and other end of angle hanger fixed with intermediate G.I. channels 45x15x0.9 mm running at the spacing of 1200 mm centre to centre, to which the ceiling section 0.5 mm thick bottom wedge of 80 mm with tapered flanges of 26 mm each having lips of 10.5 mm, at 450mm centre to centre, shall be fixed in a direction perpendicular to G.I. intermediate channel with connecting clips made out of 2.64 mm dia x 230 mm long G.I. wire at every junction, including fixing perimeter channels 0.5 mm thick 27 mm high having flanges of 20 mm and 30 mm long, the perimeter of ceiling fixed to wall/partition with the help of rawl plugs at 450 mm centre, with 25mm long dry wall screws @ 230 mm interval, including fixing of gypsum board to ceiling section and perimeter channel with the help of dry wall screws of size 3.5 x 25 mm at 230 mm c/c, including jointing and finishing 51

Supply and Fixing of 20Amps Dpplug and socket in sheet enclosure with 32A DP MCB in flush with wall earth Connection (For AC Plug) (Legrand(MDS)/Hager(L&T) make) etc., all complete in all respects complying with relevant standard specification and as directed by the departmental officer. (SD 140)

Supply and run of 3.5core 120sqmm PVC armoured Aluminium cable of 1100V grade with ISI mark , etc., all complete complying with relevant standard specification and as directed by the Departmental Officers. (The quality and brand of UG cable should be got approved by Executive Engineer before use).ED Page No 23 part E-o-j)

Wiring with 4 x 4sqmm copper P.V.C. insulated unsheathed 1.1 KV grade copper cable with ISI Mark conforming to IS:694/1990 and with continuous earth by means of 1x4 sqmm copper PVC insulated unsheathed cost of all materials, specials, etc., complete complying with relevant standard specification and as directed by the departmental (Elect data 22-23, pag-38)

Wiring with 4 x 16sqmm copper P.V.C. insulated unsheathed 1.1 KV grade copper cable with ISI Mark conforming to IS:694/1990 and with continuous earth by means of 1x4 sqmm copper PVC insulated unsheathed cost of all materials, specials, etc., complete complying with relevant standard specification and as directed by the departmental (Elect data 22-23, pag-38)

Wiring with 2x4sqmm(56/0.5) PVC insulated SC unsheathed copper conductro of 1100 V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories in flush with wall with 150mm x 100mm x 113mm TW switch box with 3mm thick hylum sheet cover for 15A 3 pin non inter locking wall spcket with 15A Flush type switch with continuous earth wire connection of 14 SWG TC wire and make good of concealed portion with suitable colour for concealed PVC plug point etc., complete complying with relevant standard specification and as directed by the departmental officer.(SD 40)

Run off mains with 2 wire of 2.5 Sqm. Copper PVC conduit 19 mm insulated un sheathed single core 1.1.KV grade cable with continuous earth etc. all complete in all respects complying with relevant standard specification and as directed by the departmental officer (Elect data 22-23, pag-37)

Run off mains with 2 wire of 6.Sqm. Copper PVC conduit 25 mm dia insulated un sheathed single core 1.1. K.V. grade cable with continuous earth 1 wire of 1.5 sqmm etc. all complete in all respects complying with relevant standard specification and as directed by the departmental officer. (Elect data 22-23, SD-77)

Supplying and fixing of 100mm x 15 Cable tray used for laying of cable the rate including cost of tray and labour etc 500mm width tray

Run off 3.5 core 70mm. PVC armoured aluminium cable of 1.1.KV grade cable with continuous earth etc. all complete in all respects complying with relevant standard specification and as directed by the departmental officer (SOR data 22-23, pag-120)

Supplying delivery and erection of IS mark mounted 36W LED light of 600 x 600 size luminian in white powder coated etc complete (Data-5)

Supplying and laying 25mm x 3mm copper plate for earth link from condensor to power contrile room the rate including cost of plat etc. complete (Data-5)

Supply and fixing 40w 4 Feet Tube light fitting with bulb on wallall complete complying with relevant standard specifications & as directed by the departmental officers.(The Tube light fitting and bulb should be of reputed Brand and it should be got approved by the EE before fixing).

Supply and fixing nominal bore quartized bulb type Sprinkler bulb 68 deg C fast response pendent typeincluding GI coller for each sprinkler bulb, mounted in MS Pipe line using suitable size MS threaded coupling, thread, shellac etc., as per standard methods and including conveyance, all including all charges, necessary scaffolding and re-doing the dismantled portion to its original condition wherever found necessary etc., as per standard specificationand as derected by the departmental officers. make omex/kartar/life gaurd/ safe gaurd/ equivalent.

Supply erection testing and commissioning of cast iron body and gun metal or stainless steel Internal Sluice Valve of size control one way flow of water to be installed pump room at delivery line and near overhead tank as per IS 5312 including conveyance and all incidental charges etc complete complying with standard specifications and as directed by the departmental officers 150mm Dia

100 mm Dia

80mm Dia

Supply, installation of fire fighting application 180 degree swinging type, hose reel drum with 20mm dia braided thermoplastic hose of 30 mtrs long, so as to extend to necessary distance by self rolling spindle wheel including necessary 20 mm dia ball valve and open and close spary nozzle, warm clip, etc., as per the standared pattern of any reputed make at every floor nearer to hydrant valve, including conveyance, all incidential charges, necessary scaffolding and redoing the dismantled portion to its original condition wherever found necessary etc., as per standard specificationand as derected by the departmental officers. make omex/kartar/life gaurd/ safe gaurd/ equivalent.-

Providing earthing station using pipe electrode as per IS 3043 using 40mm dia B Glass G.I pipe 2.5 meters. 20mm dia B class G.I. pipe 1 metre 40 x 20mm G.I. Reducer 1 no.1 set of funel G.I. nuts, bolts, washers and checknuts, 40Kg charcoal, 2nos.of C.I.bend 15mm dia 4 Nos.of 15mm dia G.I. coupling and 10Kg salt including necessary earth work excavation (i.e. by augering 30cm dia to a depth of 3.5 metres and laying the salt and charcoal in layer by layer around G.I.pipe brick work in Cement mortar and plastering etc . Including cost of all materials and labour in accordance with IS 3043. etc. all complete in all respects complying with relevant standard specification and as directed by the departmental officer.

Supply erection testing and commissioning of cast iron body and gun metal or stainless steel Internal Non return Valve of 150mm DIa of size control one way flow of water to be installed pump room at delivery line and near overhead tank as per IS 5312 including conveyance and all incidental charges etc complete complying with standard specifications and as directed by the departmental officers

Uprooting root vegetation and weeds by digging the area to a depth of 60CM removing all weeds and other growth with roots by forking repeatedly , breaking clods, rough dressing , flooding with water uprooting fresh growth after 10 to 15 days and then fine dressing for planting new grass ,including disposal of all rubbish with all leads and lifts.

Supplying, spreading and mixing red earth, sand and farm yard manure mixer with required base of chemical for control of pest and disease like Neem cake and carbo fureden and fertilizers for root regulator like DAP, Urea and superphosphate and for mind the mix cost of red earth sand, fertilizers and labour charges etc., complete directed by the Departmental Officers

Providing and Plantening of Korean grass as directed by the departmental officers work involved mixing of red earth and sand filling the same to required level, mixing with manure. Rate includes cost of korean grass red earth, sand manure and including labour charges etc., complete

Supplying making the lawn with peal grasstrapping including forking the ground to dressing with sludge manure of fertilities making with the same with forked soil watering weeding and maintenance etc,

Supplying and planting FOXTIAL palm plant directed by the engg in charge including digging holes in ordinary soils and refilling the same with manure, floating with water and dressing removal of rubbies, surplus earth if any with all lead and lift also maintenance of plant for a period of 30 days from the date of planting work.

Supplying UGINEA plant directed by the engg in charge etc complete

Supplying NANDIYAR VATTAM MINIAT plant directed by the engg in charge etc complete

Supplying PENDANCE plant directed by the engg in charge etc complete

Supplying BALL ALERIA plant directed by the engg in charge etc complete

Supplying TERMINIYA plant directed by the engg in charge etc complete

Supplying ARALI Plord plant directed by the engg in charge etc complete

Supplying FINGER Palm plant directed by the engg in charge etc complete

Supplying TECH HYBRID plant directed by the engg in charge etc complete

Manufacturing supplying and fixing Name board of size 16.75m x 1.50m (55' x 5') and 12.80m x 1.50m ( 42' x 5') using L angle and frames including cost of flex board L angle, welding charges etc complete

Supplying and fixing MS materials gate of size 7.50m x 1.83m using MS squre pipe with frame using 2'' x 1'' MS squre pipe and cross bars and MS sheet of 3mm tk encloser including cost and conveyance etc

Repairing the existing damaged Grill Gate of size 5.70 x 2.20m the rate shall including removing squre rods and replacing the same size rod and welding the squrw rod and refixing charges of grill gate with painting etc

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete complying with standard specifications and as directed by the departmental officers.

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12etc, complete complying with standard specification and as directed by the departmental officers.

Supplying and fixing SFRC Manhole Cover etc

Add GST 18%